| Message ID | 20181122125047.725-1-bgodavar@codeaurora.org (mailing list archive) |
|---|---|
| State | Not Applicable, archived |
| Headers | show |
| Series | [v1] Bluetooth: hci_serdev: Remove setting of HCI_QUIRK_RESET_ON_CLOSE. | expand |
Hi Balakrishna, > HCI_QUIRK_RESET_ON_CLOSE quirk is required for BT v1.0 based devices, > to send a reset command to the chip during hci device close. Serdev > architecture is used for the latest BT chips, which doesn't require to > send the reset command during close. If still chips required reset > command during close, it would be better enabling it in the vendor > probes or in proto setup. > > Signed-off-by: Balakrishna Godavarthi <bgodavar@codeaurora.org> > --- > drivers/bluetooth/hci_serdev.c | 3 --- > 1 file changed, 3 deletions(-) patch has been applied to bluetooth-next tree. Regards Marcel
diff --git a/drivers/bluetooth/hci_serdev.c b/drivers/bluetooth/hci_serdev.c index c445aa9ac511..490abba94363 100644 --- a/drivers/bluetooth/hci_serdev.c +++ b/drivers/bluetooth/hci_serdev.c @@ -333,9 +333,6 @@ int hci_uart_register_device(struct hci_uart *hu, if (test_bit(HCI_UART_EXT_CONFIG, &hu->hdev_flags)) set_bit(HCI_QUIRK_EXTERNAL_CONFIG, &hdev->quirks); - if (!test_bit(HCI_UART_RESET_ON_INIT, &hu->hdev_flags)) - set_bit(HCI_QUIRK_RESET_ON_CLOSE, &hdev->quirks); - if (test_bit(HCI_UART_CREATE_AMP, &hu->hdev_flags)) hdev->dev_type = HCI_AMP; else
HCI_QUIRK_RESET_ON_CLOSE quirk is required for BT v1.0 based devices, to send a reset command to the chip during hci device close. Serdev architecture is used for the latest BT chips, which doesn't require to send the reset command during close. If still chips required reset command during close, it would be better enabling it in the vendor probes or in proto setup. Signed-off-by: Balakrishna Godavarthi <bgodavar@codeaurora.org> --- drivers/bluetooth/hci_serdev.c | 3 --- 1 file changed, 3 deletions(-)