@@ -110,14 +110,14 @@ contain files named "0", "1", "2", ... The file numbers also represent
increasing zone start sector on the device.
All read and write operations to zone files are not allowed beyond the file
-maximum size, that is, beyond the zone size. Any access exceeding the zone
-size is failed with the -EFBIG error.
+maximum size, that is, beyond the zone capacity. Any access exceeding the zone
+capacity is failed with the -EFBIG error.
Creating, deleting, renaming or modifying any attribute of files and
sub-directories is not allowed.
The number of blocks of a file as reported by stat() and fstat() indicates the
-size of the file zone, or in other words, the maximum file size.
+capacity of the zone file, or in other words, the maximum file size.
Conventional zone files
-----------------------
@@ -156,8 +156,8 @@ all accepted.
Truncating sequential zone files is allowed only down to 0, in which case, the
zone is reset to rewind the file zone write pointer position to the start of
-the zone, or up to the zone size, in which case the file's zone is transitioned
-to the FULL state (finish zone operation).
+the zone, or up to the zone capacity, in which case the file's zone is
+transitioned to the FULL state (finish zone operation).
Format options
--------------
@@ -324,7 +324,7 @@ file size set to 0. This is necessary as the write pointer of read-only zones
is defined as invalib by the ZBC and ZAC standards, making it impossible to
discover the amount of data that has been written to the zone. In the case of a
read-only zone discovered at run-time, as indicated in the previous section.
-the size of the zone file is left unchanged from its last updated value.
+The size of the zone file is left unchanged from its last updated value.
Zonefs User Space Tools
=======================
@@ -401,8 +401,9 @@ append-writes to the file::
# ls -l /mnt/seq/0
-rw-r----- 1 root root 0 Nov 25 13:49 /mnt/seq/0
-Since files are statically mapped to zones on the disk, the number of blocks of
-a file as reported by stat() and fstat() indicates the size of the file zone::
+Since files are statically mapped to zones on the disk, the number of blocks
+of a file as reported by stat() and fstat() indicates the capacity of the file
+zone::
# stat /mnt/seq/0
File: /mnt/seq/0
@@ -416,5 +417,6 @@ a file as reported by stat() and fstat() indicates the size of the file zone::
The number of blocks of the file ("Blocks") in units of 512B blocks gives the
maximum file size of 524288 * 512 B = 256 MB, corresponding to the device zone
-size in this example. Of note is that the "IO block" field always indicates the
-minimum I/O size for writes and corresponds to the device physical sector size.
+capacity in this example. Of note is that the "IO block" field always
+indicates the minimum I/O size for writes and corresponds to the device
+physical sector size.
Update the zonefs documentation to reflect the difference between a zone's size and it's capacity. The maximum file size in zonefs is the zones capacity, for ZBC and ZAC based devices, which do not have a separate zone capacity, the zone capacity is equal to the zone size. Signed-off-by: Johannes Thumshirn <johannes.thumshirn@wdc.com> --- Documentation/filesystems/zonefs.rst | 22 ++++++++++++---------- 1 file changed, 12 insertions(+), 10 deletions(-)