@@ -330,6 +330,11 @@ static void raid1_end_read_request(struct bio *bio)
if (uptodate)
set_bit(R1BIO_Uptodate, &r1_bio->state);
+ else if (test_bit(FailFast, &rdev->flags) &&
+ test_bit(R1BIO_FailFast, &r1_bio->state))
+ /* This was a fail-fast read so we definitely
+ * want to retry */
+ ;
else {
/* If all other devices have failed, we want to return
* the error upwards rather than fail the last device.
@@ -536,6 +541,7 @@ static int read_balance(struct r1conf *conf, struct r1bio *r1_bio, int *max_sect
best_good_sectors = 0;
has_nonrot_disk = 0;
choose_next_idle = 0;
+ clear_bit(R1BIO_FailFast, &r1_bio->state);
if ((conf->mddev->recovery_cp < this_sector + sectors) ||
(mddev_is_clustered(conf->mddev) &&
@@ -609,6 +615,10 @@ static int read_balance(struct r1conf *conf, struct r1bio *r1_bio, int *max_sect
} else
best_good_sectors = sectors;
+ if (best_disk >= 0)
+ /* At least two disks to choose from so failfast is OK */
+ set_bit(R1BIO_FailFast, &r1_bio->state);
+
nonrot = blk_queue_nonrot(bdev_get_queue(rdev->bdev));
has_nonrot_disk |= nonrot;
pending = atomic_read(&rdev->nr_pending);
@@ -647,11 +657,6 @@ static int read_balance(struct r1conf *conf, struct r1bio *r1_bio, int *max_sect
}
break;
}
- /* If device is idle, use it */
- if (pending == 0) {
- best_disk = disk;
- break;
- }
if (choose_next_idle)
continue;
@@ -674,7 +679,7 @@ static int read_balance(struct r1conf *conf, struct r1bio *r1_bio, int *max_sect
* mixed ratation/non-rotational disks depending on workload.
*/
if (best_disk == -1) {
- if (has_nonrot_disk)
+ if (has_nonrot_disk || min_pending == 0)
best_disk = best_pending_disk;
else
best_disk = best_dist_disk;
@@ -1168,6 +1173,9 @@ static void raid1_make_request(struct mddev *mddev, struct bio * bio)
read_bio->bi_bdev = mirror->rdev->bdev;
read_bio->bi_end_io = raid1_end_read_request;
bio_set_op_attrs(read_bio, op, do_sync);
+ if (test_bit(FailFast, &mirror->rdev->flags) &&
+ test_bit(R1BIO_FailFast, &r1_bio->state))
+ read_bio->bi_opf |= MD_FAILFAST;
read_bio->bi_private = r1_bio;
if (mddev->gendisk)
@@ -1465,6 +1473,7 @@ static void raid1_error(struct mddev *mddev, struct md_rdev *rdev)
* next level up know.
* else mark the drive as failed
*/
+ spin_lock_irqsave(&conf->device_lock, flags);
if (test_bit(In_sync, &rdev->flags)
&& (conf->raid_disks - mddev->degraded) == 1) {
/*
@@ -1474,10 +1483,10 @@ static void raid1_error(struct mddev *mddev, struct md_rdev *rdev)
* it is very likely to fail.
*/
conf->recovery_disabled = mddev->recovery_disabled;
+ spin_unlock_irqrestore(&conf->device_lock, flags);
return;
}
set_bit(Blocked, &rdev->flags);
- spin_lock_irqsave(&conf->device_lock, flags);
if (test_and_clear_bit(In_sync, &rdev->flags)) {
mddev->degraded++;
set_bit(Faulty, &rdev->flags);
@@ -1816,12 +1825,24 @@ static int fix_sync_read_error(struct r1bio *r1_bio)
sector_t sect = r1_bio->sector;
int sectors = r1_bio->sectors;
int idx = 0;
+ struct md_rdev *rdev;
+
+ rdev = conf->mirrors[r1_bio->read_disk].rdev;
+ if (test_bit(FailFast, &rdev->flags)) {
+ /* Don't try recovering from here - just fail it
+ * ... unless it is the last working device of course */
+ md_error(mddev, rdev);
+ if (test_bit(Faulty, &rdev->flags))
+ /* Don't try to read from here, but make sure
+ * put_buf does it's thing
+ */
+ bio->bi_end_io = end_sync_write;
+ }
while(sectors) {
int s = sectors;
int d = r1_bio->read_disk;
int success = 0;
- struct md_rdev *rdev;
int start;
if (s > (PAGE_SIZE>>9))
@@ -2332,7 +2353,9 @@ static void handle_read_error(struct r1conf *conf, struct r1bio *r1_bio)
bio_put(bio);
r1_bio->bios[r1_bio->read_disk] = NULL;
- if (mddev->ro == 0) {
+ rdev = conf->mirrors[r1_bio->read_disk].rdev;
+ if (mddev->ro == 0
+ && !test_bit(FailFast, &rdev->flags)) {
freeze_array(conf, 1);
fix_read_error(conf, r1_bio->read_disk,
r1_bio->sector, r1_bio->sectors);
@@ -2341,7 +2364,7 @@ static void handle_read_error(struct r1conf *conf, struct r1bio *r1_bio)
r1_bio->bios[r1_bio->read_disk] = IO_BLOCKED;
}
- rdev_dec_pending(conf->mirrors[r1_bio->read_disk].rdev, conf->mddev);
+ rdev_dec_pending(rdev, conf->mddev);
read_more:
disk = read_balance(conf, r1_bio, &max_sectors);
@@ -2366,6 +2389,9 @@ static void handle_read_error(struct r1conf *conf, struct r1bio *r1_bio)
bio->bi_bdev = rdev->bdev;
bio->bi_end_io = raid1_end_read_request;
bio_set_op_attrs(bio, REQ_OP_READ, do_sync);
+ if (test_bit(FailFast, &rdev->flags) &&
+ test_bit(R1BIO_FailFast, &r1_bio->state))
+ bio->bi_opf |= MD_FAILFAST;
bio->bi_private = r1_bio;
if (max_sectors < r1_bio->sectors) {
/* Drat - have to split this up more */
@@ -2654,6 +2680,8 @@ static sector_t raid1_sync_request(struct mddev *mddev, sector_t sector_nr,
bio->bi_iter.bi_sector = sector_nr + rdev->data_offset;
bio->bi_bdev = rdev->bdev;
bio->bi_private = r1_bio;
+ if (test_bit(FailFast, &rdev->flags))
+ bio->bi_opf |= MD_FAILFAST;
}
}
rcu_read_unlock();
@@ -2784,6 +2812,8 @@ static sector_t raid1_sync_request(struct mddev *mddev, sector_t sector_nr,
if (bio->bi_end_io == end_sync_read) {
read_targets--;
md_sync_acct(bio->bi_bdev, nr_sectors);
+ if (read_targets == 1)
+ bio->bi_opf &= ~MD_FAILFAST;
generic_make_request(bio);
}
}
@@ -2791,6 +2821,8 @@ static sector_t raid1_sync_request(struct mddev *mddev, sector_t sector_nr,
atomic_set(&r1_bio->remaining, 1);
bio = r1_bio->bios[r1_bio->read_disk];
md_sync_acct(bio->bi_bdev, nr_sectors);
+ if (read_targets == 1)
+ bio->bi_opf &= ~MD_FAILFAST;
generic_make_request(bio);
}
@@ -183,5 +183,6 @@ enum r1bio_state {
*/
R1BIO_MadeGood,
R1BIO_WriteError,
+ R1BIO_FailFast,
};
#endif
If a device is marked FailFast and it is not the only device we can read from, we mark the bio with REQ_FAILFAST_* flags. If this does fail, we don't try read repair but just allow failure. If it was the last device it doesn't fail of course, so the retry happens on the same device - this time without FAILFAST. A subsequent failure will not retry but will just pass up the error. During resync we may use FAILFAST requests and on a failure we will simply use the other device(s). During recovery we will only use FAILFAST in the unusual case were there are multiple places to read from - i.e. if there are > 2 devices. If we get a failure we will fail the device and complete the resync/recovery with remaining devices. The new R1BIO_FailFast flag is set on read reqest to suggest the a FAILFAST request might be acceptable. The rdev needs to have FailFast set as well for the read to actually use REQ_FAILFAST_*. We need to know there are at least two working devices before we can set R1BIO_FailFast, so we mustn't stop looking at the first device we find. So the "min_pending == 0" handling to not exit early, but too always choose the best_pending_disk if min_pending == 0. The spinlocked region in raid1_error() in enlarged to ensure that if two bios, reading from two different devices, fail at the same time, then there is no risk that both devices will be marked faulty, leaving zero "In_sync" devices. Signed-off-by: NeilBrown <neilb@suse.com> --- drivers/md/raid1.c | 52 ++++++++++++++++++++++++++++++++++++++++++---------- drivers/md/raid1.h | 1 + 2 files changed, 43 insertions(+), 10 deletions(-) -- To unsubscribe from this list: send the line "unsubscribe linux-block" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html