@@ -203,6 +203,52 @@ vib_pwm: pwm {
};
};
+&gpu {
+ status = "okay";
+
+ zap-shader {
+ memory-region = <&gpu_mem>;
+ firmware-name = "qcom/sdm845/starqltechn/a630_zap.mbn";
+ };
+};
+
+&mdss {
+ status = "okay";
+};
+
+&mdss_dsi0 {
+ vdda-supply = <&vreg_l26a_1p2>;
+ status = "okay";
+
+ panel@0 {
+ compatible = "samsung,s6e3ha8";
+ reg = <0>;
+ vci-supply = <&s2dos05_ldo4>;
+ vddr-supply = <&s2dos05_buck>;
+ vdd3-supply = <&s2dos05_ldo1>;
+ te-gpios = <&tlmm 10 GPIO_ACTIVE_HIGH>;
+ reset-gpios = <&tlmm 6 GPIO_ACTIVE_HIGH>;
+ pinctrl-0 = <&dsi_default &dsi_te>;
+ pinctrl-1 = <&dsi_suspend &dsi_te>;
+ pinctrl-names = "default", "suspend";
+
+ port {
+ panel_in: endpoint {
+ remote-endpoint = <&mdss_dsi0_out>;
+ };
+ };
+ };
+};
+
+&mdss_dsi0_out {
+ data-lanes = <0 1 2 3>;
+ remote-endpoint = <&panel_in>;
+};
+
+&mdss_dsi0_phy {
+ vdds-supply = <&vdda_mipi_dsi0_pll>;
+ status = "okay";
+};
&apps_rsc {
regulators-0 {
@@ -837,6 +883,27 @@ &tlmm {
gpio-reserved-ranges = <27 4>, /* SPI (eSE - embedded Secure Element) */
<85 4>; /* SPI (fingerprint reader) */
+ dsi_default: dsi-default-state {
+ pins = "gpio6";
+ function = "gpio";
+ drive-strength = <8>;
+ bias-disable;
+ };
+
+ dsi_suspend: dsi-suspend-state {
+ pins = "gpio6";
+ function = "gpio";
+ drive-strength = <2>;
+ bias-pull-down;
+ };
+
+ dsi_te: dsi-te-state {
+ pins = "gpio10";
+ function = "mdp_vsync";
+ drive-strength = <2>;
+ bias-pull-down;
+ };
+
i2c21_sda_state: i2c21-sda-state {
pins = "gpio127";
function = "gpio";
Add support for gpu and panel. Signed-off-by: Dzmitry Sankouski <dsankouski@gmail.com> --- Changes for v6: - refactor: s/starqltechn/sdm845-starqltechn in subject - refactor: remove 'sde' prefix in tlmm dsi nodes - refactor: place tlmm dsi nodes alphabetically Changes for v5: - fix label names --- arch/arm64/boot/dts/qcom/sdm845-samsung-starqltechn.dts | 67 +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 67 insertions(+)