@@ -445,6 +445,30 @@ opp-384000000 {
};
};
+ qupv3_id_1: geniqup@9c0000 {
+ compatible = "qcom,geni-se-qup";
+ reg = <0x0 0x9c0000 0x0 0x2000>;
+ clock-names = "m-ahb", "s-ahb";
+ clocks = <&gcc GCC_QUPV3_WRAP_1_M_AHB_CLK>,
+ <&gcc GCC_QUPV3_WRAP_1_S_AHB_CLK>;
+ #address-cells = <2>;
+ #size-cells = <2>;
+ iommus = <&apps_smmu 0x4c3 0x0>;
+ ranges;
+ status = "disabled";
+
+ uart2: serial@98c000 {
+ compatible = "qcom,geni-debug-uart";
+ reg = <0 0x98c000 0 0x4000>;
+ clock-names = "se";
+ clocks = <&gcc GCC_QUPV3_WRAP1_S3_CLK>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&qup_uart2_default>;
+ interrupts = <GIC_SPI 356 IRQ_TYPE_LEVEL_HIGH>;
+ status = "disabled";
+ };
+ };
+
tcsr_mutex: hwlock@1f40000 {
compatible = "qcom,tcsr-mutex";
reg = <0x0 0x01f40000 0x0 0x40000>;
@@ -672,6 +696,13 @@ tlmm: pinctrl@f100000 {
interrupt-controller;
#interrupt-cells = <2>;
gpio-ranges = <&tlmm 0 0 157>;
+
+ qup_uart2_default: qup-uart2-default {
+ pins = "gpio25", "gpio26";
+ function = "qup13_f2";
+ drive-strength = <2>;
+ bias-disable;
+ };
};
apps_smmu: iommu@15000000 {
Add the necessary nodes for the debug uart on SM6350. Signed-off-by: Luca Weiss <luca@z3ntu.xyz> --- v2: remove mux{} from pinctrl node, add drive-strength & bias-disable arch/arm64/boot/dts/qcom/sm6350.dtsi | 31 ++++++++++++++++++++++++++++ 1 file changed, 31 insertions(+)