@@ -213,6 +213,13 @@ config GPIO_GE_FPGA
and write pin state) for GPIO implemented in a number of GE single
board computers.
+config GPIO_MOXART
+ bool "MOXART GPIO support"
+ depends on ARCH_MOXART || COMPILE_TEST
+ select GPIO_GENERIC
+ help
+ Select this option to enable GPIO driver for
+ MOXA ART SoC devices.
endif
config GPIO_GRGPIO
@@ -289,14 +296,6 @@ config GPIO_MM_LANTIQ
(EBU) found on Lantiq SoCs. The gpios are output only as they are
created by attaching a 16bit latch to the bus.
-config GPIO_MOXART
- bool "MOXART GPIO support"
- depends on ARCH_MOXART || COMPILE_TEST
- select GPIO_GENERIC
- help
- Select this option to enable GPIO driver for
- MOXA ART SoC devices.
-
config GPIO_MPC5200
def_bool y
depends on PPC_MPC52xx
@@ -16,6 +16,7 @@ obj-$(CONFIG_GPIO_GENERIC) += gpio-generic.o
gpio-generic-$(CONFIG_GPIO_GENERIC) += gpio-mmio.o
gpio-generic-$(CONFIG_GPIO_CLPS711X) += gpio-clps711x.o
gpio-generic-$(CONFIG_GPIO_GE_FPGA) += gpio-ge.o
+gpio-generic-$(CONFIG_GPIO_MOXART) += gpio-moxart.o
obj-$(CONFIG_GPIO_104_DIO_48E) += gpio-104-dio-48e.o
obj-$(CONFIG_GPIO_104_IDIO_16) += gpio-104-idio-16.o
@@ -68,7 +69,6 @@ obj-$(CONFIG_GPIO_MC9S08DZ60) += gpio-mc9s08dz60.o
obj-$(CONFIG_GPIO_MCP23S08) += gpio-mcp23s08.o
obj-$(CONFIG_GPIO_ML_IOH) += gpio-ml-ioh.o
obj-$(CONFIG_GPIO_MM_LANTIQ) += gpio-mm-lantiq.o
-obj-$(CONFIG_GPIO_MOXART) += gpio-moxart.o
obj-$(CONFIG_GPIO_MPC5200) += gpio-mpc5200.o
obj-$(CONFIG_GPIO_MPC8XXX) += gpio-mpc8xxx.o
obj-$(CONFIG_GPIO_MSIC) += gpio-msic.o
@@ -30,6 +30,18 @@ int ge_parse_dt(struct platform_device *pdev,
#define GPIO_GE_FPGA_COMPATIBLE
#endif /* CONFIG_CONFIG_GPIO_GE_FPGA */
+#if IS_ENABLED(CONFIG_GPIO_MOXART)
+int moxart_parse_dt(struct platform_device *pdev,
+ struct bgpio_pdata *pdata,
+ unsigned long *flags);
+
+#define GPIO_MOXART_COMPATIBLE \
+ ADD("moxa,moxart-gpio", moxart_parse_dt),
+
+#else
+#define GPIO_MOXART_COMPATIBLE
+#endif /* CONFIG_GPIO_MOXART */
+
#undef ADD
static inline void set_resource_address(struct resource *res,
@@ -610,6 +610,7 @@ static const struct of_device_id bgpio_of_match[] = {
ADD("linux,gpio-mmio", bgpio_basic_mmio_parse_dt),
GPIO_CLPS711X_COMPATIBLE
GPIO_GE_FPGA_COMPATIBLE
+ GPIO_MOXART_COMPATIBLE
{ }
};
@@ -10,75 +10,36 @@
* warranty of any kind, whether express or implied.
*/
+#include <linux/kernel.h>
+#include <linux/module.h>
#include <linux/err.h>
-#include <linux/init.h>
-#include <linux/irq.h>
-#include <linux/io.h>
-#include <linux/platform_device.h>
-#include <linux/of_address.h>
-#include <linux/of_gpio.h>
-#include <linux/pinctrl/consumer.h>
-#include <linux/delay.h>
-#include <linux/timer.h>
-#include <linux/bitops.h>
+#include <linux/ioport.h>
#include <linux/gpio/driver.h>
+#include <linux/platform_device.h>
+#include "gpio-mmio-compat.h"
#define GPIO_DATA_OUT 0x00
#define GPIO_DATA_IN 0x04
#define GPIO_PIN_DIRECTION 0x08
-static int moxart_gpio_probe(struct platform_device *pdev)
+int moxart_parse_dt(struct platform_device *pdev,
+ struct bgpio_pdata *pdata,
+ unsigned long *flags)
{
- struct device *dev = &pdev->dev;
struct resource *res;
- struct gpio_chip *gc;
- void __iomem *base;
- int ret;
-
- gc = devm_kzalloc(dev, sizeof(*gc), GFP_KERNEL);
- if (!gc)
- return -ENOMEM;
+ struct resource nres[] = {
+ DEFINE_RES_MEM_NAMED(0, 1, "dat"),
+ DEFINE_RES_MEM_NAMED(0, 1, "set"),
+ DEFINE_RES_MEM_NAMED(0, 1, "dirout"),
+ };
res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
- base = devm_ioremap_resource(dev, res);
- if (IS_ERR(base))
- return PTR_ERR(base);
-
- ret = bgpio_init(gc, dev, 4, base + GPIO_DATA_IN,
- base + GPIO_DATA_OUT, NULL,
- base + GPIO_PIN_DIRECTION, NULL,
- BGPIOF_READ_OUTPUT_REG_SET);
- if (ret) {
- dev_err(&pdev->dev, "bgpio_init failed\n");
- return ret;
- }
-
- gc->label = "moxart-gpio";
- gc->request = gpiochip_generic_request;
- gc->free = gpiochip_generic_free;
- gc->base = 0;
- gc->owner = THIS_MODULE;
-
- ret = devm_gpiochip_add_data(dev, gc, NULL);
- if (ret) {
- dev_err(dev, "%s: gpiochip_add failed\n",
- dev->of_node->full_name);
- return ret;
- }
-
- return ret;
+ if (!res || resource_size(res) != 12)
+ return -EINVAL;
+
+ *flags |= BGPIOF_READ_OUTPUT_REG_SET;
+ set_resource_address(&nres[0], res->start + GPIO_DATA_IN, 0x4);
+ set_resource_address(&nres[1], res->start + GPIO_DATA_OUT, 0x4);
+ set_resource_address(&nres[2], res->start + GPIO_PIN_DIRECTION, 0x4);
+ return platform_device_add_resources(pdev, nres, ARRAY_SIZE(nres));
}
-
-static const struct of_device_id moxart_gpio_match[] = {
- { .compatible = "moxa,moxart-gpio" },
- { }
-};
-
-static struct platform_driver moxart_gpio_driver = {
- .driver = {
- .name = "moxart-gpio",
- .of_match_table = moxart_gpio_match,
- },
- .probe = moxart_gpio_probe,
-};
-builtin_platform_driver(moxart_gpio_driver);
This patch integrates the GPIO driver for the MOXA ART SoC into the gpio-mmio framework. Signed-off-by: Christian Lamparter <chunkeey@googlemail.com> --- drivers/gpio/Kconfig | 15 ++++---- drivers/gpio/Makefile | 2 +- drivers/gpio/gpio-mmio-compat.h | 12 ++++++ drivers/gpio/gpio-mmio.c | 1 + drivers/gpio/gpio-moxart.c | 81 +++++++++++------------------------------ 5 files changed, 42 insertions(+), 69 deletions(-)