[v2,4/4] PCI: qcom: Enable ECAM feature

Commit Message

Krishna Chaitanya Chundru Dec. 24, 2024, 2:10 p.m. UTC

From: Krishna chaitanya chundru <[e-mail]>

The ELBI registers falls after the DBI space, PARF_SLV_DBI_ELBI register
gives us the offset from which ELBI starts. so use this offset and cfg
win to map these regions instead of doing the ioremap again.

On root bus, we have only the root port. Any access other than that
should not go out of the link and should return all F's. Since the iATU
is configured for the buses which starts after root bus, block the
transactions starting from function 1 of the root bus to the end of
the root bus (i.e from dbi_base + 4kb to dbi_base + 1MB) from going
outside the link through ECAM blocker through PARF registers.

Signed-off-by: Krishna Chaitanya Chundru <[e-mail]>
---
 drivers/pci/controller/dwc/pcie-qcom.c | 81 ++++++++++++++++++++++++++++++++--
 1 file changed, 77 insertions(+), 4 deletions(-)

Patch

diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
index dc102d8bd58c..cf94718d3059 100644
--- a/drivers/pci/controller/dwc/pcie-qcom.c
+++ b/drivers/pci/controller/dwc/pcie-qcom.c
@@ -52,6 +52,7 @@ 
 #define PARF_AXI_MSTR_WR_ADDR_HALT_V2		0x1a8
 #define PARF_Q2A_FLUSH				0x1ac
 #define PARF_LTSSM				0x1b0
+#define PARF_SLV_DBI_ELBI			0x1b4
 #define PARF_INT_ALL_STATUS			0x224
 #define PARF_INT_ALL_CLEAR			0x228
 #define PARF_INT_ALL_MASK			0x22c
@@ -61,6 +62,17 @@ 
 #define PARF_DBI_BASE_ADDR_V2_HI		0x354
 #define PARF_SLV_ADDR_SPACE_SIZE_V2		0x358
 #define PARF_SLV_ADDR_SPACE_SIZE_V2_HI		0x35c
+#define PARF_BLOCK_SLV_AXI_WR_BASE		0x360
+#define PARF_BLOCK_SLV_AXI_WR_BASE_HI		0x364
+#define PARF_BLOCK_SLV_AXI_WR_LIMIT		0x368
+#define PARF_BLOCK_SLV_AXI_WR_LIMIT_HI		0x36c
+#define PARF_BLOCK_SLV_AXI_RD_BASE		0x370
+#define PARF_BLOCK_SLV_AXI_RD_BASE_HI		0x374
+#define PARF_BLOCK_SLV_AXI_RD_LIMIT		0x378
+#define PARF_BLOCK_SLV_AXI_RD_LIMIT_HI		0x37c
+#define PARF_ECAM_BASE				0x380
+#define PARF_ECAM_BASE_HI			0x384
+
 #define PARF_NO_SNOOP_OVERIDE			0x3d4
 #define PARF_ATU_BASE_ADDR			0x634
 #define PARF_ATU_BASE_ADDR_HI			0x638
@@ -84,6 +96,7 @@ 
 
 /* PARF_SYS_CTRL register fields */
 #define MAC_PHY_POWERDOWN_IN_P2_D_MUX_EN	BIT(29)
+#define PCIE_ECAM_BLOCKER_EN			BIT(26)
 #define MST_WAKEUP_EN				BIT(13)
 #define SLV_WAKEUP_EN				BIT(12)
 #define MSTR_ACLK_CGC_DIS			BIT(10)
@@ -294,15 +307,60 @@  static void qcom_ep_reset_deassert(struct qcom_pcie *pcie)
 	usleep_range(PERST_DELAY_US, PERST_DELAY_US + 500);
 }
 
+static int qcom_pci_config_ecam(struct dw_pcie_rp *pp)
+{
+	struct dw_pcie *pci = to_dw_pcie_from_pp(pp);
+	struct qcom_pcie *pcie = to_qcom_pcie(pci);
+	u64 addr, addr_end;
+	u32 val;
+
+	/* Set the ECAM base */
+	writel(lower_32_bits(pci->dbi_phys_addr), pcie->parf + PARF_ECAM_BASE);
+	writel(upper_32_bits(pci->dbi_phys_addr), pcie->parf + PARF_ECAM_BASE_HI);
+
+	/*
+	 * The only device on root bus is the Root Port. Any access other than that
+	 * should not go out of the link and should return all F's. Since the iATU
+	 * is configured for the buses which starts after root bus, block the transactions
+	 * starting from function 1 of the root bus to the end of the root bus (i.e from
+	 * dbi_base + 4kb to dbi_base + 1MB) from going outside the link.
+	 */
+	addr = pci->dbi_phys_addr + SZ_4K;
+	writel(lower_32_bits(addr), pcie->parf + PARF_BLOCK_SLV_AXI_WR_BASE);
+	writel(upper_32_bits(addr), pcie->parf + PARF_BLOCK_SLV_AXI_WR_BASE_HI);
+
+	writel(lower_32_bits(addr), pcie->parf + PARF_BLOCK_SLV_AXI_RD_BASE);
+	writel(upper_32_bits(addr), pcie->parf + PARF_BLOCK_SLV_AXI_RD_BASE_HI);
+
+	addr_end = pci->dbi_phys_addr + SZ_1M - 1;
+
+	writel(lower_32_bits(addr_end), pcie->parf + PARF_BLOCK_SLV_AXI_WR_LIMIT);
+	writel(upper_32_bits(addr_end), pcie->parf + PARF_BLOCK_SLV_AXI_WR_LIMIT_HI);
+
+	writel(lower_32_bits(addr_end), pcie->parf + PARF_BLOCK_SLV_AXI_RD_LIMIT);
+	writel(upper_32_bits(addr_end), pcie->parf + PARF_BLOCK_SLV_AXI_RD_LIMIT_HI);
+
+	val = readl(pcie->parf + PARF_SYS_CTRL);
+	val |= PCIE_ECAM_BLOCKER_EN;
+	writel(val, pcie->parf + PARF_SYS_CTRL);
+	return 0;
+}
+
 static int qcom_pcie_start_link(struct dw_pcie *pci)
 {
 	struct qcom_pcie *pcie = to_qcom_pcie(pci);
+	int ret;
 
 	if (pcie_link_speed[pci->max_link_speed] == PCIE_SPEED_16_0GT) {
 		qcom_pcie_common_set_16gt_equalization(pci);
 		qcom_pcie_common_set_16gt_lane_margining(pci);
 	}
 
+	if (pci->pp.ecam_mode) {
+		ret = qcom_pci_config_ecam(&pci->pp);
+		if (ret)
+			return ret;
+	}
 	/* Enable Link Training state machine */
 	if (pcie->cfg->ops->ltssm_enable)
 		pcie->cfg->ops->ltssm_enable(pcie);
@@ -1233,6 +1291,7 @@  static int qcom_pcie_host_init(struct dw_pcie_rp *pp)
 {
 	struct dw_pcie *pci = to_dw_pcie_from_pp(pp);
 	struct qcom_pcie *pcie = to_qcom_pcie(pci);
+	u16 offset;
 	int ret;
 
 	qcom_ep_reset_assert(pcie);
@@ -1241,6 +1300,11 @@  static int qcom_pcie_host_init(struct dw_pcie_rp *pp)
 	if (ret)
 		return ret;
 
+	if (pp->ecam_mode) {
+		offset = readl(pcie->parf + PARF_SLV_DBI_ELBI);
+		pcie->elbi = pci->dbi_base + offset;
+	}
+
 	ret = phy_set_mode_ext(pcie->phy, PHY_MODE_PCIE, PHY_MODE_PCIE_RC);
 	if (ret)
 		goto err_deinit;
@@ -1613,6 +1677,13 @@  static int qcom_pcie_probe(struct platform_device *pdev)
 	pci->ops = &dw_pcie_ops;
 	pp = &pci->pp;
 
+	pp->bridge = devm_pci_alloc_host_bridge(dev, 0);
+	if (!pp->bridge) {
+		ret = -ENOMEM;
+		goto err_pm_runtime_put;
+	}
+
+	pci->pp.ecam_mode = dw_pcie_ecam_supported(pp);
 	pcie->pci = pci;
 
 	pcie->cfg = pcie_cfg;
@@ -1629,10 +1700,12 @@  static int qcom_pcie_probe(struct platform_device *pdev)
 		goto err_pm_runtime_put;
 	}
 
-	pcie->elbi = devm_platform_ioremap_resource_byname(pdev, "elbi");
-	if (IS_ERR(pcie->elbi)) {
-		ret = PTR_ERR(pcie->elbi);
-		goto err_pm_runtime_put;
+	if (!pp->ecam_mode) {
+		pcie->elbi = devm_platform_ioremap_resource_byname(pdev, "elbi");
+		if (IS_ERR(pcie->elbi)) {
+			ret = PTR_ERR(pcie->elbi);
+			goto err_pm_runtime_put;
+		}
 	}
 
 	/* MHI region is optional */