@@ -724,36 +724,13 @@ static int qcom_qmp_phy_poweron(struct phy *phy)
{
struct qmp_phy *qphy = phy_get_drvdata(phy);
struct qcom_qmp *qmp = qphy->qmp;
- int num = qmp->cfg->num_vregs;
int ret;
- dev_vdbg(&phy->dev, "Powering on QMP phy\n");
-
- /* turn on regulator supplies */
- ret = regulator_bulk_enable(num, qmp->vregs);
- if (ret) {
- dev_err(qmp->dev, "failed to enable regulators, err=%d\n", ret);
- return ret;
- }
-
ret = clk_prepare_enable(qphy->pipe_clk);
- if (ret) {
+ if (ret)
dev_err(qmp->dev, "pipe_clk enable failed, err=%d\n", ret);
- regulator_bulk_disable(num, qmp->vregs);
- return ret;
- }
- return 0;
-}
-
-static int qcom_qmp_phy_poweroff(struct phy *phy)
-{
- struct qmp_phy *qphy = phy_get_drvdata(phy);
- struct qcom_qmp *qmp = qphy->qmp;
-
- regulator_bulk_disable(qmp->cfg->num_vregs, qmp->vregs);
-
- return 0;
+ return ret;
}
static int qcom_qmp_phy_com_init(struct qcom_qmp *qmp)
@@ -768,6 +745,19 @@ static int qcom_qmp_phy_com_init(struct qcom_qmp *qmp)
return 0;
}
+ /* turn on regulator supplies */
+ ret = regulator_bulk_enable(cfg->num_vregs, qmp->vregs);
+ if (ret) {
+ dev_err(qmp->dev, "failed to enable regulators, err=%d\n", ret);
+ goto err_reg_enable;
+ }
+
+ ret = clk_bulk_prepare_enable(cfg->num_clks, qmp->clks);
+ if (ret) {
+ dev_err(qmp->dev, "failed to enable clks, err=%d\n", ret);
+ goto err_clk_enable;
+ }
+
for (i = 0; i < cfg->num_resets; i++) {
ret = reset_control_deassert(qmp->resets[i]);
if (ret) {
@@ -812,6 +802,10 @@ static int qcom_qmp_phy_com_init(struct qcom_qmp *qmp)
err_rst:
while (--i >= 0)
reset_control_assert(qmp->resets[i]);
+ clk_bulk_disable_unprepare(cfg->num_clks, qmp->clks);
+err_clk_enable:
+ regulator_bulk_disable(cfg->num_vregs, qmp->vregs);
+err_reg_enable:
mutex_unlock(&qmp->phy_mutex);
return ret;
@@ -841,6 +835,10 @@ static int qcom_qmp_phy_com_exit(struct qcom_qmp *qmp)
while (--i >= 0)
reset_control_assert(qmp->resets[i]);
+ clk_bulk_disable_unprepare(cfg->num_clks, qmp->clks);
+
+ regulator_bulk_disable(cfg->num_vregs, qmp->vregs);
+
mutex_unlock(&qmp->phy_mutex);
return 0;
@@ -861,15 +859,9 @@ static int qcom_qmp_phy_init(struct phy *phy)
dev_vdbg(qmp->dev, "Initializing QMP phy\n");
- ret = clk_bulk_prepare_enable(cfg->num_clks, qmp->clks);
- if (ret) {
- dev_err(qmp->dev, "failed to enable clks, err=%d\n", ret);
- return ret;
- }
-
ret = qcom_qmp_phy_com_init(qmp);
if (ret)
- goto err_com_init;
+ return ret;
if (cfg->has_lane_rst) {
ret = reset_control_deassert(qphy->lane_rst);
@@ -917,8 +909,6 @@ static int qcom_qmp_phy_init(struct phy *phy)
reset_control_assert(qphy->lane_rst);
err_lane_rst:
qcom_qmp_phy_com_exit(qmp);
-err_com_init:
- clk_bulk_disable_unprepare(cfg->num_clks, qmp->clks);
return ret;
}
@@ -945,8 +935,6 @@ static int qcom_qmp_phy_exit(struct phy *phy)
qcom_qmp_phy_com_exit(qmp);
- clk_bulk_disable_unprepare(cfg->num_clks, qmp->clks);
-
return 0;
}
@@ -1060,7 +1048,6 @@ static int phy_pipe_clk_register(struct qcom_qmp *qmp, struct device_node *np)
.init = qcom_qmp_phy_init,
.exit = qcom_qmp_phy_exit,
.power_on = qcom_qmp_phy_poweron,
- .power_off = qcom_qmp_phy_poweroff,
.owner = THIS_MODULE,
};
PHY regulators which are enabled from power_on() must be ON before turning-on clocks and initializing it as part of init(). As most of the core drivers perform power_on() after init(), move PHY regulators enable to com_init() and use power_on() to only enable pipe_clk. This pipe_clk is output from PHY and some core drivers e.g. PCIe follow specific sequence after phy_init() that mandates pipe_clk to be enabled from power_on() only. On similar lines move clk_enable from init() to com_init() which executes once for multi lane PHYs. Signed-off-by: Manu Gautam <mgautam@codeaurora.org> --- drivers/phy/qualcomm/phy-qcom-qmp.c | 61 +++++++++++++++---------------------- 1 file changed, 24 insertions(+), 37 deletions(-)