| Message ID | 20231109133708.653950-4-jarkko.nikula@linux.intel.com (mailing list archive) |
|---|---|
| State | Accepted |
| Headers | show |
| Series | i3c: mipi-i3c-hci: Functional update | expand |
diff --git a/drivers/i3c/master/mipi-i3c-hci/cmd_v1.c b/drivers/i3c/master/mipi-i3c-hci/cmd_v1.c index 31f03cb22489..638b054d6c92 100644 --- a/drivers/i3c/master/mipi-i3c-hci/cmd_v1.c +++ b/drivers/i3c/master/mipi-i3c-hci/cmd_v1.c @@ -339,7 +339,8 @@ static int hci_cmd_v1_daa(struct i3c_hci *hci) ret = -ETIME; break; } - if (RESP_STATUS(xfer->response) == RESP_ERR_NACK && + if ((RESP_STATUS(xfer->response) == RESP_ERR_ADDR_HEADER || + RESP_STATUS(xfer->response) == RESP_ERR_NACK) && RESP_DATA_LENGTH(xfer->response) == 1) { ret = 0; /* no more devices to be assigned */ break;
Handle also I3C address header error response status as the end of DAA process in hci_cmd_v1_daa(). According to MIPI I3C HCI Specification v1.1 the NACK error during DAA process comes when the device does not accept the dynamic address. Currently code uses it for successful exit from the process and fails with any other error response. I'm unsure is this MIPI I3C HCI version specific difference or specification misunderstanding but on an early MIPI I3C HCI version compatible controller responds always with I3C address header error and not with NACK error when there is no device on the bus or no more devices participating to DAA process. Handle now both response statuses as the end of DAA. Signed-off-by: Jarkko Nikula <jarkko.nikula@linux.intel.com> --- drivers/i3c/master/mipi-i3c-hci/cmd_v1.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)