diff mbox

[2/6] scsi: ufs: fix power info after link start-up

Message ID 1414059917-13831-3-git-send-email-draviv@codeaurora.org (mailing list archive)
State Not Applicable, archived
Headers show

Commit Message

Dolev Raviv Oct. 23, 2014, 10:25 a.m. UTC 
From: Yaniv Gardi <ygardi@codeaurora.org>

After link start-up power mode will always be PWM G1. This is not
reflected in the pwr_info struct which will keep the previous values.
Since ufshcd_change_power_mode() tries to avoid unnecessary power mode
change if the requested power mode and current power mode are same,
power mode change won't execute again after driver initialization.

This patch solves the problem by setting pwr_info to PWM G1 after link
start-up.

Signed-off-by: Yaniv Gardi <ygardi@codeaurora.org>
Signed-off-by: Dolev Raviv <draviv@codeaurora.org>
diff mbox

Patch

diff --git a/drivers/scsi/ufs/ufshcd.c b/drivers/scsi/ufs/ufshcd.c
index 59b6544..77a4e38 100644
--- a/drivers/scsi/ufs/ufshcd.c
+++ b/drivers/scsi/ufs/ufshcd.c
@@ -2246,6 +2246,22 @@  static int ufshcd_uic_hibern8_exit(struct ufs_hba *hba)
 	return ret;
 }
 
+ /**
+ * ufshcd_init_pwr_info - setting the POR (power on reset)
+ * values in hba power info
+ * @hba: per-adapter instance
+ */
+static void ufshcd_init_pwr_info(struct ufs_hba *hba)
+{
+	hba->pwr_info.gear_rx = UFS_PWM_G1;
+	hba->pwr_info.gear_tx = UFS_PWM_G1;
+	hba->pwr_info.lane_rx = 1;
+	hba->pwr_info.lane_tx = 1;
+	hba->pwr_info.pwr_rx = SLOWAUTO_MODE;
+	hba->pwr_info.pwr_tx = SLOWAUTO_MODE;
+	hba->pwr_info.hs_rate = 0;
+}
+
 /**
  * ufshcd_get_max_pwr_mode - reads the max power mode negotiated with device
  * @hba: per-adapter instance
@@ -4118,6 +4134,8 @@  static int ufshcd_probe_hba(struct ufs_hba *hba)
 	if (ret)
 		goto out;
 
+	ufshcd_init_pwr_info(hba);
+
 	/* UniPro link is active now */
 	ufshcd_set_link_active(hba);