@@ -9,6 +9,7 @@
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/regulator/qcom,rpmh-regulator.h>
+#include <dt-bindings/pinctrl/qcom,pmic-gpio.h>
#include "sc7180.dtsi"
#include "pm6150.dtsi"
#include "pm6150l.dtsi"
@@ -287,6 +288,57 @@ vreg_bob: bob {
};
};
+&dsi0 {
+ status = "okay";
+
+ vdda-supply = <&vreg_l3c_1p2>;
+
+ panel@0 {
+ compatible = "visionox,rm69299-1080p-display";
+ reg = <0>;
+
+ vdda-supply = <&vreg_l8c_1p8>;
+ vdd3p3-supply = <&vreg_l18a_2p8>;
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&disp_pins>;
+
+ reset-gpios = <&pm6150l_gpio 3 GPIO_ACTIVE_HIGH>;
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ port@0 {
+ reg = <0>;
+ panel0_in: endpoint {
+ remote-endpoint = <&dsi0_out>;
+ };
+ };
+ };
+ };
+
+ ports {
+ port@1 {
+ endpoint {
+ remote-endpoint = <&panel0_in>;
+ data-lanes = <0 1 2 3>;
+ };
+ };
+ };
+};
+
+&dsi_phy {
+ status = "okay";
+};
+
+&mdp {
+ status = "okay";
+};
+
+&mdss {
+ status = "okay";
+};
+
&qspi {
status = "okay";
pinctrl-names = "default";
@@ -402,6 +454,19 @@ wifi-firmware {
/* PINCTRL - additions to nodes defined in sc7180.dtsi */
+&pm6150l_gpio {
+ disp_pins: disp-pins {
+ pinconf {
+ pins = "gpio3";
+ function = PMIC_GPIO_FUNC_FUNC1;
+ qcom,drive-strength = <PMIC_GPIO_STRENGTH_MED>;
+ power-source = <0>;
+ bias-disable;
+ output-low;
+ };
+ };
+};
+
&qspi_clk {
pinconf {
pins = "gpio63";
Add nodes for IDP display. The display is Visionox RM69299. Signed-off-by: Harigovindan P <harigovi@codeaurora.org> --- Changes in v2: - Adding dependency patchwork series - Removing suspend configuration - Adding blank before space curly brace Changes in v3: - Updating status for mdp and mdss node to get the display working - Change in commit text Changes in v4: - Added pinconf subnode - Using macros for function and drive-strength arch/arm64/boot/dts/qcom/sc7180-idp.dts | 65 +++++++++++++++++++++++++ 1 file changed, 65 insertions(+)