@@ -59,16 +59,16 @@ static int pwm_regulator_set_voltage_sel(struct regulator_dev *rdev,
unsigned selector)
{
struct pwm_regulator_data *drvdata = rdev_get_drvdata(rdev);
- unsigned int pwm_reg_period;
+ struct pwm_args pargs = { };
int dutycycle;
int ret;
- pwm_reg_period = pwm_get_period(drvdata->pwm);
+ pwm_get_args(drvdata->pwm, &pargs);
- dutycycle = (pwm_reg_period *
+ dutycycle = (pargs.period *
drvdata->duty_cycle_table[selector].dutycycle) / 100;
- ret = pwm_config(drvdata->pwm, dutycycle, pwm_reg_period);
+ ret = pwm_config(drvdata->pwm, dutycycle, pargs.period);
if (ret) {
dev_err(&rdev->dev, "Failed to configure PWM\n");
return ret;
@@ -138,13 +138,15 @@ static int pwm_regulator_set_voltage(struct regulator_dev *rdev,
{
struct pwm_regulator_data *drvdata = rdev_get_drvdata(rdev);
unsigned int ramp_delay = rdev->constraints->ramp_delay;
- unsigned int period = pwm_get_period(drvdata->pwm);
+ struct pwm_args pargs = { };
int duty_cycle;
int ret;
+ pwm_get_args(drvdata->pwm, &pargs);
duty_cycle = pwm_voltage_to_duty_cycle_percentage(rdev, min_uV);
- ret = pwm_config(drvdata->pwm, (period / 100) * duty_cycle, period);
+ ret = pwm_config(drvdata->pwm, (pargs.period / 100) * duty_cycle,
+ pargs.period);
if (ret) {
dev_err(&rdev->dev, "Failed to configure PWM\n");
return ret;
The PWM framework has clarified the concept of reference PWM config (the platform dependent config retrieved from the DT or the PWM lookup table) and real PWM state. Use pwm_get_args() when the PWM user wants to retrieve this reference config and not the current state. This is part of the rework allowing the PWM framework to support hardware readout and expose real PWM state even when the PWM has just been requested (before the user calls pwm_config/enable/disable()). Signed-off-by: Boris Brezillon <boris.brezillon@free-electrons.com> --- drivers/regulator/pwm-regulator.c | 14 ++++++++------ 1 file changed, 8 insertions(+), 6 deletions(-)