@@ -26,10 +26,13 @@ DSTIP=192.0.2.2
PORT="6666"
MSG="netconsole selftest"
+USERDATA_KEY="key"
+USERDATA_VALUE="value"
TARGET=$(mktemp -u netcons_XXXXX)
DEFAULT_PRINTK_VALUES=$(cat /proc/sys/kernel/printk)
NETCONS_CONFIGFS="/sys/kernel/config/netconsole"
NETCONS_PATH="${NETCONS_CONFIGFS}"/"${TARGET}"
+KEY_PATH="${NETCONS_PATH}/userdata/${USERDATA_KEY}"
# NAMESPACE will be populated by setup_ns with a random value
NAMESPACE=""
@@ -122,6 +125,8 @@ function cleanup() {
# delete netconsole dynamic reconfiguration
echo 0 > "${NETCONS_PATH}"/enabled
+ # Remove key
+ rmdir "${KEY_PATH}"
# Remove the configfs entry
rmdir "${NETCONS_PATH}"
@@ -136,6 +141,18 @@ function cleanup() {
echo "${DEFAULT_PRINTK_VALUES}" > /proc/sys/kernel/printk
}
+function set_user_data() {
+ if [[ ! -d "${NETCONS_PATH}""/userdata" ]]
+ then
+ echo "Userdata path not available in ${NETCONS_PATH}/userdata"
+ exit "${ksft_skip}"
+ fi
+
+ mkdir -p "${KEY_PATH}"
+ VALUE_PATH="${KEY_PATH}""/value"
+ echo "${USERDATA_VALUE}" > "${VALUE_PATH}"
+}
+
function listen_port_and_save_to() {
local OUTPUT=${1}
# Just wait for 2 seconds
@@ -146,6 +163,10 @@ function listen_port_and_save_to() {
function validate_result() {
local TMPFILENAME="$1"
+ # TMPFILENAME will contain something like:
+ # 6.11.1-0_fbk0_rc13_509_g30d75cea12f7,13,1822,115075213798,-;netconsole selftest: netcons_gtJHM
+ # key=value
+
# Check if the file exists
if [ ! -f "$TMPFILENAME" ]; then
echo "FAIL: File was not generated." >&2
@@ -158,6 +179,12 @@ function validate_result() {
exit "${ksft_fail}"
fi
+ if ! grep -q "${USERDATA_KEY}=${USERDATA_VALUE}" "${TMPFILENAME}"; then
+ echo "FAIL: ${USERDATA_KEY}=${USERDATA_VALUE} not found in ${TMPFILENAME}" >&2
+ cat "${TMPFILENAME}" >&2
+ exit "${ksft_fail}"
+ fi
+
# Delete the file once it is validated, otherwise keep it
# for debugging purposes
rm "${TMPFILENAME}"
@@ -220,6 +247,8 @@ trap cleanup EXIT
set_network
# Create a dynamic target for netconsole
create_dynamic_target
+# Set userdata "key" with the "value" value
+set_user_data
# Listed for netconsole port inside the namespace and destination interface
listen_port_and_save_to "${OUTPUT_FILE}" &
# Wait for socat to start and listen to the port.
Extend netcons_basic selftest to verify the userdata functionality by: 1. Creating a test key in the userdata configfs directory 2. Writing a known value to the key 3. Validating the key-value pair appears in the captured network output This ensures the userdata feature is properly tested during selftests. Signed-off-by: Breno Leitao <leitao@debian.org> --- .../selftests/drivers/net/netcons_basic.sh | 29 +++++++++++++++++++ 1 file changed, 29 insertions(+)