@@ -33,6 +33,7 @@
#include <linux/jiffies.h>
#include <linux/completion.h>
#include <linux/of.h>
+#include <linux/pm_wakeirq.h>
#include <linux/property.h>
#include <linux/regulator/consumer.h>
#include <asm/unaligned.h>
@@ -86,8 +87,6 @@ struct elan_tp_data {
u16 fw_page_size;
u32 fw_signature_address;
- bool irq_wake;
-
u8 min_baseline;
u8 max_baseline;
bool baseline_ready;
@@ -1340,6 +1339,15 @@ static int elan_probe(struct i2c_client *client,
if (!dev->of_node)
device_init_wakeup(dev, true);
+ /*
+ * The wake IRQ should be declared via device tree instead of assuming
+ * the IRQ can wake the system. This is here for legacy reasons and
+ * will be removed once the i2c-core supports querying ACPI for wake
+ * capabilities.
+ */
+ if (!dev->power.wakeirq)
+ dev_pm_set_wake_irq(dev, client->irq);
+
return 0;
}
@@ -1362,8 +1370,6 @@ static int __maybe_unused elan_suspend(struct device *dev)
if (device_may_wakeup(dev)) {
ret = elan_sleep(data);
- /* Enable wake from IRQ */
- data->irq_wake = (enable_irq_wake(client->irq) == 0);
} else {
ret = elan_set_power(data, false);
if (ret)
@@ -1394,9 +1400,6 @@ static int __maybe_unused elan_resume(struct device *dev)
dev_err(dev, "error %d enabling regulator\n", error);
goto err;
}
- } else if (data->irq_wake) {
- disable_irq_wake(client->irq);
- data->irq_wake = false;
}
error = elan_set_power(data, true);
The Elan I2C touchpad driver is currently manually managing the wake IRQ. This change removes the explicit enable_irq_wake/disable_irq_wake and instead relies on the PM subsystem. This is done by calling dev_pm_set_wake_irq. i2c_device_probe already calls dev_pm_set_wake_irq when using device tree, and i2c_device_remove also already calls dev_pm_clear_wake_irq. There could be some device tree systems that have incorrectly declared `wake` capabilities, so this change will set the wake irq if one is missing. This matches the previous behavior. I tested this on an ACPI system where the touchpad doesn't have _PRW defined. I verified I can still wake the system and that the wake source was the touchpad IRQ GPIO. Signed-off-by: Raul E Rangel <rrangel@chromium.org> --- (no changes since v2) Changes in v2: - Set the wake_irq when not configured by the i2c-core. This is different than v1, where the wake_irq was only set for non DT systems. drivers/input/mouse/elan_i2c_core.c | 17 ++++++++++------- 1 file changed, 10 insertions(+), 7 deletions(-)