@@ -52,6 +52,7 @@
#define INT_MASK 0xf
#define MAX_PHASES 16
#define CORE_DLL_LOCK BIT(7)
+#define CORE_DDR_DLL_LOCK BIT(11)
#define CORE_DLL_EN BIT(16)
#define CORE_CDR_EN BIT(17)
#define CORE_CK_OUT_EN BIT(18)
@@ -63,6 +64,7 @@
#define CORE_DLL_STATUS 0x108
#define CORE_DLL_CONFIG_2 0x1b4
+#define CORE_DDR_CAL_EN BIT(0)
#define CORE_FLL_CYCLE_CNT BIT(18)
#define CORE_DLL_CLOCK_DISABLE BIT(21)
@@ -101,6 +103,11 @@
#define CORE_DDR_200_CFG 0x184
#define CORE_CDC_T4_DLY_SEL BIT(0)
#define CORE_START_CDC_TRAFFIC BIT(6)
+#define CORE_VENDOR_SPEC3 0x1b0
+#define CORE_PWRSAVE_DLL BIT(3)
+
+#define CORE_DDR_CONFIG 0x1b8
+#define DDR_CONFIG_POR_VAL 0x80040853
#define CORE_VENDOR_SPEC_CAPABILITIES0 0x11c
@@ -128,6 +135,7 @@ struct sdhci_msm_host {
bool tuning_done;
bool calibration_done;
u8 saved_tuning_phase;
+ bool use_cdclp533;
};
/* Platform specific tuning */
@@ -569,6 +577,87 @@ static int sdhci_msm_cdclp533_calibration(struct sdhci_host *host)
return ret;
}
+static int sdhci_msm_cm_dll_sdc4_calibration(struct sdhci_host *host)
+{
+ u32 dll_status, config;
+ int ret;
+
+ pr_debug("%s: %s: Enter\n", mmc_hostname(host->mmc), __func__);
+
+ /*
+ * Currently the CORE_DDR_CONFIG register defaults to desired
+ * configuration on reset. Currently reprogramming the power on
+ * reset (POR) value in case it might have been modified by
+ * bootloaders. In the future, if this changes, then the desired
+ * values will need to be programmed appropriately.
+ */
+ writel_relaxed(DDR_CONFIG_POR_VAL, host->ioaddr + CORE_DDR_CONFIG);
+
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG_2);
+ config |= CORE_DDR_CAL_EN;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG_2);
+
+ ret = readl_relaxed_poll_timeout(host->ioaddr + CORE_DLL_STATUS,
+ dll_status,
+ (dll_status & CORE_DDR_DLL_LOCK),
+ 10, 1000);
+
+ if (ret == -ETIMEDOUT) {
+ pr_err("%s: %s: CM_DLL_SDC4 calibration was not completed\n",
+ mmc_hostname(host->mmc), __func__);
+ goto out;
+ }
+
+ config = readl_relaxed(host->ioaddr + CORE_VENDOR_SPEC3);
+ config |= CORE_PWRSAVE_DLL;
+ writel_relaxed(config, host->ioaddr + CORE_VENDOR_SPEC3);
+
+ /*
+ * Drain writebuffer to ensure above DLL calibration
+ * and PWRSAVE DLL is enabled.
+ */
+ wmb();
+out:
+ pr_debug("%s: %s: Exit, ret %d\n", mmc_hostname(host->mmc),
+ __func__, ret);
+ return ret;
+}
+
+static int sdhci_msm_hs400_dll_calibration(struct sdhci_host *host)
+{
+ struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
+ struct sdhci_msm_host *msm_host = sdhci_pltfm_priv(pltfm_host);
+ int ret;
+ u32 config;
+
+ pr_debug("%s: %s: Enter\n", mmc_hostname(host->mmc), __func__);
+
+ /*
+ * Retuning in HS400 (DDR mode) will fail, just reset the
+ * tuning block and restore the saved tuning phase.
+ */
+ ret = msm_init_cm_dll(host);
+ if (ret)
+ goto out;
+
+ /* Set the selected phase in delay line hw block */
+ ret = msm_config_cm_dll_phase(host, msm_host->saved_tuning_phase);
+ if (ret)
+ goto out;
+
+ config = readl_relaxed(host->ioaddr + CORE_DLL_CONFIG);
+ config |= CORE_CMD_DAT_TRACK_SEL;
+ writel_relaxed(config, host->ioaddr + CORE_DLL_CONFIG);
+ if (msm_host->use_cdclp533)
+ ret = sdhci_msm_cdclp533_calibration(host);
+ else
+ ret = sdhci_msm_cm_dll_sdc4_calibration(host);
+out:
+ pr_debug("%s: %s: Exit, ret %d\n", mmc_hostname(host->mmc),
+ __func__, ret);
+ return ret;
+}
+
static int sdhci_msm_execute_tuning(struct sdhci_host *host, u32 opcode)
{
int tuning_seq_cnt = 3;
@@ -715,7 +804,7 @@ static void sdhci_msm_set_uhs_signaling(struct sdhci_host *host,
if (host->clock > CORE_FREQ_100MHZ &&
msm_host->tuning_done && !msm_host->calibration_done &&
mmc->ios.timing == MMC_TIMING_MMC_HS400)
- if (!sdhci_msm_cdclp533_calibration(host))
+ if (!sdhci_msm_hs400_dll_calibration(host))
msm_host->calibration_done = true;
spin_lock_irq(&host->lock);
}
@@ -805,7 +894,7 @@ static void sdhci_msm_set_clock(struct sdhci_host *host, unsigned int clock)
struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
struct sdhci_msm_host *msm_host = sdhci_pltfm_priv(pltfm_host);
struct mmc_ios curr_ios = host->mmc->ios;
- u32 config;
+ u32 config, dll_lock;
int rc;
if (!clock) {
@@ -862,7 +951,32 @@ static void sdhci_msm_set_clock(struct sdhci_host *host, unsigned int clock)
config |= CORE_HC_SELECT_IN_EN;
writel_relaxed(config, host->ioaddr + CORE_VENDOR_SPEC);
}
+ if (!msm_host->clk_rate && !msm_host->use_cdclp533) {
+ /*
+ * Poll on DLL_LOCK or DDR_DLL_LOCK bits in
+ * CORE_DLL_STATUS to be set. This should get set
+ * within 15 us at 200 MHz.
+ */
+ rc = readl_relaxed_poll_timeout(host->ioaddr +
+ CORE_DLL_STATUS,
+ dll_lock,
+ (dll_lock &
+ (CORE_DLL_LOCK |
+ CORE_DDR_DLL_LOCK)), 10,
+ 1000);
+ if (rc == -ETIMEDOUT)
+ pr_err("%s: Unable to get DLL_LOCK/DDR_DLL_LOCK, dll_status: 0x%08x\n",
+ mmc_hostname(host->mmc), dll_lock);
+ }
} else {
+ if (!msm_host->use_cdclp533) {
+ config = readl_relaxed(host->ioaddr +
+ CORE_VENDOR_SPEC3);
+ config &= ~CORE_PWRSAVE_DLL;
+ writel_relaxed(config, host->ioaddr +
+ CORE_VENDOR_SPEC3);
+ }
+
config = readl_relaxed(host->ioaddr + CORE_VENDOR_SPEC);
config &= ~CORE_HC_MCLK_SEL_MASK;
config |= CORE_HC_MCLK_SEL_DFLT;
@@ -1055,6 +1169,13 @@ static int sdhci_msm_probe(struct platform_device *pdev)
msm_host->use_14lpp_dll_reset = true;
/*
+ * SDCC 5 controller with major version 1, minor version 0x34 and later
+ * with HS 400 mode support will use CM DLL instead of CDC LP 533 DLL.
+ */
+ if (core_major == 1 && core_minor < 0x34)
+ msm_host->use_cdclp533 = true;
+
+ /*
* Support for some capabilities is not advertised by newer
* controller versions and must be explicitly enabled.
*/