| Message ID | 20181028122629.10144-4-martin.blumenstingl@googlemail.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | meson-saradc: add chip temperature support | expand |
diff --git a/arch/arm/boot/dts/meson8.dtsi b/arch/arm/boot/dts/meson8.dtsi index 3e3d9c54cddc..30d4406f63b3 100644 --- a/arch/arm/boot/dts/meson8.dtsi +++ b/arch/arm/boot/dts/meson8.dtsi @@ -304,6 +304,11 @@ compatible = "amlogic,meson8-efuse"; clocks = <&clkc CLKID_EFUSE>; clock-names = "core"; + + temperature_calib: calib@1f4 { + /* only the upper two bytes are relevant */ + reg = <0x1f4 0x4>; + }; }; ðmac { @@ -364,6 +369,9 @@ clocks = <&clkc CLKID_XTAL>, <&clkc CLKID_SAR_ADC>; clock-names = "clkin", "core"; + amlogic,hhi-sysctrl = <&hhi>; + nvmem-cells = <&temperature_calib>; + nvmem-cell-names = "temperature_calib"; }; &sdio {
The SAR ADC can measure the chip temperature of the SoC. This only works if the chip is calibrated and if the calibration data is written to the correct registers. The calibration data is stored in the upper two bytes of eFuse offset 0x1f4. This adds the eFuse cell for the temperature calibration data and passes it to the SAR ADC. We also need to pass the HHI sysctrl node to the SAR ADC because the 4th TSC (temperature sensor calibration coefficient) bit is stored in the HHI region (unlike bits [3:0] which are stored directly inside the SAR ADC's register area). On boards that have the SAR ADC enabled channel 8 can be used to measure the chip temperature. Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com> --- arch/arm/boot/dts/meson8.dtsi | 8 ++++++++ 1 file changed, 8 insertions(+)