| Message ID | 1401716531-29794-8-git-send-email-geert+renesas@glider.be (mailing list archive) |
|---|---|
| State | Not Applicable |
| Headers | show |
On 02/06/14 14:42, Geert Uytterhoeven wrote: > Add a DMA property to the QSPI node > > Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be> > --- > v2: > - QSPI needs to use 8-bit accesses for DMA, not 32-bit, > - Reorder: TX first, RX second. > > arch/arm/boot/dts/r8a7791.dtsi | 3 +++ > 1 file changed, 3 insertions(+) > > diff --git a/arch/arm/boot/dts/r8a7791.dtsi b/arch/arm/boot/dts/r8a7791.dtsi > index 37685ef32ea0..6c285ffc46cb 100644 > --- a/arch/arm/boot/dts/r8a7791.dtsi > +++ b/arch/arm/boot/dts/r8a7791.dtsi > @@ -917,6 +917,9 @@ > reg = <0 0xe6b10000 0 0x2c>; > interrupts = <0 184 IRQ_TYPE_LEVEL_HIGH>; > clocks = <&mstp9_clks R8A7791_CLK_QSPI_MOD>; > + dmas = <&dma0 R8A7791_DMA_QSPI_TX CHCR_TX_8BIT>, > + <&dma0 R8A7791_DMA_QSPI_RX CHCR_RX_8BIT>; > + dma-names = "tx", "rx"; I am hopeful that we can remove the CHCR settings, each driver should configure the width when configuring the slave. V2 of the patches will reflect this.
diff --git a/arch/arm/boot/dts/r8a7791.dtsi b/arch/arm/boot/dts/r8a7791.dtsi index 37685ef32ea0..6c285ffc46cb 100644 --- a/arch/arm/boot/dts/r8a7791.dtsi +++ b/arch/arm/boot/dts/r8a7791.dtsi @@ -917,6 +917,9 @@ reg = <0 0xe6b10000 0 0x2c>; interrupts = <0 184 IRQ_TYPE_LEVEL_HIGH>; clocks = <&mstp9_clks R8A7791_CLK_QSPI_MOD>; + dmas = <&dma0 R8A7791_DMA_QSPI_TX CHCR_TX_8BIT>, + <&dma0 R8A7791_DMA_QSPI_RX CHCR_RX_8BIT>; + dma-names = "tx", "rx"; num-cs = <1>; #address-cells = <1>; #size-cells = <0>;
Add a DMA property to the QSPI node Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be> --- v2: - QSPI needs to use 8-bit accesses for DMA, not 32-bit, - Reorder: TX first, RX second. arch/arm/boot/dts/r8a7791.dtsi | 3 +++ 1 file changed, 3 insertions(+)