@@ -71,6 +71,7 @@ config ARM_SCMI_DEBUG_COUNTERS
source "drivers/firmware/arm_scmi/transports/Kconfig"
source "drivers/firmware/arm_scmi/vendors/imx/Kconfig"
+source "drivers/firmware/arm_scmi/vendors/qcom/Kconfig"
endif #ARM_SCMI_PROTOCOL
@@ -12,6 +12,7 @@ scmi-module-objs := $(scmi-driver-y) $(scmi-protocols-y) $(scmi-transport-y)
obj-$(CONFIG_ARM_SCMI_PROTOCOL) += transports/
obj-$(CONFIG_ARM_SCMI_PROTOCOL) += vendors/imx/
+obj-$(CONFIG_ARM_SCMI_PROTOCOL) += vendors/qcom/
obj-$(CONFIG_ARM_SCMI_PROTOCOL) += scmi-core.o
obj-$(CONFIG_ARM_SCMI_PROTOCOL) += scmi-module.o
new file mode 100644
@@ -0,0 +1,15 @@
+# SPDX-License-Identifier: GPL-2.0-only
+menu "ARM SCMI QCOM Vendor Protocols"
+
+config QCOM_SCMI_GENERIC_EXT
+ tristate "Qualcomm Technologies, Inc. Qcom SCMI vendor Protocol"
+ depends on ARM_SCMI_PROTOCOL || COMPILE_TEST
+ help
+ The QCOM SCMI vendor protocol provides a generic way of exposing
+ a number of Qualcomm SoC specific features (like memory bus scaling)
+ through a mixture of pre-determined algorithm strings and param_id
+ pairs hosted on the SCMI controller.
+
+ This driver defines/documents the message ID's used for this
+ communication and also exposes the operations used by the clients.
+endmenu
new file mode 100644
@@ -0,0 +1,2 @@
+# SPDX-License-Identifier: GPL-2.0-only
+obj-$(CONFIG_QCOM_SCMI_GENERIC_EXT) += qcom-generic-ext.o
new file mode 100644
@@ -0,0 +1,139 @@
+// SPDX-License-Identifier: GPL-2.0-only
+/*
+ * Copyright (c) 2024, Qualcomm Innovation Center, Inc. All rights reserved.
+ */
+
+#include <linux/scmi_qcom_protocol.h>
+
+#include "../../common.h"
+
+/**
+ * enum qcom_generic_ext_protocol_cmd - vendor specific commands supported by SCMI Qualcomm
+ * generic vendor protocol.
+ *
+ * This protocol is intended as a generic way of exposing a number of Qualcomm SoC
+ * specific features through a mixture of pre-determined algorithm string and param_id
+ * pairs hosted on the SCMI controller.
+ *
+ * The QCOM SCMI Vendor Protocol has the protocol id as 0x80 and vendor id set to
+ * Qualcomm and the implementation version set to 0x20000. The PROTOCOL_VERSION command
+ * returns version 1.0.
+ *
+ * @QCOM_SCMI_SET_PARAM: is used to set the parameter of a specific algo_str hosted on
+ * QCOM SCMI Vendor Protocol. The tx len depends on the algo_str used.
+ * @QCOM_SCMI_GET_PARAM: is used to get parameter information of a specific algo_str
+ * hosted on QCOM SCMI Vendor Protocol. The tx and rx len depends
+ * on the algo_str used.
+ * @QCOM_SCMI_START_ACTIVITY: is used to start the activity performed by the algo_str.
+ * @QCOM_SCMI_STOP_ACTIVITY: is used to stop a pre-existing activity performed by the algo_str.
+ */
+enum qcom_generic_ext_protocol_cmd {
+ QCOM_SCMI_SET_PARAM = 0x10,
+ QCOM_SCMI_GET_PARAM = 0x11,
+ QCOM_SCMI_START_ACTIVITY = 0x12,
+ QCOM_SCMI_STOP_ACTIVITY = 0x13,
+};
+
+/**
+ * struct qcom_scmi_msg - represents the various parameters to be populated
+ * for using the QCOM SCMI Vendor Protocol
+ *
+ * @ext_id: reserved, must be zero
+ * @algo_low: lower 32 bits of the algo_str
+ * @algo_high: upper 32 bits of the algo_str
+ * @param_id: serves as token message id to the specific algo_str
+ * @buf: serves as the payload to the specified param_id and algo_str pair
+ */
+struct qcom_scmi_msg {
+ __le32 ext_id;
+ __le32 algo_low;
+ __le32 algo_high;
+ __le32 param_id;
+ __le32 buf[];
+};
+
+static int qcom_scmi_common_xfer(const struct scmi_protocol_handle *ph,
+ enum qcom_generic_ext_protocol_cmd cmd_id, void *buf,
+ size_t buf_len, u64 algo_str, u32 param_id, size_t rx_size)
+{
+ struct scmi_xfer *t;
+ struct qcom_scmi_msg *msg;
+ int ret;
+
+ ret = ph->xops->xfer_get_init(ph, cmd_id, buf_len + sizeof(*msg), rx_size, &t);
+ if (ret)
+ return ret;
+
+ msg = t->tx.buf;
+ msg->algo_low = cpu_to_le32(lower_32_bits(algo_str));
+ msg->algo_high = cpu_to_le32(upper_32_bits(algo_str));
+ msg->param_id = cpu_to_le32(param_id);
+ memcpy(msg->buf, buf, buf_len);
+
+ ret = ph->xops->do_xfer(ph, t);
+ if (rx_size)
+ memcpy(buf, t->rx.buf, t->rx.len);
+ ph->xops->xfer_put(ph, t);
+
+ return ret;
+}
+
+static int qcom_scmi_set_param(const struct scmi_protocol_handle *ph, void *buf, size_t buf_len,
+ u64 algo_str, u32 param_id)
+{
+ return qcom_scmi_common_xfer(ph, QCOM_SCMI_SET_PARAM, buf, buf_len, algo_str,
+ param_id, 0);
+}
+
+static int qcom_scmi_get_param(const struct scmi_protocol_handle *ph, void *buf, size_t buf_len,
+ u64 algo_str, u32 param_id, size_t rx_size)
+{
+ return qcom_scmi_common_xfer(ph, QCOM_SCMI_GET_PARAM, buf, buf_len, algo_str,
+ param_id, rx_size);
+}
+
+static int qcom_scmi_start_activity(const struct scmi_protocol_handle *ph, void *buf,
+ size_t buf_len, u64 algo_str, u32 param_id)
+{
+ return qcom_scmi_common_xfer(ph, QCOM_SCMI_START_ACTIVITY, buf, buf_len, algo_str,
+ param_id, 0);
+}
+
+static int qcom_scmi_stop_activity(const struct scmi_protocol_handle *ph, void *buf,
+ size_t buf_len, u64 algo_str, u32 param_id)
+{
+ return qcom_scmi_common_xfer(ph, QCOM_SCMI_STOP_ACTIVITY, buf, buf_len, algo_str,
+ param_id, 0);
+}
+
+static struct qcom_generic_ext_ops qcom_proto_ops = {
+ .set_param = qcom_scmi_set_param,
+ .get_param = qcom_scmi_get_param,
+ .start_activity = qcom_scmi_start_activity,
+ .stop_activity = qcom_scmi_stop_activity,
+};
+
+static int qcom_generic_ext_protocol_init(const struct scmi_protocol_handle *ph)
+{
+ u32 version;
+
+ ph->xops->version_get(ph, &version);
+
+ dev_dbg(ph->dev, "QCOM Generic Vendor Version %d.%d\n",
+ PROTOCOL_REV_MAJOR(version), PROTOCOL_REV_MINOR(version));
+
+ return 0;
+}
+
+static const struct scmi_protocol qcom_generic_ext = {
+ .id = SCMI_PROTOCOL_QCOM_GENERIC,
+ .owner = THIS_MODULE,
+ .instance_init = &qcom_generic_ext_protocol_init,
+ .ops = &qcom_proto_ops,
+ .vendor_id = "Qualcomm",
+ .impl_ver = 0x20000,
+};
+module_scmi_protocol(qcom_generic_ext);
+
+MODULE_DESCRIPTION("QCOM SCMI Generic Vendor protocol");
+MODULE_LICENSE("GPL");
new file mode 100644
@@ -0,0 +1,37 @@
+/* SPDX-License-Identifier: GPL-2.0-only */
+/*
+ * SCMI Message Protocol driver QCOM extension header
+ *
+ * Copyright (c) 2024, Qualcomm Innovation Center, Inc. All rights reserved.
+ */
+
+#ifndef _LINUX_SCMI_QCOM_PROTOCOL_H
+#define _LINUX_SCMI_QCOM_PROTOCOL_H
+
+#include <linux/types.h>
+
+#define SCMI_PROTOCOL_QCOM_GENERIC 0x80
+
+struct scmi_protocol_handle;
+
+/**
+ * struct qcom_generic_ext_ops - represents the various operations provided
+ * by QCOM Generic Vendor Protocol
+ *
+ * @set_param: set parameter specified by param_id and algo_str pair.
+ * @get_param: retrieve parameter specified by param_id and algo_str pair.
+ * @start_activity: initiate a specific activity defined by algo_str.
+ * @stop_activity: halt previously initiated activity defined by algo_str.
+ */
+struct qcom_generic_ext_ops {
+ int (*set_param)(const struct scmi_protocol_handle *ph, void *buf, size_t buf_len,
+ u64 algo_str, u32 param_id);
+ int (*get_param)(const struct scmi_protocol_handle *ph, void *buf, size_t buf_len,
+ u64 algo_str, u32 param_id, size_t rx_size);
+ int (*start_activity)(const struct scmi_protocol_handle *ph, void *buf, size_t buf_len,
+ u64 algo_str, u32 param_id);
+ int (*stop_activity)(const struct scmi_protocol_handle *ph, void *buf, size_t buf_len,
+ u64 algo_str, u32 param_id);
+};
+
+#endif /* _LINUX_SCMI_QCOM_PROTOCOL_H */