new file mode 100644
@@ -0,0 +1,36 @@
+* Toradex Colibri VF50 Touchscreen driver
+
+Required Properties:
+- compatible must be toradex,vf50-touchscreen
+- io-channels: adc channels being used by the Colibri VF50 module
+- xp-gpios: FET gate driver for input of X+
+- xm-gpios: FET gate driver for input of X-
+- yp-gpios: FET gate driver for input of Y+
+- ym-gpios: FET gate driver for input of Y-
+- interrupt-parent: phandle for the interrupt controller
+- interrupts: pen irq interrupt for touch detection
+- pinctrl-names: "idle", "default", "gpios"
+- pinctrl-0: pinctrl node for pen/touch detection state pinmux
+- pinctrl-1: pinctrl node for X/Y and pressure measurement (ADC) state pinmux
+- pinctrl-2: pinctrl node for gpios functioning as FET gate drivers
+- vf50-ts-min-pressure: pressure level at which to stop measuring X/Y values
+
+Example:
+
+ touchctrl: vf50_touchctrl {
+ compatible = "toradex,vf50-touchscreen";
+ io-channels = <&adc1 0>,<&adc0 0>,
+ <&adc0 1>,<&adc1 2>;
+ xp-gpios = <&gpio0 13 GPIO_ACTIVE_LOW>;
+ xm-gpios = <&gpio2 29 GPIO_ACTIVE_HIGH>;
+ yp-gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
+ ym-gpios = <&gpio0 4 GPIO_ACTIVE_HIGH>;
+ interrupt-parent = <&gpio0>;
+ interrupts = <8 IRQ_TYPE_LEVEL_LOW>;
+ pinctrl-names = "idle","default","gpios";
+ pinctrl-0 = <&pinctrl_touchctrl_idle>;
+ pinctrl-1 = <&pinctrl_touchctrl_default>;
+ pinctrl-2 = <&pinctrl_touchctrl_gpios>;
+ vf50-ts-min-pressure = <200>;
+ status = "disabled";
+ };
This adds device tree binding documentation for the Colibri VF50 touchscreen driver. Signed-off-by: Sanchayan Maity <maitysanchayan@gmail.com> --- .../bindings/input/touchscreen/colibri-vf50-ts.txt | 36 ++++++++++++++++++++++ 1 file changed, 36 insertions(+) create mode 100644 Documentation/devicetree/bindings/input/touchscreen/colibri-vf50-ts.txt