@@ -2859,7 +2859,12 @@ static int qcom_param_page_type_exec(struct nand_chip *chip, const struct nand_
const struct nand_op_instr *instr = NULL;
unsigned int op_id = 0;
unsigned int len = 0;
- int ret;
+ int ret, reg_base;
+
+ reg_base = NAND_READ_LOCATION_0;
+
+ if (nandc->props->qpic_v2)
+ reg_base = NAND_READ_LOCATION_LAST_CW_0;
ret = qcom_parse_instructions(chip, subop, &q_op);
if (ret)
@@ -2911,7 +2916,10 @@ static int qcom_param_page_type_exec(struct nand_chip *chip, const struct nand_
op_id = q_op.data_instr_idx;
len = nand_subop_get_data_len(subop, op_id);
- nandc_set_read_loc(chip, 0, 0, 0, len, 1);
+ if (nandc->props->qpic_v2)
+ nandc_set_read_loc_last(chip, reg_base, 0, len, 1);
+ else
+ nandc_set_read_loc_first(chip, reg_base, 0, len, 1);
if (!nandc->props->qpic_v2) {
write_reg_dma(nandc, NAND_DEV_CMD_VLD, 1, 0);
For QPIC V2 onwards there is a separate register to read last code word "QPIC_NAND_READ_LOCATION_LAST_CW_n". qcom_param_page_type_exec() is used to read only one code word If it will get configure number of code words to 1 in QPIC_NAND_DEV0_CFG0 register then QPIC controller thinks its reading the last code word, since we are having separate register to read the last code word, we have to configure "QPIC_NAND_READ_LOCATION_LAST_CW_n" register to fetch data from QPIC buffer to system memory. Without this change page read was failing with timeout error / # hexdump -C /dev/mtd1 [ 129.206113] qcom-nandc 1cc8000.nand-controller: failure to read page/oob hexdump: /dev/mtd1: Connection timed out This issue only seen on SDX targets since SDX target used QPICv2. But same working on IPQ targets since IPQ used QPICv1. Cc: stable@vger.kernel.org Fixes: 89550beb098e ("mtd: rawnand: qcom: Implement exec_op()") Signed-off-by: Md Sadre Alam <quic_mdalam@quicinc.com> --- Change in [v2] * Updated commit message * Added stable kernel tag * Replaced the buf_count value of 512 with the len in bytes. Change in [v1] * Resolved the issue with reading a single code word in the parameter page read drivers/mtd/nand/raw/qcom_nandc.c | 12 ++++++++++-- 1 file changed, 10 insertions(+), 2 deletions(-)