mbox series

[0/6] Add support for SCD30 sensor

Message ID 20200422141135.86419-1-tomasz.duszynski@octakon.com (mailing list archive)
Headers show
Series Add support for SCD30 sensor | expand

Message

Tomasz Duszynski April 22, 2020, 2:11 p.m. UTC 
Following series adds support for Sensirion SCD30 sensor module capable of
measuring carbon dioxide, temperature and relative humidity. CO2 measurements
base on NDIR principle while temperature and relative humidity are measured by
the on board SHT31. As for sensor communication, both I2C and serial interfaces
are supported.

Tomasz Duszynski (6):
  iio: chemical: scd30: add core driver
  iio: chemical: scd30: add I2C interface driver
  iio: chemical: scd30: add serial interface driver
  Documentation: ABI: testing: scd30: document iio attributes
  dt-bindings: iio: scd30: add device binding file
  MAINTAINERS: add myself as a SCD30 driver maintainer

 Documentation/ABI/testing/sysfs-bus-iio-scd30 |  97 +++
 .../iio/chemical/sensirion,scd30.yaml         |  71 ++
 MAINTAINERS                                   |   9 +
 drivers/iio/chemical/Kconfig                  |  33 +
 drivers/iio/chemical/Makefile                 |   3 +
 drivers/iio/chemical/scd30.h                  |  72 ++
 drivers/iio/chemical/scd30_core.c             | 796 ++++++++++++++++++
 drivers/iio/chemical/scd30_i2c.c              | 141 ++++
 drivers/iio/chemical/scd30_serial.c           | 262 ++++++
 9 files changed, 1484 insertions(+)
 create mode 100644 Documentation/ABI/testing/sysfs-bus-iio-scd30
 create mode 100644 Documentation/devicetree/bindings/iio/chemical/sensirion,scd30.yaml
 create mode 100644 drivers/iio/chemical/scd30.h
 create mode 100644 drivers/iio/chemical/scd30_core.c
 create mode 100644 drivers/iio/chemical/scd30_i2c.c
 create mode 100644 drivers/iio/chemical/scd30_serial.c

--
2.26.1