diff mbox series

[3/3] phy: qcom: edp: Allow PHY mode configuration via devicetree

Message ID 20231219-x1e80100-phy-edp-compatible-refactor-v1-3-f9e77752953d@linaro.org (mailing list archive)
State Not Applicable
Headers show
Series phy: qcom: edp: Add support for DT phy mode configuration | expand

Commit Message

Abel Vesa Dec. 19, 2023, 8:55 p.m. UTC 
Future platforms should not use different compatibles to differentiate
between eDP and DP mode. Instead, they should use a single compatible as
the IP block is the same, and use the 'phys' (controller) DT property
to pass the phy mode. Rework the device match config data so that it
only keeps the different knobs rather than swing and pre-emphasis tables.

The existing platforms will remain with separate compatibles for each mode.

Signed-off-by: Abel Vesa <abel.vesa@linaro.org>
---
 drivers/phy/qualcomm/phy-qcom-edp.c | 89 ++++++++++++++++++++++++++++---------
 1 file changed, 67 insertions(+), 22 deletions(-)
diff mbox series

Patch

diff --git a/drivers/phy/qualcomm/phy-qcom-edp.c b/drivers/phy/qualcomm/phy-qcom-edp.c
index 8e5078304646..c70e6eae16ba 100644
--- a/drivers/phy/qualcomm/phy-qcom-edp.c
+++ b/drivers/phy/qualcomm/phy-qcom-edp.c
@@ -68,19 +68,22 @@ 
 
 #define TXn_TRAN_DRVR_EMP_EN                    0x0078
 
-struct qcom_edp_cfg {
-	bool is_dp;
-
-	/* DP PHY swing and pre_emphasis tables */
+struct qcom_edp_swing_pre_emph_cfg {
 	const u8 (*swing_hbr_rbr)[4][4];
 	const u8 (*swing_hbr3_hbr2)[4][4];
 	const u8 (*pre_emphasis_hbr_rbr)[4][4];
 	const u8 (*pre_emphasis_hbr3_hbr2)[4][4];
 };
 
+struct qcom_edp_phy_cfg {
+	int type;
+	bool needs_swing_pre_emph_cfg;
+};
+
 struct qcom_edp {
 	struct device *dev;
-	const struct qcom_edp_cfg *cfg;
+	const struct qcom_edp_phy_cfg *cfg;
+	const struct qcom_edp_swing_pre_emph_cfg *swing_pre_emph_cfg;
 
 	struct phy *phy;
 
@@ -96,6 +99,8 @@  struct qcom_edp {
 
 	struct clk_bulk_data clks[2];
 	struct regulator_bulk_data supplies[2];
+
+	bool is_dp;
 };
 
 static const u8 dp_swing_hbr_rbr[4][4] = {
@@ -126,8 +131,7 @@  static const u8 dp_pre_emp_hbr2_hbr3[4][4] = {
 	{ 0x04, 0xff, 0xff, 0xff }
 };
 
-static const struct qcom_edp_cfg dp_phy_cfg = {
-	.is_dp = true,
+static const struct qcom_edp_swing_pre_emph_cfg dp_phy_swing_pre_emph_cfg = {
 	.swing_hbr_rbr = &dp_swing_hbr_rbr,
 	.swing_hbr3_hbr2 = &dp_swing_hbr2_hbr3,
 	.pre_emphasis_hbr_rbr = &dp_pre_emp_hbr_rbr,
@@ -162,18 +166,30 @@  static const u8 edp_pre_emp_hbr2_hbr3[4][4] = {
 	{ 0x00, 0xff, 0xff, 0xff }
 };
 
-static const struct qcom_edp_cfg edp_phy_cfg = {
-	.is_dp = false,
+static const struct qcom_edp_swing_pre_emph_cfg edp_phy_swing_pre_emph_cfg = {
 	.swing_hbr_rbr = &edp_swing_hbr_rbr,
 	.swing_hbr3_hbr2 = &edp_swing_hbr2_hbr3,
 	.pre_emphasis_hbr_rbr = &edp_pre_emp_hbr_rbr,
 	.pre_emphasis_hbr3_hbr2 = &edp_pre_emp_hbr2_hbr3,
 };
 
+static struct qcom_edp_phy_cfg sc7280_dp_phy_cfg = {
+	.type = PHY_TYPE_DP,
+};
+
+static struct qcom_edp_phy_cfg sc8280xp_dp_phy_cfg = {
+	.type = PHY_TYPE_DP,
+	.needs_swing_pre_emph_cfg = true,
+};
+
+static struct qcom_edp_phy_cfg sc8280xp_edp_phy_cfg = {
+	.type = PHY_TYPE_EDP,
+	.needs_swing_pre_emph_cfg = true,
+};
+
 static int qcom_edp_phy_init(struct phy *phy)
 {
 	struct qcom_edp *edp = phy_get_drvdata(phy);
-	const struct qcom_edp_cfg *cfg = edp->cfg;
 	int ret;
 	u8 cfg8;
 
@@ -200,7 +216,7 @@  static int qcom_edp_phy_init(struct phy *phy)
 	       DP_PHY_PD_CTL_PLL_PWRDN | DP_PHY_PD_CTL_DP_CLAMP_EN,
 	       edp->edp + DP_PHY_PD_CTL);
 
-	if (cfg && cfg->is_dp)
+	if (edp->cfg->needs_swing_pre_emph_cfg && edp->is_dp)
 		cfg8 = 0xb7;
 	else
 		cfg8 = 0x37;
@@ -234,7 +250,7 @@  static int qcom_edp_phy_init(struct phy *phy)
 
 static int qcom_edp_set_voltages(struct qcom_edp *edp, const struct phy_configure_opts_dp *dp_opts)
 {
-	const struct qcom_edp_cfg *cfg = edp->cfg;
+	const struct qcom_edp_swing_pre_emph_cfg *cfg = edp->swing_pre_emph_cfg;
 	unsigned int v_level = 0;
 	unsigned int p_level = 0;
 	u8 ldo_config;
@@ -242,7 +258,7 @@  static int qcom_edp_set_voltages(struct qcom_edp *edp, const struct phy_configur
 	u8 emph;
 	int i;
 
-	if (!cfg)
+	if (!edp->cfg->needs_swing_pre_emph_cfg)
 		return 0;
 
 	for (i = 0; i < dp_opts->lanes; i++) {
@@ -261,7 +277,7 @@  static int qcom_edp_set_voltages(struct qcom_edp *edp, const struct phy_configur
 	if (swing == 0xff || emph == 0xff)
 		return -EINVAL;
 
-	ldo_config = (cfg && cfg->is_dp) ? 0x1 : 0x0;
+	ldo_config = edp->is_dp ? 0x1 : 0x0;
 
 	writel(ldo_config, edp->tx0 + TXn_LDO_CONFIG);
 	writel(swing, edp->tx0 + TXn_TX_DRV_LVL);
@@ -447,10 +463,9 @@  static int qcom_edp_set_vco_div(const struct qcom_edp *edp, unsigned long *pixel
 static int qcom_edp_phy_power_on(struct phy *phy)
 {
 	const struct qcom_edp *edp = phy_get_drvdata(phy);
-	const struct qcom_edp_cfg *cfg = edp->cfg;
 	u32 bias0_en, drvr0_en, bias1_en, drvr1_en;
 	unsigned long pixel_freq;
-	u8 ldo_config;
+	u8 ldo_config = 0x0;
 	int timeout;
 	int ret;
 	u32 val;
@@ -468,7 +483,8 @@  static int qcom_edp_phy_power_on(struct phy *phy)
 		return timeout;
 
 
-	ldo_config = (cfg && cfg->is_dp) ? 0x1 : 0x0;
+	if (edp->cfg->needs_swing_pre_emph_cfg && edp->is_dp)
+		ldo_config = 0x1;
 
 	writel(ldo_config, edp->tx0 + TXn_LDO_CONFIG);
 	writel(ldo_config, edp->tx1 + TXn_LDO_CONFIG);
@@ -768,6 +784,33 @@  static int qcom_edp_clks_register(struct qcom_edp *edp, struct device_node *np)
 	return devm_of_clk_add_hw_provider(edp->dev, of_clk_hw_onecell_get, data);
 }
 
+static struct phy *qcom_edp_phy_xlate(struct device *dev,
+				      struct of_phandle_args *args)
+{
+	struct qcom_edp *edp = dev_get_drvdata(dev);
+	int type = edp->cfg->type;
+
+	if (args->args_count == 1)
+		type = args->args[0];
+
+	if (type != PHY_TYPE_DP && type != PHY_TYPE_EDP)
+		return ERR_PTR(-EINVAL);
+
+	if (type == PHY_TYPE_EDP) {
+		edp->phy->attrs.mode = PHY_MODE_EDP;
+	} else {
+		edp->phy->attrs.mode = PHY_MODE_DP;
+		edp->is_dp = true;
+	}
+
+	if (edp->cfg->needs_swing_pre_emph_cfg)
+		edp->swing_pre_emph_cfg = edp->is_dp ?
+						&dp_phy_swing_pre_emph_cfg:
+						&edp_phy_swing_pre_emph_cfg;
+
+	return edp->phy;
+}
+
 static int qcom_edp_phy_probe(struct platform_device *pdev)
 {
 	struct phy_provider *phy_provider;
@@ -832,17 +875,19 @@  static int qcom_edp_phy_probe(struct platform_device *pdev)
 		return PTR_ERR(edp->phy);
 	}
 
+	dev_set_drvdata(edp->dev, edp);
 	phy_set_drvdata(edp->phy, edp);
 
-	phy_provider = devm_of_phy_provider_register(dev, of_phy_simple_xlate);
+	phy_provider = devm_of_phy_provider_register(dev, qcom_edp_phy_xlate);
+
 	return PTR_ERR_OR_ZERO(phy_provider);
 }
 
 static const struct of_device_id qcom_edp_phy_match_table[] = {
-	{ .compatible = "qcom,sc7280-edp-phy" },
-	{ .compatible = "qcom,sc8180x-edp-phy" },
-	{ .compatible = "qcom,sc8280xp-dp-phy", .data = &dp_phy_cfg },
-	{ .compatible = "qcom,sc8280xp-edp-phy", .data = &edp_phy_cfg },
+	{ .compatible = "qcom,sc7280-edp-phy" , .data = &sc7280_dp_phy_cfg, },
+	{ .compatible = "qcom,sc8180x-edp-phy", .data = &sc7280_dp_phy_cfg, },
+	{ .compatible = "qcom,sc8280xp-dp-phy", .data = &sc8280xp_dp_phy_cfg, },
+	{ .compatible = "qcom,sc8280xp-edp-phy", .data = &sc8280xp_edp_phy_cfg, },
 	{ }
 };
 MODULE_DEVICE_TABLE(of, qcom_edp_phy_match_table);