[v4,2/2] Added AMS tsl2591 device tree binding

Commit Message

Joe Sandom Feb. 22, 2021, 8:56 p.m. UTC

Device tree binding for AMS/TAOS tsl2591 ambient light sensor.

This driver supports configuration via device tree and sysfs.
Supported channels for raw infrared light intensity,
raw combined light intensity and illuminance in lux.
The driver additionally supports iio events on lower and
upper thresholds.

This is a very-high sensitivity light-to-digital converter that
transforms light intensity into a digital signal.

Datasheet Available at: https://ams.com/tsl25911

Signed-off-by: Joe Sandom <[e-mail]>
---
Changes in v4:
- Corrected id field to include vendor name in prefix

Notes:
- Previously incorrectly included binding in same patch as driver.
  This was pointed out by the maintainer and has now been changed to
  a patch series. Sorry for the confusion!
 
 .../bindings/iio/light/amstaos,tsl2591.yaml   | 50 +++++++++++++++++++
 1 file changed, 50 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/iio/light/amstaos,tsl2591.yaml

Patch

diff --git a/Documentation/devicetree/bindings/iio/light/amstaos,tsl2591.yaml b/Documentation/devicetree/bindings/iio/light/amstaos,tsl2591.yaml
new file mode 100644
index 000000000000..596a3bc770f4
--- /dev/null
+++ b/Documentation/devicetree/bindings/iio/light/amstaos,tsl2591.yaml
@@ -0,0 +1,50 @@ 
+# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/iio/light/amstaos,tsl2591.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: AMS/TAOS TSL2591 Ambient Light Sensor (ALS)
+
+maintainers:
+  - Joe Sandom <[e-mail]>
+
+description: |
+  AMS/TAOS TSL2591 is a very-high sensitivity
+  light-to-digital converter that transforms light intensity into a digital
+  signal.
+
+properties:
+  compatible:
+    const: amstaos,tsl2591
+
+  reg:
+    maxItems: 1
+
+  interrupts:
+    maxItems: 1
+    description:
+      Interrupt (INT:Pin 2) Active low. Should be set to IRQ_TYPE_EDGE_FALLING.
+      interrupt is used to detect if the light intensity has fallen below
+      or reached above the configured threshold values.
+
+required:
+  - compatible
+  - reg
+
+additionalProperties: false
+
+examples:
+  - |
+    #include <dt-bindings/interrupt-controller/irq.h>
+    i2c {
+        #address-cells = <1>;
+        #size-cells = <0>;
+
+        tsl2591@29 {
+            compatible = "amstaos,tsl2591";
+            reg = <0x29>;
+            interrupts = <20 IRQ_TYPE_EDGE_FALLING>;
+       };
+    };
+...