[00/13] btrfs: clean up RAID I/O geometry calculation

Message

Johannes Thumshirn Dec. 12, 2023, 12:37 p.m. UTC

The calculation of the RAID I/O geometry in btrfs_map_block has been a maze of
if-else statements for a very long time and the advent of the
raid-stripe-tree made the situation even worse.

This patchset refactors btrfs_map_block() to untagle the maze and make I/O
geometry setting easier to follow, but does not introduce any functional
changes.

I've also run it through Josef's CI and there have been test failures, but
none of them introduced by these patches.

---
Johannes Thumshirn (13):
      btrfs: factor out helper for single device IO check
      btrfs: re-introduce struct btrfs_io_geometry
      btrfs: factor out block-mapping for RAID0
      btrfs: factor out RAID1 block mapping
      btrfs: factor out block mapping for DUP profiles
      btrfs: factor out block mapping for RAID10
      btrfs: reduce scope of data_stripes in btrfs_map_block
      btrfs: factor out block mapping for RAID5/6
      btrfs: factor out block mapping for single profiles
      btrfs: untagle if else maze in btrfs_map_block
      btrfs: open code set_io_stripe for RAID56
      btrfs: pass struct btrfs_io_geometry to set_io_stripe
      btrfs: pass btrfs_io_geometry into btrfs_max_io_len

 fs/btrfs/volumes.c | 388 +++++++++++++++++++++++++++++++++--------------------
 1 file changed, 245 insertions(+), 143 deletions(-)
---
base-commit: 14d1d39586246ca9d4ce97049c98be849e3bbcd9
change-id: 20231207-btrfs_map_block-cleanup-346f53aff90d

Best regards,