diff mbox series

[v1] Bluetooth: hci_qca: Enhance retry logic in qca_setup

Message ID 1601965767-18796-1-git-send-email-bgodavar@codeaurora.org (mailing list archive)
State Superseded
Headers show
Series [v1] Bluetooth: hci_qca: Enhance retry logic in qca_setup | expand

Commit Message

Balakrishna Godavarthi Oct. 6, 2020, 6:29 a.m. UTC 
Currently driver only retries to download FW if FW downloading
is failed. Sometimes observed command timeout for version request
command, if this happen on some platforms during boot time, then
a reboot is needed to turn ON BT. Instead to avoid a reboot, now
extended retry logic for version request command too.

Signed-off-by: Balakrishna Godavarthi <bgodavar@codeaurora.org>
---
 drivers/bluetooth/hci_qca.c | 34 ++++++++++++++++++----------------
 1 file changed, 18 insertions(+), 16 deletions(-)

Comments

Abhishek Pandit-Subedi Oct. 6, 2020, 9:51 p.m. UTC | #1 
Reviewed-by: Abhishek Pandit-Subedi <abhishekpandit@chromium.org>

On Mon, Oct 5, 2020 at 11:33 PM Balakrishna Godavarthi
<bgodavar@codeaurora.org> wrote:
>
> Currently driver only retries to download FW if FW downloading
> is failed. Sometimes observed command timeout for version request
> command, if this happen on some platforms during boot time, then
> a reboot is needed to turn ON BT. Instead to avoid a reboot, now
> extended retry logic for version request command too.
>
> Signed-off-by: Balakrishna Godavarthi <bgodavar@codeaurora.org>
diff mbox series

Patch

diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index 2d3f1f1..1c9a2d46 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -1672,7 +1672,7 @@  static int qca_setup(struct hci_uart *hu)
 retry:
 	ret = qca_power_on(hdev);
 	if (ret)
-		return ret;
+		goto out;
 
 	clear_bit(QCA_SSR_TRIGGERED, &qca->flags);
 
@@ -1681,7 +1681,7 @@  static int qca_setup(struct hci_uart *hu)
 
 		ret = qca_read_soc_version(hdev, &soc_ver, soc_type);
 		if (ret)
-			return ret;
+			goto out;
 	} else {
 		qca_set_speed(hu, QCA_INIT_SPEED);
 	}
@@ -1691,7 +1691,7 @@  static int qca_setup(struct hci_uart *hu)
 	if (speed) {
 		ret = qca_set_speed(hu, QCA_OPER_SPEED);
 		if (ret)
-			return ret;
+			goto out;
 
 		qca_baudrate = qca_get_baudrate_value(speed);
 	}
@@ -1700,7 +1700,7 @@  static int qca_setup(struct hci_uart *hu)
 		/* Get QCA version information */
 		ret = qca_read_soc_version(hdev, &soc_ver, soc_type);
 		if (ret)
-			return ret;
+			goto out;
 	}
 
 	bt_dev_info(hdev, "QCA controller version 0x%08x", soc_ver);
@@ -1721,20 +1721,22 @@  static int qca_setup(struct hci_uart *hu)
 		 * patch/nvm-config is found, so run with original fw/config.
 		 */
 		ret = 0;
-	} else {
-		if (retries < MAX_INIT_RETRIES) {
-			qca_power_shutdown(hu);
-			if (hu->serdev) {
-				serdev_device_close(hu->serdev);
-				ret = serdev_device_open(hu->serdev);
-				if (ret) {
-					bt_dev_err(hdev, "failed to open port");
-					return ret;
-				}
+	}
+
+out:
+	if (ret && retries < MAX_INIT_RETRIES) {
+		bt_dev_warn(hdev, "Retry BT power ON:%d", retries);
+		qca_power_shutdown(hu);
+		if (hu->serdev) {
+			serdev_device_close(hu->serdev);
+			ret = serdev_device_open(hu->serdev);
+			if (ret) {
+				bt_dev_err(hdev, "failed to open port");
+				return ret;
 			}
-			retries++;
-			goto retry;
 		}
+		retries++;
+		goto retry;
 	}
 
 	/* Setup bdaddr */