@@ -152,13 +152,6 @@ config GPIO_BRCMSTB
help
Say yes here to enable GPIO support for Broadcom STB (BCM7XXX) SoCs.
-config GPIO_CLPS711X
- tristate "CLPS711X GPIO support"
- depends on ARCH_CLPS711X || COMPILE_TEST
- select GPIO_GENERIC
- help
- Say yes here to support GPIO on CLPS711X SoCs.
-
config GPIO_DAVINCI
bool "TI Davinci/Keystone GPIO support"
default y if ARCH_DAVINCI
@@ -213,6 +206,13 @@ config GPIO_GENERIC_PLATFORM
Say yes here to support basic platform_device memory-mapped GPIO controllers.
if GPIO_GENERIC_PLATFORM
+config GPIO_CLPS711X
+ bool "CLPS711X GPIO support"
+ depends on ARCH_CLPS711X || COMPILE_TEST
+ select GPIO_GENERIC
+ help
+ Say yes here to support GPIO on CLPS711X SoCs.
+
endif
config GPIO_GRGPIO
@@ -14,6 +14,7 @@ obj-$(CONFIG_GPIO_GENERIC) += gpio-generic.o
# directly supported by gpio-generic
gpio-generic-$(CONFIG_GPIO_GENERIC) += gpio-mmio.o
+gpio-generic-$(CONFIG_GPIO_CLPS711X) += gpio-clps711x.o
obj-$(CONFIG_GPIO_104_DIO_48E) += gpio-104-dio-48e.o
obj-$(CONFIG_GPIO_104_IDIO_16) += gpio-104-idio-16.o
@@ -31,7 +32,6 @@ obj-$(CONFIG_GPIO_ATH79) += gpio-ath79.o
obj-$(CONFIG_GPIO_BCM_KONA) += gpio-bcm-kona.o
obj-$(CONFIG_GPIO_BRCMSTB) += gpio-brcmstb.o
obj-$(CONFIG_GPIO_BT8XX) += gpio-bt8xx.o
-obj-$(CONFIG_GPIO_CLPS711X) += gpio-clps711x.o
obj-$(CONFIG_GPIO_CS5535) += gpio-cs5535.o
obj-$(CONFIG_GPIO_CRYSTAL_COVE) += gpio-crystalcove.o
obj-$(CONFIG_GPIO_DA9052) += gpio-da9052.o
@@ -9,83 +9,55 @@
* (at your option) any later version.
*/
-#include <linux/err.h>
+#include <linux/kernel.h>
#include <linux/module.h>
+#include <linux/err.h>
+#include <linux/ioport.h>
#include <linux/gpio/driver.h>
#include <linux/platform_device.h>
+#include "gpio-mmio-compat.h"
-static int clps711x_gpio_probe(struct platform_device *pdev)
+int cirrus_clps711x_parse_dt(struct platform_device *pdev,
+ struct bgpio_pdata *pdata,
+ unsigned long *flags)
{
struct device_node *np = pdev->dev.of_node;
- void __iomem *dat, *dir;
- struct gpio_chip *gc;
+ int id = np ? of_alias_get_id(np, "gpio") : pdev->id;
struct resource *res;
- int err, id = np ? of_alias_get_id(np, "gpio") : pdev->id;
+ struct resource nres[] = {
+ DEFINE_RES_MEM_NAMED(0, 1, "dat"),
+ DEFINE_RES_MEM_NAMED(0, 1, "dirout"),
+ };
if ((id < 0) || (id > 4))
return -ENODEV;
- gc = devm_kzalloc(&pdev->dev, sizeof(*gc), GFP_KERNEL);
- if (!gc)
- return -ENOMEM;
+ if (id == 4) {
+ /* PORTE is 3 lines only */
+ pdata->ngpio = 3;
+ }
+
+ pdata->base = id * 8;
res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
- dat = devm_ioremap_resource(&pdev->dev, res);
- if (IS_ERR(dat))
- return PTR_ERR(dat);
+ if (!res || resource_size(res) != 0x1)
+ return -EINVAL;
+ set_resource_address(&nres[0], res->start, 0x1);
res = platform_get_resource(pdev, IORESOURCE_MEM, 1);
- dir = devm_ioremap_resource(&pdev->dev, res);
- if (IS_ERR(dir))
- return PTR_ERR(dir);
+ if (!res || resource_size(res) != 0x1)
+ return -EINVAL;
+ set_resource_address(&nres[1], res->start, 0x1);
- switch (id) {
- case 3:
+ if (id == 3) {
/* PORTD is inverted logic for direction register */
- err = bgpio_init(gc, &pdev->dev, 1, dat, NULL, NULL,
- NULL, dir, 0);
- break;
- default:
- err = bgpio_init(gc, &pdev->dev, 1, dat, NULL, NULL,
- dir, NULL, 0);
- break;
- }
-
- if (err)
- return err;
-
- switch (id) {
- case 4:
- /* PORTE is 3 lines only */
- gc->ngpio = 3;
- break;
- default:
- break;
+ nres[1].name = "dirin";
}
- gc->base = id * 8;
- gc->owner = THIS_MODULE;
- platform_set_drvdata(pdev, gc);
-
- return devm_gpiochip_add_data(&pdev->dev, gc, NULL);
+ return platform_device_add_resources(pdev, nres, ARRAY_SIZE(nres));
}
-static const struct of_device_id __maybe_unused clps711x_gpio_ids[] = {
- { .compatible = "cirrus,clps711x-gpio" },
- { }
-};
-MODULE_DEVICE_TABLE(of, clps711x_gpio_ids);
-
-static struct platform_driver clps711x_gpio_driver = {
- .driver = {
- .name = "clps711x-gpio",
- .of_match_table = of_match_ptr(clps711x_gpio_ids),
- },
- .probe = clps711x_gpio_probe,
-};
-module_platform_driver(clps711x_gpio_driver);
-
-MODULE_LICENSE("GPL");
MODULE_AUTHOR("Alexander Shiyan <shc_work@mail.ru>");
MODULE_DESCRIPTION("CLPS711X GPIO driver");
MODULE_ALIAS("platform:clps711x-gpio");
+MODULE_ALIAS("clps711x-gpio");
@@ -5,6 +5,17 @@
#define ADD(_name, _func) { .compatible = _name, .data = _func }
+#if IS_ENABLED(CONFIG_GPIO_CLPS711X)
+int cirrus_clps711x_parse_dt(struct platform_device *pdev,
+ struct bgpio_pdata *pdata,
+ unsigned long *flags);
+
+#define GPIO_CLPS711X_COMPATIBLE \
+ ADD("cirrus,clps711x-gpio", cirrus_clps711x_parse_dt),
+#else
+#define GPIO_CLPS711X_COMPATIBLE
+#endif /* CONFIG_GPIO_CLPS711X */
+
#undef ADD
static inline void set_resource_address(struct resource *res,
@@ -608,6 +608,7 @@ static int bgpio_basic_mmio_parse_dt(struct platform_device *pdev,
static const struct of_device_id bgpio_of_match[] = {
ADD("linux,gpio-mmio", bgpio_basic_mmio_parse_dt),
+ GPIO_CLPS711X_COMPATIBLE
{ }
};
This patch integrates the Cirrus' clps711x driver into the gpio-mmio framework. Signed-off-by: Christian Lamparter <chunkeey@googlemail.com> --- drivers/gpio/Kconfig | 14 +++---- drivers/gpio/Makefile | 2 +- drivers/gpio/gpio-clps711x.c | 84 ++++++++++++++--------------------------- drivers/gpio/gpio-mmio-compat.h | 11 ++++++ drivers/gpio/gpio-mmio.c | 1 + 5 files changed, 48 insertions(+), 64 deletions(-)