@@ -90,10 +90,20 @@ config ARM_EXYNOS_BUS_DEVFREQ
Each memory bus group could contain many memoby bus block. It reads
PPMU counters of memory controllers by using DEVFREQ-event device
and adjusts the operating frequencies and voltages with OPP support.
This does not yet operate with optimal voltages.
+config ARM_IMX_DEVFREQ
+ tristate "i.MX DEVFREQ Driver"
+ depends on ARCH_MXC || COMPILE_TEST
+ select DEVFREQ_GOV_USERSPACE
+ select PM_OPP
+ help
+ This adds the DEVFREQ driver for the i.MX family of SoCs.
+ It allows adjusting frequencies for DDRC (DDR Controller) and various
+ NICs and NOCs which form the SOC interconnect fabric
+
config ARM_TEGRA_DEVFREQ
tristate "NVIDIA Tegra30/114/124/210 DEVFREQ Driver"
depends on ARCH_TEGRA_3x_SOC || ARCH_TEGRA_114_SOC || \
ARCH_TEGRA_132_SOC || ARCH_TEGRA_124_SOC || \
ARCH_TEGRA_210_SOC || \
@@ -7,10 +7,11 @@ obj-$(CONFIG_DEVFREQ_GOV_POWERSAVE) += governor_powersave.o
obj-$(CONFIG_DEVFREQ_GOV_USERSPACE) += governor_userspace.o
obj-$(CONFIG_DEVFREQ_GOV_PASSIVE) += governor_passive.o
# DEVFREQ Drivers
obj-$(CONFIG_ARM_EXYNOS_BUS_DEVFREQ) += exynos-bus.o
+obj-$(CONFIG_ARM_IMX_DEVFREQ) += imx-devfreq.o
obj-$(CONFIG_ARM_RK3399_DMC_DEVFREQ) += rk3399_dmc.o
obj-$(CONFIG_ARM_TEGRA_DEVFREQ) += tegra30-devfreq.o
obj-$(CONFIG_ARM_TEGRA20_DEVFREQ) += tegra20-devfreq.o
# DEVFREQ Event Drivers
new file mode 100644
@@ -0,0 +1,143 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Copyright (c) 2019 NXP
+ */
+
+#include <linux/clk.h>
+#include <linux/devfreq.h>
+#include <linux/devfreq-event.h>
+#include <linux/device.h>
+#include <linux/module.h>
+#include <linux/of_device.h>
+#include <linux/pm_opp.h>
+#include <linux/platform_device.h>
+#include <linux/slab.h>
+
+struct imx_devfreq {
+ struct devfreq_dev_profile profile;
+ struct devfreq *devfreq;
+ struct clk *clk;
+};
+
+static int imx_devfreq_target(struct device *dev, unsigned long *freq, u32 flags)
+{
+ struct imx_devfreq *priv = dev_get_drvdata(dev);
+ struct dev_pm_opp *new_opp;
+ unsigned long new_freq;
+ int ret;
+
+ new_opp = devfreq_recommended_opp(dev, freq, flags);
+ if (IS_ERR(new_opp)) {
+ ret = PTR_ERR(new_opp);
+ dev_err(dev, "failed to get recommended opp: %d\n", ret);
+ return ret;
+ }
+ new_freq = dev_pm_opp_get_freq(new_opp);
+ dev_pm_opp_put(new_opp);
+
+ ret = clk_set_min_rate(priv->clk, new_freq);
+ if (ret)
+ return ret;
+
+ ret = clk_set_rate(priv->clk, 0);
+ if (ret) {
+ clk_set_min_rate(priv->clk, priv->devfreq->previous_freq);
+ return ret;
+ }
+
+ return 0;
+}
+
+static int imx_devfreq_get_cur_freq(struct device *dev, unsigned long *freq)
+{
+ struct imx_devfreq *priv = dev_get_drvdata(dev);
+
+ *freq = clk_get_rate(priv->clk);
+
+ return 0;
+}
+
+static int imx_devfreq_get_dev_status(struct device *dev,
+ struct devfreq_dev_status *stat)
+{
+ struct imx_devfreq *priv = dev_get_drvdata(dev);
+
+ stat->busy_time = 0;
+ stat->total_time = 0;
+ stat->current_frequency = clk_get_rate(priv->clk);
+
+ return 0;
+}
+
+static void imx_devfreq_exit(struct device *dev)
+{
+ return dev_pm_opp_of_remove_table(dev);
+}
+
+static int imx_devfreq_probe(struct platform_device *pdev)
+{
+ struct device *dev = &pdev->dev;
+ struct imx_devfreq *priv;
+ const char *gov = DEVFREQ_GOV_USERSPACE;
+ int ret;
+
+ priv = devm_kzalloc(dev, sizeof(*priv), GFP_KERNEL);
+ if (!priv)
+ return -ENOMEM;
+
+ priv->clk = devm_clk_get(dev, NULL);
+ if (IS_ERR(priv->devfreq)) {
+ ret = PTR_ERR(priv->devfreq);
+ dev_err(dev, "failed to fetch clk: %d\n", ret);
+ return ret;
+ }
+ platform_set_drvdata(pdev, priv);
+
+ ret = dev_pm_opp_of_add_table(dev);
+ if (ret < 0) {
+ dev_err(dev, "failed to get OPP table\n");
+ return ret;
+ }
+
+ priv->profile.polling_ms = 1000;
+ priv->profile.target = imx_devfreq_target;
+ priv->profile.get_dev_status = imx_devfreq_get_dev_status;
+ priv->profile.exit = imx_devfreq_exit;
+ priv->profile.get_cur_freq = imx_devfreq_get_cur_freq;
+ priv->profile.initial_freq = clk_get_rate(priv->clk);
+
+ priv->devfreq = devm_devfreq_add_device(dev, &priv->profile,
+ gov, NULL);
+ if (IS_ERR(priv->devfreq)) {
+ ret = PTR_ERR(priv->devfreq);
+ dev_err(dev, "failed to add devfreq device: %d\n", ret);
+ goto err;
+ }
+
+ return 0;
+
+err:
+ dev_pm_opp_of_remove_table(dev);
+ return ret;
+}
+
+static const struct of_device_id imx_devfreq_of_match[] = {
+ { .compatible = "fsl,imx8m-ddrc", },
+ { .compatible = "fsl,imx8m-noc", },
+ { .compatible = "fsl,imx8m-nic", },
+ { /* sentinel */ },
+};
+MODULE_DEVICE_TABLE(of, imx_devfreq_of_match);
+
+static struct platform_driver imx_devfreq_platdrv = {
+ .probe = imx_devfreq_probe,
+ .driver = {
+ .name = "imx-devfreq",
+ .of_match_table = of_match_ptr(imx_devfreq_of_match),
+ },
+};
+module_platform_driver(imx_devfreq_platdrv);
+
+MODULE_DESCRIPTION("Generic i.MX bus frequency driver");
+MODULE_AUTHOR("Leonard Crestez <leonard.crestez@nxp.com>");
+MODULE_LICENSE("GPL v2");
Add initial support for frequency switching on pieces of the imx interconnect fabric. Uses clk_set_min_rate so that other subsytems can also impose minimum rate requests. Signed-off-by: Leonard Crestez <leonard.crestez@nxp.com> --- drivers/devfreq/Kconfig | 10 +++ drivers/devfreq/Makefile | 1 + drivers/devfreq/imx-devfreq.c | 143 ++++++++++++++++++++++++++++++++++ 3 files changed, 154 insertions(+) create mode 100644 drivers/devfreq/imx-devfreq.c