@@ -24,6 +24,28 @@ chosen {
stdout-path = "serial0";
};
+ battery: battery {
+ compatible = "simple-battery";
+ device-chemistry = "lithium-ion-polymer";
+ voltage-min-design-microvolt = <3700000>;
+ voltage-max-design-microvolt = <4200000>;
+ energy-full-design-microwatt-hours = <13690000>;
+ charge-full-design-microamp-hours = <3700000>;
+
+ ocv-capacity-celsius = <25>;
+ ocv-capacity-table-0 =
+ <4186000 100>, <4126000 95>, <4078000 90>,
+ <4036000 85>, <3997000 80>, <3962000 75>,
+ <3932000 70>, <3904000 65>, <3874000 60>,
+ <3839000 55>, <3809000 50>, <3792000 45>,
+ <3780000 40>, <3772000 35>, <3764000 30>,
+ <3752000 25>, <3731000 20>, <3704000 16>,
+ <3677000 13>, <3670000 11>, <3668000 10>,
+ <3666000 9>, <3662000 8>, <3658000 7>, <3648000 6>,
+ <3624000 5>, <3580000 4>, <3518000 3>, <3434000 2>,
+ <3310000 1>, <3000000 0>;
+ };
+
flash-led-controller {
/* Actually qcom,leds-gpio-flash */
compatible = "sgmicro,sgm3140";
@@ -116,6 +138,11 @@ &mpss_mem {
reg = <0x0 0x86800000 0x0 0x5000000>;
};
+&pm8916_bms {
+ monitored-battery = <&battery>;
+ status = "okay";
+};
+
&pm8916_codec {
qcom,micbias-lvl = <2800>;
qcom,mbhc-vthreshold-low = <150 180 237 450 500>;
There is PM8916 Battery voltage monitor on GPLUS FL8005A. Add PM8916 BMS and the battery to the device tree. Signed-off-by: "Lin, Meng-Bo" <linmengbo06890@proton.me> --- .../boot/dts/qcom/msm8916-gplus-fl8005a.dts | 27 +++++++++++++++++++ 1 file changed, 27 insertions(+)