diff mbox

[2/3,v5] ARM: dts: reference PM8058 as IRQ parent

Message ID 20170105151336.18667-2-linus.walleij@linaro.org (mailing list archive)
State Accepted, archived
Delegated to: Andy Gross
Headers show

Commit Message

Linus Walleij Jan. 5, 2017, 3:13 p.m. UTC 
Some nodes are referencing the pm8058_gpio as IRQ parent, but
the HW IRQ offset they are supplying is actually that for the
parent to that controller: the PM8058 itself. Since that is the
proper parent, reference it directly.

We can switch this to the pm8058_gpio and the proper offset
once we have fixed the SSBI GPIO driver to properly deal with
the hierarchical IRQ domain and get proper local offset
translation.

Acked-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
---
ChangeLog v4->v5:
- No changes, just rebased on v4.10-rc1
ChangeLog v1->v2:
- Add Bjorn's ACK.
- Follow version numbering of the primary patch.
---
 arch/arm/boot/dts/qcom-apq8060-dragonboard.dts | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)
diff mbox

Patch

diff --git a/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts b/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts
index 4a532ddab53a..ea660ffa03ea 100644
--- a/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts
+++ b/arch/arm/boot/dts/qcom-apq8060-dragonboard.dts
@@ -369,8 +369,8 @@ 
 				ak8975@0c {
 					compatible = "asahi-kasei,ak8975";
 					reg = <0x0c>;
-					/* GPIO33 has interrupt 224 on the PM8058 */
-					interrupt-parent = <&pm8058_gpio>;
+					/* FIXME: GPIO33 has interrupt 224 on the PM8058 */
+					interrupt-parent = <&pm8058>;
 					interrupts = <224 IRQ_TYPE_EDGE_RISING>;
 					pinctrl-names = "default";
 					pinctrl-0 = <&dragon_ak8975_gpios>;
@@ -380,8 +380,8 @@ 
 				bmp085@77 {
 					compatible = "bosch,bmp085";
 					reg = <0x77>;
-					/* GPIO16 has interrupt 207 on the PM8058 */
-					interrupt-parent = <&pm8058_gpio>;
+					/* FIXME: GPIO16 has interrupt 207 on the PM8058 */
+					interrupt-parent = <&pm8058>;
 					interrupts = <207 IRQ_TYPE_EDGE_RISING>;
 					reset-gpios = <&tlmm 86 GPIO_ACTIVE_LOW>;
 					pinctrl-names = "default";