@@ -193,12 +193,12 @@ static void dpu_encoder_phys_wb_setup_fb(struct dpu_encoder_phys *phys_enc,
hw_wb->ops.setup_roi(hw_wb, wb_cfg);
if (hw_wb->ops.setup_outformat)
- hw_wb->ops.setup_outformat(hw_wb, wb_cfg);
+ hw_wb->ops.setup_outformat(hw_wb, wb_cfg, msm_framebuffer_format(fb));
if (hw_wb->ops.setup_cdp) {
const struct dpu_perf_cfg *perf = phys_enc->dpu_kms->catalog->perf;
- hw_wb->ops.setup_cdp(hw_wb, wb_cfg->dest.format,
+ hw_wb->ops.setup_cdp(hw_wb, msm_framebuffer_format(fb),
perf->cdp_cfg[DPU_PERF_CDP_USAGE_NRT].wr_enable);
}
@@ -584,14 +584,6 @@ static void dpu_encoder_phys_wb_prepare_wb_job(struct dpu_encoder_phys *phys_enc
format = msm_framebuffer_format(job->fb);
- wb_cfg->dest.format = mdp_get_format(&phys_enc->dpu_kms->base,
- format->pixel_format, job->fb->modifier);
- if (!wb_cfg->dest.format) {
- /* this error should be detected during atomic_check */
- DPU_ERROR("failed to get format %p4cc\n", &format->pixel_format);
- return;
- }
-
ret = dpu_format_populate_layout(aspace, job->fb, &wb_cfg->dest);
if (ret) {
DPU_DEBUG("failed to populate layout %d\n", ret);
@@ -600,10 +592,10 @@ static void dpu_encoder_phys_wb_prepare_wb_job(struct dpu_encoder_phys *phys_enc
wb_cfg->dest.width = job->fb->width;
wb_cfg->dest.height = job->fb->height;
- wb_cfg->dest.num_planes = wb_cfg->dest.format->num_planes;
+ wb_cfg->dest.num_planes = format->num_planes;
- if ((wb_cfg->dest.format->fetch_type == MDP_PLANE_PLANAR) &&
- (wb_cfg->dest.format->element[0] == C1_B_Cb))
+ if ((format->fetch_type == MDP_PLANE_PLANAR) &&
+ (format->element[0] == C1_B_Cb))
swap(wb_cfg->dest.plane_addr[1], wb_cfg->dest.plane_addr[2]);
DPU_DEBUG("[fb_offset:%8.8x,%8.8x,%8.8x,%8.8x]\n",
@@ -104,7 +104,6 @@ static int _dpu_format_get_plane_sizes_ubwc(
bool meta = MSM_FORMAT_IS_UBWC(fmt);
memset(layout, 0, sizeof(struct dpu_hw_fmt_layout));
- layout->format = fmt;
layout->width = width;
layout->height = height;
layout->num_planes = fmt->num_planes;
@@ -116,7 +115,7 @@ static int _dpu_format_get_plane_sizes_ubwc(
return -EINVAL;
}
- if (MSM_FORMAT_IS_YUV(layout->format)) {
+ if (MSM_FORMAT_IS_YUV(fmt)) {
uint32_t y_sclines, uv_sclines;
uint32_t y_meta_scanlines = 0;
uint32_t uv_meta_scanlines = 0;
@@ -182,7 +181,6 @@ static int _dpu_format_get_plane_sizes_linear(
int i;
memset(layout, 0, sizeof(struct dpu_hw_fmt_layout));
- layout->format = fmt;
layout->width = width;
layout->height = height;
layout->num_planes = fmt->num_planes;
@@ -190,8 +188,8 @@ static int _dpu_format_get_plane_sizes_linear(
/* Due to memset above, only need to set planes of interest */
if (fmt->fetch_type == MDP_PLANE_INTERLEAVED) {
layout->num_planes = 1;
- layout->plane_size[0] = width * height * layout->format->bpp;
- layout->plane_pitch[0] = width * layout->format->bpp;
+ layout->plane_size[0] = width * height * fmt->bpp;
+ layout->plane_pitch[0] = width * fmt->bpp;
} else {
uint32_t v_subsample, h_subsample;
uint32_t chroma_samp;
@@ -272,6 +270,7 @@ static int _dpu_format_populate_addrs_ubwc(
struct drm_framebuffer *fb,
struct dpu_hw_fmt_layout *layout)
{
+ const struct msm_format *fmt;
uint32_t base_addr = 0;
bool meta;
@@ -286,10 +285,11 @@ static int _dpu_format_populate_addrs_ubwc(
return -EFAULT;
}
- meta = MSM_FORMAT_IS_UBWC(layout->format);
+ fmt = msm_framebuffer_format(fb);
+ meta = MSM_FORMAT_IS_UBWC(fmt);
/* Per-format logic for verifying active planes */
- if (MSM_FORMAT_IS_YUV(layout->format)) {
+ if (MSM_FORMAT_IS_YUV(fmt)) {
/************************************************/
/* UBWC ** */
/* buffer ** DPU PLANE */
@@ -390,6 +390,7 @@ int dpu_format_populate_layout(
struct drm_framebuffer *fb,
struct dpu_hw_fmt_layout *layout)
{
+ const struct msm_format *fmt;
int ret;
if (!fb || !layout) {
@@ -403,17 +404,17 @@ int dpu_format_populate_layout(
return -ERANGE;
}
- layout->format = msm_framebuffer_format(fb);
+ fmt = msm_framebuffer_format(fb);
/* Populate the plane sizes etc via get_format */
- ret = dpu_format_get_plane_sizes(layout->format, fb->width, fb->height,
+ ret = dpu_format_get_plane_sizes(fmt, fb->width, fb->height,
layout, fb->pitches);
if (ret)
return ret;
/* Populate the addresses given the fb */
- if (MSM_FORMAT_IS_UBWC(layout->format) ||
- MSM_FORMAT_IS_TILE(layout->format))
+ if (MSM_FORMAT_IS_UBWC(fmt) ||
+ MSM_FORMAT_IS_TILE(fmt))
ret = _dpu_format_populate_addrs_ubwc(aspace, fb, layout);
else
ret = _dpu_format_populate_addrs_linear(aspace, fb, layout);
@@ -293,7 +293,6 @@ enum dpu_3d_blend_mode {
/**
* struct dpu_hw_fmt_layout - format information of the source pixel data
- * @format: pixel format parameters
* @num_planes: number of planes (including meta data planes)
* @width: image width
* @height: image height
@@ -303,7 +302,6 @@ enum dpu_3d_blend_mode {
* @plane_pitch: pitch of each plane
*/
struct dpu_hw_fmt_layout {
- const struct msm_format *format;
uint32_t num_planes;
uint32_t width;
uint32_t height;
@@ -64,10 +64,10 @@ static void dpu_hw_wb_setup_outaddress(struct dpu_hw_wb *ctx,
}
static void dpu_hw_wb_setup_format(struct dpu_hw_wb *ctx,
- struct dpu_hw_wb_cfg *data)
+ struct dpu_hw_wb_cfg *data,
+ const struct msm_format *fmt)
{
struct dpu_hw_blk_reg_map *c = &ctx->hw;
- const struct msm_format *fmt = data->dest.format;
u32 dst_format, pattern, ystride0, ystride1, outsize, chroma_samp;
u32 write_config = 0;
u32 opmode = 0;
@@ -37,7 +37,8 @@ struct dpu_hw_wb_ops {
struct dpu_hw_wb_cfg *wb);
void (*setup_outformat)(struct dpu_hw_wb *ctx,
- struct dpu_hw_wb_cfg *wb);
+ struct dpu_hw_wb_cfg *wb,
+ const struct msm_format *fmt);
void (*setup_roi)(struct dpu_hw_wb *ctx,
struct dpu_hw_wb_cfg *wb);
The struct dpu_hw_fmt_layout defines hardware data layout (addresses, sizes and pitches. Drop format field from this structure as it's not a part of the data layout. Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org> --- .../gpu/drm/msm/disp/dpu1/dpu_encoder_phys_wb.c | 18 +++++------------ drivers/gpu/drm/msm/disp/dpu1/dpu_formats.c | 23 +++++++++++----------- drivers/gpu/drm/msm/disp/dpu1/dpu_hw_mdss.h | 2 -- drivers/gpu/drm/msm/disp/dpu1/dpu_hw_wb.c | 4 ++-- drivers/gpu/drm/msm/disp/dpu1/dpu_hw_wb.h | 3 ++- 5 files changed, 21 insertions(+), 29 deletions(-)