new file mode 100644
@@ -0,0 +1,45 @@
+Allwinner A31 DMA Controller
+
+This driver follows the generic DMA bindings defined in dma.txt.
+
+Required properties:
+
+- compatible: Must be "allwinner,sun6i-a31-dma"
+- reg: Should contain the registers base address and length
+- interrupts: Should contain a reference to the interrupt used by this device
+- clocks: Should contain a reference to the parent AHB clock
+- resets: Should contain a reference to the reset controller asserting
+ this device in reset
+- #dma-cells : Should be 1, a single cell holding a line request number
+
+Example:
+ dma: dma-controller@01c02000 {
+ compatible = "allwinner,sun6i-a31-dma";
+ reg = <0x01c02000 0x1000>;
+ interrupts = <0 50 4>;
+ clocks = <&ahb1_gates 6>;
+ resets = <&ahb1_rst 6>;
+ #dma-cells = <1>;
+ };
+
+Clients:
+
+DMA clients connected to the A31 DMA controller must use the format
+described in the dma.txt file, using a two-cell specifier for each
+channel: a phandle plus one integer cells.
+The two cells in order are:
+
+1. A phandle pointing to the DMA controller.
+2. The port ID as specified in the datasheet
+
+Example:
+spi2: spi@01c6a000 {
+ compatible = "allwinner,sun6i-a31-spi";
+ reg = <0x01c6a000 0x1000>;
+ interrupts = <0 67 4>;
+ clocks = <&ahb1_gates 22>, <&spi2_clk>;
+ clock-names = "ahb", "mod";
+ dmas = <&dma 25>, <&dma 25>;
+ dma-names = "rx", "tx";
+ resets = <&ahb1_rst 22>;
+};
The Allwinner A31 DMA controller is rather simple to describe in the DT. Add the bindings documentation. Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com> --- .../devicetree/bindings/dma/sun6i-dma.txt | 45 ++++++++++++++++++++++ 1 file changed, 45 insertions(+) create mode 100644 Documentation/devicetree/bindings/dma/sun6i-dma.txt