@@ -201,8 +201,18 @@ static int pvt_read_in(struct device *dev, u32 attr, int channel, long *val)
return ret;
n &= SAMPLE_DATA_MSK;
- /* Convert the N bitstream count into voltage */
- *val = (PVT_N_CONST * n - PVT_R_CONST) >> PVT_CONV_BITS;
+ /*
+ * Convert the N bitstream count into voltage.
+ * To support negative voltage calculation for 64bit machines
+ * n must be cast to long, since n and *val differ both in
+ * signedness and in size.
+ * Division is used instead of right shift, because for signed
+ * numbers, the sign bit is used to fill the vacated bit
+ * positions, and if the number is negative, 1 is used.
+ * BIT(x) may not be used instead of (1 << x) because it's
+ * unsigned.
+ */
+ *val = (PVT_N_CONST * (long)n - PVT_R_CONST) / (1 << PVT_CONV_BITS);
return 0;
default:
According to Moortec Embedded Voltage Monitor (MEVM) series 3 data sheet, the minimum input signal is -100mv and maximum input signal is +1000mv. The equation used to convert the digital word to voltage uses mixed types (*val signed and n unsigned), and on 64 bit machines also has different size, since sizeof(u32) = 4 and sizeof(long) = 8. So when measuring a negative input, n will be small enough, such that PVT_N_CONST * n < PVT_R_CONST, and the result of (PVT_N_CONST * n - PVT_R_CONST) will overflow to a very big positive 32 bit number. Then when storing the result in *val it will be the same value just in 64 bit (instead of it representing a negative number which will what happen when sizeof(long) = 4). When -1023 <= (PVT_N_CONST * n - PVT_R_CONST) <= -1 dividing the number by 1024 should result of in 0, but because ">> 10" is used, and the sign bit is used to fill the vacated bit positions, it results in -1 (0xf...fffff) which is wrong. This change fixes the sign problem and supports negative values by casting n to long and replacing the shift right with div operation. Fixes: 9d823351a337 ("hwmon: Add hardware monitoring driver for Moortec MR75203 PVT controller") Signed-off-by: Eliav Farber <farbere@amazon.com> Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> --- V5 -> V4: - Add detailed comment in code explaining the cast and the div instead of right shift or use of BIT(). V4 -> V3: - Remove unrelated change (add of empty line). V3 -> V2: - Fix equation to support negative values instead of limiting value to zero. drivers/hwmon/mr75203.c | 14 ++++++++++++-- 1 file changed, 12 insertions(+), 2 deletions(-)