diff mbox series

[v6,2/4] gpio: mvebu: add pwm support for Armada 8K/7K

Message ID d5a3c49ac3ea56fb467ec325ecc769f3563a0d9b.1609917364.git.baruch@tkos.co.il (mailing list archive)
State New, archived
Headers show
Series gpio: mvebu: Armada 8K/7K PWM support | expand

Commit Message

Baruch Siach Jan. 6, 2021, 7:37 a.m. UTC
Use the marvell,pwm-offset DT property to store the location of PWM
signal duration registers.

Since we have more than two GPIO chips per system, we can't use the
alias id to differentiate between them. Use the offset value for that.

Signed-off-by: Baruch Siach <baruch@tkos.co.il>
---
v3: Split mvebu_pwm_probe() move out of this patch into a separate fix
    (Andrew Lunn)
---
 drivers/gpio/gpio-mvebu.c | 101 +++++++++++++++++++++++++-------------
 1 file changed, 68 insertions(+), 33 deletions(-)
diff mbox series

Patch

diff --git a/drivers/gpio/gpio-mvebu.c b/drivers/gpio/gpio-mvebu.c
index a912a8fed197..daf2fd8acb21 100644
--- a/drivers/gpio/gpio-mvebu.c
+++ b/drivers/gpio/gpio-mvebu.c
@@ -70,7 +70,12 @@ 
  */
 #define PWM_BLINK_ON_DURATION_OFF	0x0
 #define PWM_BLINK_OFF_DURATION_OFF	0x4
+#define PWM_BLINK_COUNTER_B_OFF		0x8
 
+/* Armada 8k variant gpios register offsets */
+#define AP80X_GPIO0_OFF_A8K		0x1040
+#define CP11X_GPIO0_OFF_A8K		0x100
+#define CP11X_GPIO1_OFF_A8K		0x140
 
 /* The MV78200 has per-CPU registers for edge mask and level mask */
 #define GPIO_EDGE_MASK_MV78200_OFF(cpu)	  ((cpu) ? 0x30 : 0x18)
@@ -93,6 +98,7 @@ 
 
 struct mvebu_pwm {
 	struct regmap		*regs;
+	u32			 offset;
 	unsigned long		 clk_rate;
 	struct gpio_desc	*gpiod;
 	struct pwm_chip		 chip;
@@ -283,12 +289,12 @@  mvebu_gpio_write_level_mask(struct mvebu_gpio_chip *mvchip, u32 val)
  */
 static unsigned int mvebu_pwmreg_blink_on_duration(struct mvebu_pwm *mvpwm)
 {
-	return PWM_BLINK_ON_DURATION_OFF;
+	return mvpwm->offset + PWM_BLINK_ON_DURATION_OFF;
 }
 
 static unsigned int mvebu_pwmreg_blink_off_duration(struct mvebu_pwm *mvpwm)
 {
-	return PWM_BLINK_OFF_DURATION_OFF;
+	return mvpwm->offset + PWM_BLINK_OFF_DURATION_OFF;
 }
 
 /*
@@ -778,51 +784,80 @@  static int mvebu_pwm_probe(struct platform_device *pdev,
 	struct device *dev = &pdev->dev;
 	struct mvebu_pwm *mvpwm;
 	void __iomem *base;
+	u32 offset;
 	u32 set;
 
-	if (!of_device_is_compatible(mvchip->chip.of_node,
-				     "marvell,armada-370-gpio"))
-		return 0;
-
-	/*
-	 * There are only two sets of PWM configuration registers for
-	 * all the GPIO lines on those SoCs which this driver reserves
-	 * for the first two GPIO chips. So if the resource is missing
-	 * we can't treat it as an error.
-	 */
-	if (!platform_get_resource_byname(pdev, IORESOURCE_MEM, "pwm"))
+	if (of_device_is_compatible(mvchip->chip.of_node,
+				    "marvell,armada-370-gpio")) {
+		/*
+		 * There are only two sets of PWM configuration registers for
+		 * all the GPIO lines on those SoCs which this driver reserves
+		 * for the first two GPIO chips. So if the resource is missing
+		 * we can't treat it as an error.
+		 */
+		if (!platform_get_resource_byname(pdev, IORESOURCE_MEM, "pwm"))
+			return 0;
+		offset = 0;
+	} else if (mvchip->soc_variant == MVEBU_GPIO_SOC_VARIANT_A8K) {
+		int ret = of_property_read_u32(dev->of_node,
+					       "marvell,pwm-offset", &offset);
+		if (ret < 0)
+			return 0;
+	} else {
 		return 0;
+	}
 
 	if (IS_ERR(mvchip->clk))
 		return PTR_ERR(mvchip->clk);
 
-	/*
-	 * Use set A for lines of GPIO chip with id 0, B for GPIO chip
-	 * with id 1. Don't allow further GPIO chips to be used for PWM.
-	 */
-	if (id == 0)
-		set = 0;
-	else if (id == 1)
-		set = U32_MAX;
-	else
-		return -EINVAL;
-	regmap_write(mvchip->regs,
-		     GPIO_BLINK_CNT_SELECT_OFF + mvchip->offset, set);
-
 	mvpwm = devm_kzalloc(dev, sizeof(struct mvebu_pwm), GFP_KERNEL);
 	if (!mvpwm)
 		return -ENOMEM;
 	mvchip->mvpwm = mvpwm;
 	mvpwm->mvchip = mvchip;
+	mvpwm->offset = offset;
+
+	if (mvchip->soc_variant == MVEBU_GPIO_SOC_VARIANT_A8K) {
+		mvpwm->regs = mvchip->regs;
+
+		switch (mvchip->offset) {
+		case AP80X_GPIO0_OFF_A8K:
+		case CP11X_GPIO0_OFF_A8K:
+			/* Blink counter A */
+			set = 0;
+			break;
+		case CP11X_GPIO1_OFF_A8K:
+			/* Blink counter B */
+			set = U32_MAX;
+			mvpwm->offset += PWM_BLINK_COUNTER_B_OFF;
+			break;
+		default:
+			return -EINVAL;
+		}
+	} else {
+		base = devm_platform_ioremap_resource_byname(pdev, "pwm");
+		if (IS_ERR(base))
+			return PTR_ERR(base);
 
-	base = devm_platform_ioremap_resource_byname(pdev, "pwm");
-	if (IS_ERR(base))
-		return PTR_ERR(base);
+		mvpwm->regs = devm_regmap_init_mmio(&pdev->dev, base,
+						    &mvebu_gpio_regmap_config);
+		if (IS_ERR(mvpwm->regs))
+			return PTR_ERR(mvpwm->regs);
 
-	mvpwm->regs = devm_regmap_init_mmio(&pdev->dev, base,
-					    &mvebu_gpio_regmap_config);
-	if (IS_ERR(mvpwm->regs))
-		return PTR_ERR(mvpwm->regs);
+		/*
+		 * Use set A for lines of GPIO chip with id 0, B for GPIO chip
+		 * with id 1. Don't allow further GPIO chips to be used for PWM.
+		 */
+		if (id == 0)
+			set = 0;
+		else if (id == 1)
+			set = U32_MAX;
+		else
+			return -EINVAL;
+	}
+
+	regmap_write(mvchip->regs,
+		     GPIO_BLINK_CNT_SELECT_OFF + mvchip->offset, set);
 
 	mvpwm->clk_rate = clk_get_rate(mvchip->clk);
 	if (!mvpwm->clk_rate) {