@@ -151,10 +151,10 @@ static inline void ufs_qcom_assert_reset(struct ufs_hba *hba)
ufshcd_rmwl(hba, UFS_PHY_SOFT_RESET, UFS_PHY_SOFT_RESET, REG_UFS_CFG1);
/*
- * Make sure assertion of ufs phy reset is written to
- * register before returning
+ * Dummy read to ensure the write takes effect before doing any sort
+ * of delay
*/
- mb();
+ ufshcd_readl(hba, REG_UFS_CFG1);
}
static inline void ufs_qcom_deassert_reset(struct ufs_hba *hba)
@@ -162,10 +162,10 @@ static inline void ufs_qcom_deassert_reset(struct ufs_hba *hba)
ufshcd_rmwl(hba, UFS_PHY_SOFT_RESET, 0, REG_UFS_CFG1);
/*
- * Make sure de-assertion of ufs phy reset is written to
- * register before returning
+ * Dummy read to ensure the write takes effect before doing any sort
+ * of delay
*/
- mb();
+ ufshcd_readl(hba, REG_UFS_CFG1);
}
/* Host controller hardware version: major.minor.step */
Currently, the reset bit for the UFS provided reset controller (used by its phy) is written to, and then a mb() happens to try and ensure that hit the device. Immediately afterwards a usleep_range() occurs. mb() ensure that the write completes, but completion doesn't mean that it isn't stored in a buffer somewhere. The recommendation for ensuring this bit has taken effect on the device is to perform a read back to force it to make it all the way to the device. This is documented in device-io.rst and a talk by Will Deacon on this can be seen over here: https://youtu.be/i6DayghhA8Q?si=MiyxB5cKJXSaoc01&t=1678 Let's do that to ensure the bit hits the device. By doing so and guaranteeing the ordering against the immediately following usleep_range(), the mb() can safely be removed. Fixes: 81c0fc51b7a7 ("ufs-qcom: add support for Qualcomm Technologies Inc platforms") Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org> Reviewed-by: Can Guo <quic_cang@quicinc.com> Signed-off-by: Andrew Halaney <ahalaney@redhat.com> --- drivers/ufs/host/ufs-qcom.h | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-)