| Message ID | 20200206092313.18265-3-alexandru.tachici@analog.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
| Series | iio: dac: AD5770R: Add support | expand |
On Thu, 6 Feb 2020 11:23:13 +0200 Alexandru Tachici <alexandru.tachici@analog.com> wrote: > Adding dt-bindings documentation for AD5770R DAC. > > Signed-off-by: Mircea Caprioru <mircea.caprioru@analog.com> > Signed-off-by: Alexandru Tachici <alexandru.tachici@analog.com> A few minor bits inline. > --- > .../bindings/iio/dac/adi,ad5770r.yaml | 176 ++++++++++++++++++ > 1 file changed, 176 insertions(+) > create mode 100644 Documentation/devicetree/bindings/iio/dac/adi,ad5770r.yaml > > diff --git a/Documentation/devicetree/bindings/iio/dac/adi,ad5770r.yaml b/Documentation/devicetree/bindings/iio/dac/adi,ad5770r.yaml > new file mode 100644 > index 000000000000..02b2f6e67583 > --- /dev/null > +++ b/Documentation/devicetree/bindings/iio/dac/adi,ad5770r.yaml > @@ -0,0 +1,176 @@ > +# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) > +# Copyright 2020 Analog Devices Inc. > +%YAML 1.2 > +--- > +$id: http://devicetree.org/schemas/bindings/iio/adc/adi,ad5770r.yaml# > +$schema: http://devicetree.org/meta-schemas/core.yaml# > + > +title: Analog Devices AD5770R DAC device driver > + > +maintainers: > + - Mircea Caprioru <mircea.caprioru@analog.com> > + > +description: | > + Bindings for the Analog Devices AD5770R current DAC device. Datasheet can be > + found here: > + https://www.analog.com/media/en/technical-documentation/data-sheets/AD5770R.pdf > + > +properties: > + compatible: > + enum: > + - adi,ad5770r > + > + reg: > + maxItems: 1 > + > + vref-supply: Probably need to also mention the main power supply? Ideally enable it in the driver, but if not should still be in the binding. > + description: Specify the voltage of the external reference used. > + Available reference options are 1.25 V or 2.5 V. If no > + external reference declared then the device will use the > + internal reference of 1.25 V. > + > + adi,external-resistor: > + description: Specify if an external 2.5k ohm resistor is used. If not > + specified the device will use and internal 2.5k ohm resistor. use an internal... > + The precision resistor is used for reference current generation. > + type: boolean > + > + reset-gpios: > + description: GPIO spec for the RESET pin. If specified, it will be > + asserted during driver probe. > + maxItems: 1 > + > + channel0: > + description: Represents an external channel which are > + connected to the DAC. Channel 0 can act both as a current > + source and sink. > + type: object > + > + properties: > + num: > + description: This represents the channel number. > + items: > + const: 0 > + > + adi,range-microamp: > + description: Output range of the channel. > + oneOf: > + - $ref: /schemas/types.yaml#/definitions/int32-array > + - items: > + - enum: [0 300000] > + - enum: [-60000 0] > + - enum: [-60000 300000] > + > + channel1: > + description: Represents an external channel which are > + connected to the DAC. > + type: object > + > + properties: > + num: > + description: This represents the channel number. > + items: > + const: 1 > + > + adi,range-microamp: > + description: Output range of the channel. > + allOf: > + - $ref: /schemas/types.yaml#/definitions/uint32-array > + - items: > + - enum: [0 140000] > + - enum: [0 250000] > + > + channel2: > + description: Represents an external channel which are > + connected to the DAC. > + type: object > + > + properties: > + num: > + description: This represents the channel number. > + items: > + const: 2 > + > + adi,range-microamp: > + description: Output range of the channel. > + allOf: > + - $ref: /schemas/types.yaml#/definitions/uint32-array > + - items: > + - enum: [0 140000] > + - enum: [0 250000] > + > +patternProperties: > + "^channel@([3-5])$": > + type: object > + description: Represents the external channels which are connected to the DAC. > + properties: > + num: > + description: This represents the channel number. > + items: > + minimum: 3 > + maximum: 5 > + > + adi,range-microamp: > + description: Output range of the channel. > + oneOf: > + - $ref: /schemas/types.yaml#/definitions/uint32-array > + - items: > + - enum: [0 45000] > + - enum: [0 100000] > + > +required: > +- reg > +- diff-channels > +- channel0 > +- channel1 > +- channel2 > +- channel3 > +- channel4 > +- channel5 > + > +examples: > + - | > + spi { > + #address-cells = <1>; > + #size-cells = <0>; > + > + ad5770r@0 { > + compatible = "ad5770r"; > + reg = <0>; > + spi-max-frequency = <1000000>; > + vref-supply = <&vref>; > + adi,external-resistor; > + reset-gpios = <&gpio 22 0>; > + > + channel@0 { > + num = <0>; > + adi,range-microamp = <(-60000) 300000>; > + }; > + > + channel@1 { > + num = <1>; > + adi,range-microamp = <0 140000>; > + }; > + > + channel@2 { > + num = <2>; > + adi,range-microamp = <0 55000>; > + }; > + > + channel@3 { > + num = <3>; > + adi,range-microamp = <0 45000>; > + }; > + > + channel@4 { > + num = <4>; > + adi,range-microamp = <0 45000>; > + }; > + > + channel@5 { > + num = <5>; > + adi,range-microamp = <0 45000>; > + }; > + }; > + }; > +... > \ No newline at end of file Tidy that up if you are doing a new version.
diff --git a/Documentation/devicetree/bindings/iio/dac/adi,ad5770r.yaml b/Documentation/devicetree/bindings/iio/dac/adi,ad5770r.yaml new file mode 100644 index 000000000000..02b2f6e67583 --- /dev/null +++ b/Documentation/devicetree/bindings/iio/dac/adi,ad5770r.yaml @@ -0,0 +1,176 @@ +# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) +# Copyright 2020 Analog Devices Inc. +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/bindings/iio/adc/adi,ad5770r.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: Analog Devices AD5770R DAC device driver + +maintainers: + - Mircea Caprioru <mircea.caprioru@analog.com> + +description: | + Bindings for the Analog Devices AD5770R current DAC device. Datasheet can be + found here: + https://www.analog.com/media/en/technical-documentation/data-sheets/AD5770R.pdf + +properties: + compatible: + enum: + - adi,ad5770r + + reg: + maxItems: 1 + + vref-supply: + description: Specify the voltage of the external reference used. + Available reference options are 1.25 V or 2.5 V. If no + external reference declared then the device will use the + internal reference of 1.25 V. + + adi,external-resistor: + description: Specify if an external 2.5k ohm resistor is used. If not + specified the device will use and internal 2.5k ohm resistor. + The precision resistor is used for reference current generation. + type: boolean + + reset-gpios: + description: GPIO spec for the RESET pin. If specified, it will be + asserted during driver probe. + maxItems: 1 + + channel0: + description: Represents an external channel which are + connected to the DAC. Channel 0 can act both as a current + source and sink. + type: object + + properties: + num: + description: This represents the channel number. + items: + const: 0 + + adi,range-microamp: + description: Output range of the channel. + oneOf: + - $ref: /schemas/types.yaml#/definitions/int32-array + - items: + - enum: [0 300000] + - enum: [-60000 0] + - enum: [-60000 300000] + + channel1: + description: Represents an external channel which are + connected to the DAC. + type: object + + properties: + num: + description: This represents the channel number. + items: + const: 1 + + adi,range-microamp: + description: Output range of the channel. + allOf: + - $ref: /schemas/types.yaml#/definitions/uint32-array + - items: + - enum: [0 140000] + - enum: [0 250000] + + channel2: + description: Represents an external channel which are + connected to the DAC. + type: object + + properties: + num: + description: This represents the channel number. + items: + const: 2 + + adi,range-microamp: + description: Output range of the channel. + allOf: + - $ref: /schemas/types.yaml#/definitions/uint32-array + - items: + - enum: [0 140000] + - enum: [0 250000] + +patternProperties: + "^channel@([3-5])$": + type: object + description: Represents the external channels which are connected to the DAC. + properties: + num: + description: This represents the channel number. + items: + minimum: 3 + maximum: 5 + + adi,range-microamp: + description: Output range of the channel. + oneOf: + - $ref: /schemas/types.yaml#/definitions/uint32-array + - items: + - enum: [0 45000] + - enum: [0 100000] + +required: +- reg +- diff-channels +- channel0 +- channel1 +- channel2 +- channel3 +- channel4 +- channel5 + +examples: + - | + spi { + #address-cells = <1>; + #size-cells = <0>; + + ad5770r@0 { + compatible = "ad5770r"; + reg = <0>; + spi-max-frequency = <1000000>; + vref-supply = <&vref>; + adi,external-resistor; + reset-gpios = <&gpio 22 0>; + + channel@0 { + num = <0>; + adi,range-microamp = <(-60000) 300000>; + }; + + channel@1 { + num = <1>; + adi,range-microamp = <0 140000>; + }; + + channel@2 { + num = <2>; + adi,range-microamp = <0 55000>; + }; + + channel@3 { + num = <3>; + adi,range-microamp = <0 45000>; + }; + + channel@4 { + num = <4>; + adi,range-microamp = <0 45000>; + }; + + channel@5 { + num = <5>; + adi,range-microamp = <0 45000>; + }; + }; + }; +... \ No newline at end of file