| Message ID | 20210303033106.549-3-shawn.guo@linaro.org (mailing list archive) |
|---|---|
| State | Accepted |
| Commit | dca9464b366c225123086406e9bad2d67d1d208d |
| Headers | show |
| Series | Fix number of pins in 'gpio-ranges' | expand |
diff --git a/arch/arm64/boot/dts/qcom/sm8150.dtsi b/arch/arm64/boot/dts/qcom/sm8150.dtsi index e5bb17bc2f46..778613d3410b 100644 --- a/arch/arm64/boot/dts/qcom/sm8150.dtsi +++ b/arch/arm64/boot/dts/qcom/sm8150.dtsi @@ -914,7 +914,7 @@ <0x0 0x03D00000 0x0 0x300000>; reg-names = "west", "east", "north", "south"; interrupts = <GIC_SPI 208 IRQ_TYPE_LEVEL_HIGH>; - gpio-ranges = <&tlmm 0 0 175>; + gpio-ranges = <&tlmm 0 0 176>; gpio-controller; #gpio-cells = <2>; interrupt-controller;
The last cell of 'gpio-ranges' should be number of GPIO pins, and in case of qcom platform it should match msm_pinctrl_soc_data.ngpio rather than msm_pinctrl_soc_data.ngpio - 1. This fixes the problem that when the last GPIO pin in the range is configured with the following call sequence, it always fails with -EPROBE_DEFER. pinctrl_gpio_set_config() pinctrl_get_device_gpio_range() pinctrl_match_gpio_range() Fixes: e13c6d144fa0 ("arm64: dts: qcom: sm8150: Add base dts file") Cc: Vinod Koul <vkoul@kernel.org> Signed-off-by: Shawn Guo <shawn.guo@linaro.org> --- arch/arm64/boot/dts/qcom/sm8150.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)