diff mbox series

[v2,3/8] dt-bindings: mfd: axp20x: add support for regulator-ramp-delay for AXP209

Message ID 78eafc64831c50005fe5d186c174440d48a865e3.1544512919.git-series.plaes@plaes.org (mailing list archive)
State New, archived
Headers show
Series regulator: axp20x: Stop AXP209 from crashing when enabling LDO3 | expand

Commit Message

Priit Laes Dec. 11, 2018, 3:17 p.m. UTC 
From: Olliver Schinagl <oliver@schinagl.nl>

The AXP209 supports ramping up voltages on several regulators such as
DCDC2 and LDO3, therefore we can use the standard 'regulator-ramp-delay'
property for those 2 regulators.

Note that the voltage ramp only works when the regulator is already
enabled. E.g. when going from say 0.7 V to 3.6 V.

When turning on the regulator, no voltage ramp is performed in hardware.

What this means, is that if the bootloader brings up the voltage at 0.7 V,
the ramp delay property is properly applied. If however, the bootloader
leaves the power off, no ramp delay is applied when the power is
enabled by the regulator framework.

Signed-off-by: Olliver Schinagl <oliver@schinagl.nl>
Signed-off-by: Priit Laes <plaes@plaes.org>
Acked-for-MFD-by: Lee Jones <lee.jones@linaro.org>
---
 Documentation/devicetree/bindings/mfd/axp20x.txt | 6 ++++++
 1 file changed, 6 insertions(+)
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/mfd/axp20x.txt b/Documentation/devicetree/bindings/mfd/axp20x.txt
index 188f037..c626605 100644
--- a/Documentation/devicetree/bindings/mfd/axp20x.txt
+++ b/Documentation/devicetree/bindings/mfd/axp20x.txt
@@ -32,6 +32,12 @@  Required properties:
 - interrupt-controller: The PMIC has its own internal IRQs
 - #interrupt-cells: Should be set to 1
 
+Supported common regulator properties, see ../regulator/regulator.txt for
+more information:
+- regulator-ramp-delay: sets the ramp up delay in uV/us
+			AXP20x/DCDC2: 1600, 800
+			AXP20x/LDO3:  1600, 800
+
 Optional properties:
 - x-powers,dcdc-freq: defines the work frequency of DC-DC in KHz
 		      AXP152/20X: range:  750-1875, Default: 1.5 MHz