diff mbox series

[2/3] ARM: dts: qcom: pm8841: Add thermal zone config

Message ID 20230529221501.43455-3-matti.lehtimaki@gmail.com (mailing list archive)
State Accepted
Commit 84e72ea467db83043858b48fcd97de4c9e68881a
Headers show
Series Thermal zones for pm8226, pm8841 and pm8941 | expand

Commit Message

Matti Lehtimäki May 29, 2023, 10:15 p.m. UTC 
Add thermal zone for the PMIC thermal sensor. Temperatures are based on
downstream values, except for critical trip point where 140°C is used
instead of 145°C due to limitations without a configured ADC.

Signed-off-by: Matti Lehtimäki <matti.lehtimaki@gmail.com>
---
 arch/arm/boot/dts/qcom-pm8841.dtsi | 33 +++++++++++++++++++++++++++++-
 1 file changed, 32 insertions(+), 1 deletion(-)
diff mbox series

Patch

diff --git a/arch/arm/boot/dts/qcom-pm8841.dtsi b/arch/arm/boot/dts/qcom-pm8841.dtsi
index b5cdde034d18..3bf2ce5c86a6 100644
--- a/arch/arm/boot/dts/qcom-pm8841.dtsi
+++ b/arch/arm/boot/dts/qcom-pm8841.dtsi
@@ -2,6 +2,37 @@ 
 #include <dt-bindings/interrupt-controller/irq.h>
 #include <dt-bindings/spmi/spmi.h>
 
+
+/ {
+	thermal-zones {
+		pm8841-thermal {
+			polling-delay-passive = <100>;
+			polling-delay = <0>;
+			thermal-sensors = <&pm8841_temp>;
+
+			trips {
+				trip0 {
+					temperature = <105000>;
+					hysteresis = <2000>;
+					type = "passive";
+				};
+
+				trip1 {
+					temperature = <125000>;
+					hysteresis = <2000>;
+					type = "hot";
+				};
+
+				crit {
+					temperature = <140000>;
+					hysteresis = <2000>;
+					type = "critical";
+				};
+			};
+		};
+	};
+};
+
 &spmi_bus {
 
 	pm8841_0: pm8841@4 {
@@ -20,7 +51,7 @@  pm8841_mpps: mpps@a000 {
 			#interrupt-cells = <2>;
 		};
 
-		temp-alarm@2400 {
+		pm8841_temp: temp-alarm@2400 {
 			compatible = "qcom,spmi-temp-alarm";
 			reg = <0x2400>;
 			interrupts = <4 0x24 0 IRQ_TYPE_EDGE_RISING>;