mbox series

[v3,0/3] phy: qcom: edp: Add support for X1E80100

Message ID 20231122-phy-qualcomm-edp-x1e80100-v3-0-576fc4e9559d@linaro.org (mailing list archive)
Headers show
Series phy: qcom: edp: Add support for X1E80100 | expand

Message

Abel Vesa Dec. 7, 2023, 10:52 a.m. UTC 
This patchset adds support for the X1E80100 eDP/DP PHY and documents its
compatible.

Now, the X1E80100 uses QMP COM v6 registers, so it is added here. This
required configuration-based register offsets support, so that's done
here as well. Then, the legacy "PHY type" specific compatible should not
be used by newer platforms, so the platform-specific configurations have
been added. Rest of it is pretty much variables renaming to make their
use more obvious.

Only tested this on the X1E80100 CRD. Need to test it on at least one
legacy with "PHY type" compatible platforms.

This patchset depends on the QSERDES_V6_COM_SSC_ADJ_PER1 register offset
added by the following patchset:

https://lore.kernel.org/all/20231122-phy-qualcomm-v6-v6-20-v7-new-offsets-v1-0-d9340d362664@linaro.org/

Signed-off-by: Abel Vesa <abel.vesa@linaro.org>
---
Changes in v3:
- The whole support for COM v6 register offsets has been reworked from scratch.
- The bindings now document the phy-type property. (dropped Krzysztof's R-b tag)
- New patch for adding PHY_TYPE_EDP into bindings header file.
- Link to v2: https://lore.kernel.org/r/20231122-phy-qualcomm-edp-x1e80100-v2-0-114e789f0195@linaro.org

Changes in v2:
- Added Krzysztof's R-b tag
- Re-worded commit message for bindings to suggest same PHY can work in
  both eDP and DP mode rather than being different PHY types.
- Implemented different qcom_edp_configure_ssc and
  qcom_edp_configure_pll for each version of the PHY.
- Dropped the cfg8 override in qcom_edp_phy_init
- Used enum instead of defines for PHY versions
- Link to v1: https://lore.kernel.org/r/20231122-phy-qualcomm-edp-x1e80100-v1-0-a9938990edb3@linaro.org

---
Abel Vesa (3):
      dt-bindings: phy: Add PHY_TYPE_EDP definition
      dt-bindings: phy: qcom-edp: Add X1E80100 PHY compatibles
      phy: qcom: edp: Add support for X1E80100 PHY

 .../devicetree/bindings/phy/qcom,edp-phy.yaml      |  15 +
 drivers/phy/qualcomm/phy-qcom-edp.c                | 583 +++++++++++++++++----
 include/dt-bindings/phy/phy.h                      |   1 +
 3 files changed, 506 insertions(+), 93 deletions(-)
---
base-commit: 629a3b49f3f957e975253c54846090b8d5ed2e9b
change-id: 20231122-phy-qualcomm-edp-x1e80100-a57c15fff32b

Best regards,