similarity index 100%
rename from Documentation/devicetree/bindings/cpufreq/cpufreq-cpu0.txt
rename to Documentation/devicetree/bindings/cpufreq/cpufreq-generic.txt
@@ -183,16 +183,16 @@ config CPU_FREQ_GOV_CONSERVATIVE
If in doubt, say N.
-config GENERIC_CPUFREQ_CPU0
- tristate "Generic CPU0 cpufreq driver"
+config CPUFREQ_GENERIC
+ tristate "Generic cpufreq driver"
depends on HAVE_CLK && OF
- # if CPU_THERMAL is on and THERMAL=m, CPU0 cannot be =y:
+ # if CPU_THERMAL is on and THERMAL=m, GENERIC cannot be =y:
depends on !CPU_THERMAL || THERMAL
select PM_OPP
help
- This adds a generic cpufreq driver for CPU0 frequency management.
+ This adds a generic cpufreq driver for frequency management.
It supports both uniprocessor (UP) and symmetric multiprocessor (SMP)
- systems which share clock and voltage across all CPUs.
+ systems which may or maynot share clock and voltage across all CPUs.
If in doubt, say N.
@@ -92,7 +92,7 @@ config ARM_EXYNOS_CPU_FREQ_BOOST_SW
config ARM_HIGHBANK_CPUFREQ
tristate "Calxeda Highbank-based"
- depends on ARCH_HIGHBANK && GENERIC_CPUFREQ_CPU0 && REGULATOR
+ depends on ARCH_HIGHBANK && CPUFREQ_GENERIC && REGULATOR
default m
help
This adds the CPUFreq driver for Calxeda Highbank SoC
@@ -13,7 +13,7 @@ obj-$(CONFIG_CPU_FREQ_GOV_ONDEMAND) += cpufreq_ondemand.o
obj-$(CONFIG_CPU_FREQ_GOV_CONSERVATIVE) += cpufreq_conservative.o
obj-$(CONFIG_CPU_FREQ_GOV_COMMON) += cpufreq_governor.o
-obj-$(CONFIG_GENERIC_CPUFREQ_CPU0) += cpufreq-cpu0.o
+obj-$(CONFIG_CPUFREQ_GENERIC) += cpufreq-generic.o
##################################################################################
# x86 drivers.
similarity index 91%
rename from drivers/cpufreq/cpufreq-cpu0.c
rename to drivers/cpufreq/cpufreq-generic.c
@@ -4,7 +4,7 @@
* Copyright (C) 2014 Linaro.
* Viresh Kumar <viresh.kumar@linaro.org>
*
- * The OPP code in function cpu0_set_target() is reused from
+ * The OPP code in function set_target() is reused from
* drivers/cpufreq/omap-cpufreq.c
*
* This program is free software; you can redistribute it and/or modify
@@ -35,7 +35,7 @@ struct private_data {
unsigned int voltage_tolerance; /* in percentage */
};
-static int cpu0_set_target(struct cpufreq_policy *policy, unsigned int index)
+static int set_target(struct cpufreq_policy *policy, unsigned int index)
{
struct dev_pm_opp *opp;
struct cpufreq_frequency_table *freq_table = policy->freq_table;
@@ -201,7 +201,7 @@ static void find_siblings(struct cpufreq_policy *policy)
}
}
-static int cpu0_cpufreq_init(struct cpufreq_policy *policy)
+static int cpufreq_init(struct cpufreq_policy *policy)
{
struct cpufreq_frequency_table *freq_table;
struct thermal_cooling_device *cdev;
@@ -318,7 +318,7 @@ out_put_reg_clk:
return ret;
}
-static int cpu0_cpufreq_exit(struct cpufreq_policy *policy)
+static int cpufreq_exit(struct cpufreq_policy *policy)
{
struct private_data *priv = policy->driver_data;
@@ -332,18 +332,18 @@ static int cpu0_cpufreq_exit(struct cpufreq_policy *policy)
return 0;
}
-static struct cpufreq_driver cpu0_cpufreq_driver = {
+static struct cpufreq_driver generic_cpufreq_driver = {
.flags = CPUFREQ_STICKY | CPUFREQ_NEED_INITIAL_FREQ_CHECK,
.verify = cpufreq_generic_frequency_table_verify,
- .target_index = cpu0_set_target,
+ .target_index = set_target,
.get = cpufreq_generic_get,
- .init = cpu0_cpufreq_init,
- .exit = cpu0_cpufreq_exit,
- .name = "generic_cpu0",
+ .init = cpufreq_init,
+ .exit = cpufreq_exit,
+ .name = "cpufreq-generic",
.attr = cpufreq_generic_attr,
};
-static int cpu0_cpufreq_probe(struct platform_device *pdev)
+static int generic_cpufreq_probe(struct platform_device *pdev)
{
struct device *cpu_dev;
struct regulator *cpu_reg;
@@ -365,30 +365,30 @@ static int cpu0_cpufreq_probe(struct platform_device *pdev)
if (!IS_ERR(cpu_reg))
regulator_put(cpu_reg);
- ret = cpufreq_register_driver(&cpu0_cpufreq_driver);
+ ret = cpufreq_register_driver(&generic_cpufreq_driver);
if (ret)
dev_err(cpu_dev, "failed register driver: %d\n", ret);
return ret;
}
-static int cpu0_cpufreq_remove(struct platform_device *pdev)
+static int generic_cpufreq_remove(struct platform_device *pdev)
{
- cpufreq_unregister_driver(&cpu0_cpufreq_driver);
+ cpufreq_unregister_driver(&generic_cpufreq_driver);
return 0;
}
-static struct platform_driver cpu0_cpufreq_platdrv = {
+static struct platform_driver generic_cpufreq_platdrv = {
.driver = {
.name = "cpufreq-cpu0",
.owner = THIS_MODULE,
},
- .probe = cpu0_cpufreq_probe,
- .remove = cpu0_cpufreq_remove,
+ .probe = generic_cpufreq_probe,
+ .remove = generic_cpufreq_remove,
};
-module_platform_driver(cpu0_cpufreq_platdrv);
+module_platform_driver(generic_cpufreq_platdrv);
MODULE_AUTHOR("Viresh Kumar <viresh.kumar@linaro.org>");
MODULE_AUTHOR("Shawn Guo <shawn.guo@linaro.org>");
-MODULE_DESCRIPTION("Generic CPU0 cpufreq driver");
+MODULE_DESCRIPTION("Generic cpufreq driver");
MODULE_LICENSE("GPL");
This is not a cpu0 driver anymore as it supports any number of clusters with separate clock/voltage lines. Lets rename it to 'cpufreq_generic' from 'cpufreq_cpu0'. '.name' field of platform driver/devices isn't renamed yet, would be done separately. Signed-off-by: Viresh Kumar <viresh.kumar@linaro.org> --- .../{cpufreq-cpu0.txt => cpufreq-generic.txt} | 0 drivers/cpufreq/Kconfig | 10 +++--- drivers/cpufreq/Kconfig.arm | 2 +- drivers/cpufreq/Makefile | 2 +- .../cpufreq/{cpufreq-cpu0.c => cpufreq-generic.c} | 36 +++++++++++----------- 5 files changed, 25 insertions(+), 25 deletions(-) rename Documentation/devicetree/bindings/cpufreq/{cpufreq-cpu0.txt => cpufreq-generic.txt} (100%) rename drivers/cpufreq/{cpufreq-cpu0.c => cpufreq-generic.c} (91%)