[v3,6/6] ARM: dts: ifc6410: enable pcie dt node for this board

Commit Message

Stanimir Varbanov Nov. 23, 2015, 9:29 a.m. UTC

Enable pcie dt node and fill pcie dt node with regulator, pinctrl
and reset gpio, to use the pcie on the ifc6410 board.

Signed-off-by: Stanimir Varbanov <[e-mail]>
---
 arch/arm/boot/dts/qcom-apq8064-ifc6410.dts |   26 ++++++++++++++++++++++++++
 1 file changed, 26 insertions(+)

Patch

diff --git a/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts b/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts
index 11ac608b6d50..bdee36a9b418 100644
--- a/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts
+++ b/arch/arm/boot/dts/qcom-apq8064-ifc6410.dts
@@ -47,6 +47,18 @@ 
 					bias-disable;
 				};
 			};
+
+			pcie0_pins: pcie0_pinmux {
+				mux {
+					pins = "gpio27";
+					function = "gpio";
+				};
+				conf {
+					pins = "gpio27";
+					drive-strength = <12>;
+					bias-disable;
+				};
+			};
 		};
 
 		rpm@108000 {
@@ -123,6 +135,10 @@ 
 				pm8921_lvs1: lvs1 {
 					bias-pull-down;
 				};
+
+				pm8921_lvs6: lvs6 {
+					bias-pull-down;
+				};
 			};
 		};
 
@@ -231,6 +247,16 @@ 
 			status = "okay";
 		};
 
+		pci@1b500000 {
+			status = "ok";
+			vdda-supply = <&pm8921_s3>;
+			vdda_phy-supply = <&pm8921_lvs6>;
+			vdda_refclk-supply = <&ext_3p3v>;
+			pinctrl-0 = <&pcie0_pins>;
+			pinctrl-names = "default";
+			perst-gpio = <&tlmm_pinmux 27 GPIO_ACTIVE_LOW>;
+		};
+
 		qcom,ssbi@500000 {
 			pmic@0 {
 				gpio@150 {