| Message ID | 20180718193200.17944-1-srinivas.pandruvada@linux.intel.com (mailing list archive) |
|---|---|
| State | New, archived |
| Headers | show |
On Wed, Jul 18, 2018 at 9:32 PM Srinivas Pandruvada <srinivas.pandruvada@linux.intel.com> wrote: > > On Mehlow Xeon-E workstation, ISH PCI device is enabled but without ISH > firmware. Here the ISH device PCI device id was reused for some non Linux > storage drivers. So this was not done for enabling ISH. But this has a > undesirable side effect for Linux. > > Here the ISH driver will be loaded via PCI enumeration and will try to do > reset sequence. But reset sequence will wait till timeout as there is no > real ISH firmware is present to take action. This delay will add to boot > time of Linux (This platform will still continue to boot after this > timeout). > > To avoid this boot delay we need to prevent loading of ISH drivers on > this platform. So we need to have hack to avoid treating this device as > ISH on this platform. To identify this workstation, we need some runtime > method. Luckily there are special PCI id on this workstation to > distinguish from the client version of this platform. On client version, > the ISH is supported using same PCI device id. So this change look for > the presence of PCI device IDs A309 and A30A and exit. > > Signed-off-by: Srinivas Pandruvada <srinivas.pandruvada@linux.intel.com> > --- > v2 > Replaced pci_get_device with pci_dev_present to check in a loop as > suggested by Benjamin. That's even better than what I suggested :) Reviewed-by: Benjamin Tissoires <benjamin.tissoires@redhat.com> Cheers, Benjamin > > drivers/hid/intel-ish-hid/ipc/pci-ish.c | 11 +++++++++++ > 1 file changed, 11 insertions(+) > > diff --git a/drivers/hid/intel-ish-hid/ipc/pci-ish.c b/drivers/hid/intel-ish-hid/ipc/pci-ish.c > index a2c53ea3b5ed..4a55eab39b88 100644 > --- a/drivers/hid/intel-ish-hid/ipc/pci-ish.c > +++ b/drivers/hid/intel-ish-hid/ipc/pci-ish.c > @@ -95,6 +95,13 @@ static int ish_init(struct ishtp_device *dev) > return 0; > } > > +static const struct pci_device_id ish_invalid_pci_ids[] = { > + /* Mehlow platform special pci ids */ > + {PCI_DEVICE(PCI_VENDOR_ID_INTEL, 0xA309)}, > + {PCI_DEVICE(PCI_VENDOR_ID_INTEL, 0xA30A)}, > + {} > +}; > + > /** > * ish_probe() - PCI driver probe callback > * @pdev: pci device > @@ -110,6 +117,10 @@ static int ish_probe(struct pci_dev *pdev, const struct pci_device_id *ent) > struct ish_hw *hw; > int ret; > > + /* Check for invalid platforms for ISH support */ > + if (pci_dev_present(ish_invalid_pci_ids)) > + return -ENODEV; > + > /* enable pci dev */ > ret = pci_enable_device(pdev); > if (ret) { > -- > 2.17.1 > -- To unsubscribe from this list: send the line "unsubscribe linux-input" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
On Wed, 18 Jul 2018, Srinivas Pandruvada wrote: > On Mehlow Xeon-E workstation, ISH PCI device is enabled but without ISH > firmware. Here the ISH device PCI device id was reused for some non Linux > storage drivers. So this was not done for enabling ISH. But this has a > undesirable side effect for Linux. > > Here the ISH driver will be loaded via PCI enumeration and will try to do > reset sequence. But reset sequence will wait till timeout as there is no > real ISH firmware is present to take action. This delay will add to boot > time of Linux (This platform will still continue to boot after this > timeout). > > To avoid this boot delay we need to prevent loading of ISH drivers on > this platform. So we need to have hack to avoid treating this device as > ISH on this platform. To identify this workstation, we need some runtime > method. Luckily there are special PCI id on this workstation to > distinguish from the client version of this platform. On client version, > the ISH is supported using same PCI device id. So this change look for > the presence of PCI device IDs A309 and A30A and exit. > > Signed-off-by: Srinivas Pandruvada <srinivas.pandruvada@linux.intel.com> > --- > v2 > Replaced pci_get_device with pci_dev_present to check in a loop as > suggested by Benjamin. Applied, thanks.
diff --git a/drivers/hid/intel-ish-hid/ipc/pci-ish.c b/drivers/hid/intel-ish-hid/ipc/pci-ish.c index a2c53ea3b5ed..4a55eab39b88 100644 --- a/drivers/hid/intel-ish-hid/ipc/pci-ish.c +++ b/drivers/hid/intel-ish-hid/ipc/pci-ish.c @@ -95,6 +95,13 @@ static int ish_init(struct ishtp_device *dev) return 0; } +static const struct pci_device_id ish_invalid_pci_ids[] = { + /* Mehlow platform special pci ids */ + {PCI_DEVICE(PCI_VENDOR_ID_INTEL, 0xA309)}, + {PCI_DEVICE(PCI_VENDOR_ID_INTEL, 0xA30A)}, + {} +}; + /** * ish_probe() - PCI driver probe callback * @pdev: pci device @@ -110,6 +117,10 @@ static int ish_probe(struct pci_dev *pdev, const struct pci_device_id *ent) struct ish_hw *hw; int ret; + /* Check for invalid platforms for ISH support */ + if (pci_dev_present(ish_invalid_pci_ids)) + return -ENODEV; + /* enable pci dev */ ret = pci_enable_device(pdev); if (ret) {
On Mehlow Xeon-E workstation, ISH PCI device is enabled but without ISH firmware. Here the ISH device PCI device id was reused for some non Linux storage drivers. So this was not done for enabling ISH. But this has a undesirable side effect for Linux. Here the ISH driver will be loaded via PCI enumeration and will try to do reset sequence. But reset sequence will wait till timeout as there is no real ISH firmware is present to take action. This delay will add to boot time of Linux (This platform will still continue to boot after this timeout). To avoid this boot delay we need to prevent loading of ISH drivers on this platform. So we need to have hack to avoid treating this device as ISH on this platform. To identify this workstation, we need some runtime method. Luckily there are special PCI id on this workstation to distinguish from the client version of this platform. On client version, the ISH is supported using same PCI device id. So this change look for the presence of PCI device IDs A309 and A30A and exit. Signed-off-by: Srinivas Pandruvada <srinivas.pandruvada@linux.intel.com> --- v2 Replaced pci_get_device with pci_dev_present to check in a loop as suggested by Benjamin. drivers/hid/intel-ish-hid/ipc/pci-ish.c | 11 +++++++++++ 1 file changed, 11 insertions(+)