@@ -91,6 +91,14 @@ vph_pwr: vph-pwr-regulator {
regulator-boot-on;
};
+ extcon_usb: extcon-usb {
+ compatible = "linux,extcon-usb-gpio";
+ id-gpio = <&tlmm 38 GPIO_ACTIVE_HIGH>;
+ vbus-gpio = <&tlmm 128 GPIO_ACTIVE_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&usb_extcon_active &usb_vbus_active>;
+ };
+
gpio-keys {
compatible = "gpio-keys";
label = "Side buttons";
@@ -644,6 +652,13 @@ cam1_vdig_default: cam1-vdig-default {
drive-strength = <2>;
};
+ usb_extcon_active: usb-extcon-active {
+ pins = "gpio38";
+ function = "gpio";
+ bias-disable;
+ drive-strength = <16>;
+ };
+
hall_sensor0_default: acc-cover-open {
pins = "gpio124";
function = "gpio";
@@ -659,6 +674,14 @@ ts_int_n: ts-int-n {
bias-pull-up;
};
+ usb_vbus_active: usb-vbus-active {
+ pins = "gpio128";
+ function = "gpio";
+ bias-disable;
+ drive-strength = <2>;
+ output-low;
+ };
+
ts_vddio_en: ts-vddio-en-default {
pins = "gpio133";
function = "gpio";
@@ -689,6 +712,7 @@ &usb3 {
&usb3_dwc3 {
/* Force to peripheral until we have Type-C hooked up */
dr_mode = "peripheral";
+ extcon = <&extcon_usb>;
};
&usb3phy {
While not strictly necessary, at least on maple, configure the USB extcon, which requires two pins on Yoshino. Signed-off-by: Konrad Dybcio <konrad.dybcio@somainline.org> --- .../dts/qcom/msm8998-sony-xperia-yoshino.dtsi | 24 +++++++++++++++++++ 1 file changed, 24 insertions(+)