[0/6] Add DT bindings for USB HS/SS in QCS404

Message

Bryan O'Donoghue March 11, 2020, 7:15 p.m. UTC

This set adds DT entries for the Primary and Secondary DWC3 controllers on
QCS404 and the PHYs attached to those controllers.

Additional board-specific bindings are required to make the SoC change
functional on the EVBs as on the EVB a type-c connector interfaces with the
SoC which is responsible to toggle VBUS via a regulator interface directly.

These patches have been through seven review cycles already and have a
number of Review-by and Ack-by. For the pusposes of making it easier to
merge this set focuses on the SoC DT bindings and target board bindings
alone.

The last set for can be found here:
https://lkml.org/lkml/2020/3/3/807

Bjorn Andersson (1):
  arm64: dts: qcom: qcs404: Add USB devices and PHYs

Bryan O'Donoghue (5):
  arm64: dts: qcom: qcs404-evb: Define VBUS pins
  arm64: dts: qcom: qcs404-evb: Define USB ID pin
  arm64: dts: qcom: qcs404-evb: Describe external VBUS regulator
  arm64: dts: qcom: qcs404-evb: Raise vreg_l12_3p3 minimum voltage
  arm64: dts: qcom: qcs404-evb: Enable USB controllers

 arch/arm64/boot/dts/qcom/qcs404-evb.dtsi |  90 +++++++++++++++++++-
 arch/arm64/boot/dts/qcom/qcs404.dtsi     | 100 +++++++++++++++++++++++
 2 files changed, 189 insertions(+), 1 deletion(-)