@@ -139,10 +139,38 @@
clock-latency-ns = <150000>;
opp-suspend;
};
};
+ ddrc_opp_table: ddrc-opp-table {
+ compatible = "operating-points-v2";
+
+ opp-25M {
+ opp-hz = /bits/ 64 <25000000>;
+ };
+ opp-100M {
+ opp-hz = /bits/ 64 <100000000>;
+ };
+ opp-750M {
+ opp-hz = /bits/ 64 <750000000>;
+ };
+ };
+
+ noc_opp_table: noc-opp-table {
+ compatible = "operating-points-v2";
+
+ opp-150M {
+ opp-hz = /bits/ 64 <150000000>;
+ };
+ opp-375M {
+ opp-hz = /bits/ 64 <375000000>;
+ };
+ opp-750M {
+ opp-hz = /bits/ 64 <750000000>;
+ };
+ };
+
memory@40000000 {
device_type = "memory";
reg = <0x0 0x40000000 0 0x80000000>;
};
@@ -773,10 +801,18 @@
status = "disabled";
};
};
+ noc: noc@32700000 {
+ compatible = "fsl,imx8mm-noc", "fsl,imx8m-noc";
+ reg = <0x32700000 0x100000>;
+ clocks = <&clk IMX8MM_CLK_NOC>;
+ devfreq = <&ddrc>;
+ operating-points-v2 = <&noc_opp_table>;
+ };
+
aips4: bus@32c00000 {
compatible = "fsl,aips-bus", "simple-bus";
#address-cells = <1>;
#size-cells = <1>;
ranges = <0x32c00000 0x32c00000 0x400000>;
@@ -857,11 +893,26 @@
#interrupt-cells = <3>;
interrupt-controller;
interrupts = <GIC_PPI 9 IRQ_TYPE_LEVEL_HIGH>;
};
- ddr-pmu@3d800000 {
+ ddrc: dram-controller@3d400000 {
+ compatible = "fsl,imx8mm-ddrc", "fsl,imx8m-ddrc";
+ reg = <0x3d400000 0x400000>;
+ clock-names = "dram_core",
+ "dram_pll",
+ "dram_alt",
+ "dram_apb";
+ clocks = <&clk IMX8MM_CLK_DRAM_CORE>,
+ <&clk IMX8MM_DRAM_PLL>,
+ <&clk IMX8MM_CLK_DRAM_ALT>,
+ <&clk IMX8MM_CLK_DRAM_APB>;
+ devfreq-events = <&ddr_pmu>;
+ operating-points-v2 = <&ddrc_opp_table>;
+ };
+
+ ddr_pmu: ddr-pmu@3d800000 {
compatible = "fsl,imx8mm-ddr-pmu", "fsl,imx8m-ddr-pmu";
reg = <0x3d800000 0x400000>;
interrupt-parent = <&gic>;
interrupts = <GIC_SPI 98 IRQ_TYPE_LEVEL_HIGH>;
};
Add initial support for bus scaling on imx8m, starting with noc and ddrc because they're the biggest power hogs. Add a devfreq-event link to the PMU in order to support on-demand scaling of ddrc based on measured dram bandwith usage. Make ddrc a parent of the NOC because all traffic to ddrc goes through Support for proactive scaling via interconnect and support for scaling additional NICs will come later. The high-performance bus masters which need that (display, vpu, gpu) are not yet enabled in upstream anyway. Signed-off-by: Leonard Crestez <leonard.crestez@nxp.com> --- arch/arm64/boot/dts/freescale/imx8mm.dtsi | 53 ++++++++++++++++++++++- 1 file changed, 52 insertions(+), 1 deletion(-)