@@ -1389,8 +1389,7 @@ static int atmel_spi_one_transfer(struct spi_master *master,
&& as->use_pdc)
atmel_spi_dma_unmap_xfer(master, xfer);
- if (xfer->delay_usecs)
- udelay(xfer->delay_usecs);
+ spi_transfer_delay(xfer);
if (xfer->cs_change) {
if (list_is_last(&xfer->transfer_list,
@@ -291,8 +291,7 @@ static int bcm63xx_hsspi_transfer_one(struct spi_master *master,
msg->actual_length += t->len;
- if (t->delay_usecs)
- udelay(t->delay_usecs);
+ spi_transfer_delay(t);
if (t->cs_change)
bcm63xx_hsspi_set_cs(bs, spi->chip_select, false);
@@ -119,8 +119,7 @@ static int octeon_spi_do_transfer(struct octeon_spi *p,
*rx_buf++ = (u8)v;
}
- if (xfer->delay_usecs)
- udelay(xfer->delay_usecs);
+ spi_transfer_delay(xfer);
return xfer->len;
}
@@ -752,8 +752,7 @@ static int dspi_transfer_one_message(struct spi_master *master,
dspi->waitflags = 0;
}
- if (transfer->delay_usecs)
- udelay(transfer->delay_usecs);
+ spi_transfer_delay(transfer);
}
out:
@@ -427,8 +427,7 @@ static int fsl_espi_trans(struct spi_message *m, struct spi_transfer *trans)
ret = fsl_espi_bufs(spi, trans);
- if (trans->delay_usecs)
- udelay(trans->delay_usecs);
+ spi_transfer_delay(trans);
return ret;
}
@@ -417,8 +417,7 @@ static int fsl_spi_do_one_msg(struct spi_master *master,
}
m->actual_length += t->len;
- if (t->delay_usecs)
- udelay(t->delay_usecs);
+ spi_transfer_delay(t);
if (cs_change) {
ndelay(nsecs);
@@ -311,8 +311,7 @@ static int mpc512x_psc_spi_msg_xfer(struct spi_master *master,
break;
m->actual_length += t->len;
- if (t->delay_usecs)
- udelay(t->delay_usecs);
+ spi_transfer_delay(t);
if (cs_change)
mpc512x_psc_spi_deactivate_cs(spi);
@@ -234,8 +234,7 @@ static void mpc52xx_psc_spi_work(struct work_struct *work)
break;
m->actual_length += t->len;
- if (t->delay_usecs)
- udelay(t->delay_usecs);
+ spi_transfer_delay(t);
if (cs_change)
mpc52xx_psc_spi_deactivate_cs(spi);
@@ -321,8 +321,7 @@ static int omap1_spi100k_transfer_one_message(struct spi_master *master,
}
}
- if (t->delay_usecs)
- udelay(t->delay_usecs);
+ spi_transfer_delay(t);
/* ignore the "leave it on after last xfer" hint */
@@ -485,12 +485,11 @@ static void giveback(struct pl022 *pl022)
struct spi_transfer, transfer_list);
/* Delay if requested before any change in chip select */
- if (last_transfer->delay_usecs)
- /*
- * FIXME: This runs in interrupt context.
- * Is this really smart?
- */
- udelay(last_transfer->delay_usecs);
+ /*
+ * FIXME: This runs in interrupt context.
+ * Is this really smart?
+ */
+ spi_transfer_delay(last_transfer);
if (!last_transfer->cs_change) {
struct spi_message *next_msg;
@@ -1401,12 +1400,11 @@ static void pump_transfers(unsigned long data)
previous = list_entry(transfer->transfer_list.prev,
struct spi_transfer,
transfer_list);
- if (previous->delay_usecs)
- /*
- * FIXME: This runs in interrupt context.
- * Is this really smart?
- */
- udelay(previous->delay_usecs);
+ /*
+ * FIXME: This runs in interrupt context.
+ * Is this really smart?
+ */
+ spi_transfer_delay(previous);
/* Reselect chip select only if cs_change was requested */
if (previous->cs_change)
@@ -1520,8 +1518,7 @@ static void do_polling_transfer(struct pl022 *pl022)
previous =
list_entry(transfer->transfer_list.prev,
struct spi_transfer, transfer_list);
- if (previous->delay_usecs)
- udelay(previous->delay_usecs);
+ spi_transfer_delay(previous);
if (previous->cs_change)
pl022_cs_control(pl022, SSP_CHIP_SELECT);
} else {
@@ -211,8 +211,7 @@ static int sc18is602_transfer_one(struct spi_master *master,
}
status = 0;
- if (t->delay_usecs)
- udelay(t->delay_usecs);
+ spi_transfer_delay(t);
}
m->status = status;
spi_finalize_current_message(master);
@@ -190,8 +190,7 @@ static int hspi_transfer_one_message(struct spi_controller *ctlr,
msg->actual_length += t->len;
- if (t->delay_usecs)
- udelay(t->delay_usecs);
+ spi_transfer_delay(t);
if (cs_change) {
ndelay(nsecs);
@@ -344,7 +344,7 @@ static int tegra_sflash_transfer_one_message(struct spi_master *master,
if (xfer->cs_change && xfer->delay_usecs) {
tegra_sflash_writel(tsd, tsd->def_command_reg,
SPI_COMMAND);
- udelay(xfer->delay_usecs);
+ spi_transfer_delay(xfer);
}
}
ret = 0;
@@ -1229,12 +1229,7 @@ static void pch_spi_process_messages(struct work_struct *pwork)
"%s:data->current_msg->actual_length=%d\n",
__func__, data->current_msg->actual_length);
- /* check for delay */
- if (data->cur_trans->delay_usecs) {
- dev_dbg(&data->master->dev, "%s:delay in usec=%d\n",
- __func__, data->cur_trans->delay_usecs);
- udelay(data->cur_trans->delay_usecs);
- }
+ spi_transfer_delay(data->cur_trans);
spin_lock(&data->lock);
@@ -248,8 +248,7 @@ static void txx9spi_work_one(struct txx9spi *c, struct spi_message *m)
len -= count * wsize;
}
m->actual_length += t->len;
- if (t->delay_usecs)
- udelay(t->delay_usecs);
+ spi_transfer_delay(t);
if (!cs_change)
continue;
@@ -188,8 +188,7 @@ static int spi_xcomm_transfer_one(struct spi_master *master,
}
status = 0;
- if (t->delay_usecs)
- udelay(t->delay_usecs);
+ spi_transfer_delay(t);
is_first = false;
}
For many places in the spi drivers, using the new `spi_transfer_delay` helper is straightforward. It's just replacing: ``` if (t->delay_usecs) udelay(t->delay_usecs); ``` with `spi_transfer_delay(t)` which handles both `delay_usecs` and the new `delay` field. This change replaces in all places (in the spi drivers) where this change is simple. Signed-off-by: Alexandru Ardelean <alexandru.ardelean@analog.com> --- drivers/spi/spi-atmel.c | 3 +-- drivers/spi/spi-bcm63xx-hsspi.c | 3 +-- drivers/spi/spi-cavium.c | 3 +-- drivers/spi/spi-fsl-dspi.c | 3 +-- drivers/spi/spi-fsl-espi.c | 3 +-- drivers/spi/spi-fsl-spi.c | 3 +-- drivers/spi/spi-mpc512x-psc.c | 3 +-- drivers/spi/spi-mpc52xx-psc.c | 3 +-- drivers/spi/spi-omap-100k.c | 3 +-- drivers/spi/spi-pl022.c | 25 +++++++++++-------------- drivers/spi/spi-sc18is602.c | 3 +-- drivers/spi/spi-sh-hspi.c | 3 +-- drivers/spi/spi-tegra20-sflash.c | 2 +- drivers/spi/spi-topcliff-pch.c | 7 +------ drivers/spi/spi-txx9.c | 3 +-- drivers/spi/spi-xcomm.c | 3 +-- 16 files changed, 26 insertions(+), 47 deletions(-)