| Message ID | 20171207151942.5805-5-damien.riegel@savoirfairelinux.com (mailing list archive) |
|---|---|
| State | Accepted |
| Delegated to: | Andy Gross |
| Headers | show |
On Thu 07 Dec 07:19 PST 2017, Damien Riegel wrote: > These nodes reserve and configure some pins as GPIOs. They are not > generic pinctrls, they actually belong to board files but they are not > used by any other node, so just drop them altogether. > > Signed-off-by: Damien Riegel <damien.riegel@savoirfairelinux.com> Reviewed-by: Bjorn Andersson <bjorn.andersson@linaro.org> Let's introduce them back into the db410c when we define a client. Regards, Bjorn -- To unsubscribe from this list: send the line "unsubscribe linux-arm-msm" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
diff --git a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi index 10fc1fc90682..21f144c55638 100644 --- a/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi +++ b/arch/arm64/boot/dts/qcom/msm8916-pins.dtsi @@ -505,32 +505,6 @@ }; }; - ext-codec-lines { - ext_codec_lines_act: lines_on { - pinmux { - function = "gpio"; - pins = "gpio67"; - }; - pinconf { - pins = "gpio67"; - drive-strength = <8>; - bias-disable; - output-high; - }; - }; - ext_codec_lines_sus: lines_off { - pinmux { - function = "gpio"; - pins = "gpio67"; - }; - pinconf { - pins = "gpio67"; - drive-strength = <2>; - bias-disable; - }; - }; - }; - cdc-pdm-lines { cdc_pdm_lines_act: pdm_lines_on { pinmux { @@ -703,32 +677,6 @@ }; }; - cross-conn-det { - cross_conn_det_act: lines_on { - pinmux { - function = "gpio"; - pins = "gpio120"; - }; - pinconf { - pins = "gpio120"; - drive-strength = <8>; - output-low; - bias-pull-down; - }; - }; - cross_conn_det_sus: lines_off { - pinmux { - function = "gpio"; - pins = "gpio120"; - }; - pinconf { - pins = "gpio120"; - drive-strength = <2>; - bias-disable; - }; - }; - }; - wcnss_pin_a: wcnss-active { pinmux { pins = "gpio40", "gpio41", "gpio42", "gpio43", "gpio44";
These nodes reserve and configure some pins as GPIOs. They are not generic pinctrls, they actually belong to board files but they are not used by any other node, so just drop them altogether. Signed-off-by: Damien Riegel <damien.riegel@savoirfairelinux.com> --- arch/arm64/boot/dts/qcom/msm8916-pins.dtsi | 52 ------------------------------ 1 file changed, 52 deletions(-)