@@ -229,6 +229,22 @@ on working with the default settings initially.</para>
and LIRC_SETUP_END. Drivers can also choose to ignore these ioctls.</para>
</listitem>
</varlistentry>
+ <varlistentry>
+ <term>LIRC_SET_WIDEBAND_RECEIVER</term>
+ <listitem>
+ <para>Some receivers are equipped with special wide band receiver which is intended
+ to be used to learn output of existing remote.
+ Calling that ioctl with (1) will enable it, and with (0) disable it.
+ This might be useful of receivers that have otherwise narrow band receiver
+ that prevents them to be used with some remotes.
+ Wide band receiver might also be more precise
+ On the other hand its disadvantage it usually reduced range of reception.
+ Note: wide band receiver might be implictly enabled if you enable
+ carrier reports. In that case it will be disabled as soon as you disable
+ carrier reports. Trying to disable wide band receiver while carrier
+ reports are active will do nothing.</para>
+ </listitem>
+ </varlistentry>
</variablelist>
</section>
@@ -79,6 +79,7 @@ struct ir_raw_event_ctrl {
struct lirc_codec {
struct ir_input_dev *ir_dev;
struct lirc_driver *drv;
+ int carrier_low;
} lirc;
};
@@ -46,7 +46,6 @@ static int ir_lirc_decode(struct input_dev *input_dev, struct ir_raw_event ev)
IR_dprintk(2, "LIRC data transfer started (%uus %s)\n",
TO_US(ev.duration), TO_STR(ev.pulse));
-
sample = ev.duration / 1000;
if (ev.pulse)
sample |= PULSE_BIT;
@@ -96,13 +95,14 @@ out:
return ret;
}
-static long ir_lirc_ioctl(struct file *filep, unsigned int cmd, unsigned long arg)
+static long ir_lirc_ioctl(struct file *filep, unsigned int cmd,
+ unsigned long __user arg)
{
struct lirc_codec *lirc;
struct ir_input_dev *ir_dev;
int ret = 0;
void *drv_data;
- unsigned long val;
+ unsigned long val = 0;
lirc = lirc_get_pdata(filep);
if (!lirc)
@@ -114,47 +114,106 @@ static long ir_lirc_ioctl(struct file *filep, unsigned int cmd, unsigned long ar
drv_data = ir_dev->props->priv;
- switch (cmd) {
- case LIRC_SET_TRANSMITTER_MASK:
+ if (_IOC_DIR(cmd) & _IOC_WRITE) {
ret = get_user(val, (unsigned long *)arg);
if (ret)
return ret;
+ }
+
+ switch (cmd) {
+
+ /* legacy support */
+ case LIRC_GET_SEND_MODE:
+ val = LIRC_CAN_SEND_PULSE & LIRC_CAN_SEND_MASK;
+ break;
+
+ case LIRC_SET_SEND_MODE:
+ if (val != (LIRC_MODE_PULSE & LIRC_CAN_SEND_MASK))
+ return -EINVAL;
+ break;
- if (ir_dev->props && ir_dev->props->s_tx_mask)
+ /* TX settings */
+ case LIRC_SET_TRANSMITTER_MASK:
+ if (ir_dev->props->s_tx_mask)
ret = ir_dev->props->s_tx_mask(drv_data, (u32)val);
else
return -EINVAL;
break;
case LIRC_SET_SEND_CARRIER:
- ret = get_user(val, (unsigned long *)arg);
- if (ret)
- return ret;
-
- if (ir_dev->props && ir_dev->props->s_tx_carrier)
+ if (ir_dev->props->s_tx_carrier)
ir_dev->props->s_tx_carrier(drv_data, (u32)val);
else
return -EINVAL;
break;
- case LIRC_GET_SEND_MODE:
- val = LIRC_CAN_SEND_PULSE & LIRC_CAN_SEND_MASK;
- ret = put_user(val, (unsigned long *)arg);
+ case LIRC_SET_SEND_DUTY_CYCLE:
+ if (!ir_dev->props->s_tx_duty_cycle)
+ return -ENOSYS;
+
+ if (val <= 0 || val >= 100)
+ return -EINVAL;
+
+ ir_dev->props->s_tx_duty_cycle(ir_dev->props->priv, val);
break;
- case LIRC_SET_SEND_MODE:
- ret = get_user(val, (unsigned long *)arg);
- if (ret)
- return ret;
+ /* RX settings */
+ case LIRC_SET_REC_CARRIER:
+ if (ir_dev->props->s_rx_carrier_range)
+ ret = ir_dev->props->s_rx_carrier_range(
+ ir_dev->props->priv,
+ ir_dev->raw->lirc.carrier_low, val);
+ else
+ return -ENOSYS;
- if (val != (LIRC_MODE_PULSE & LIRC_CAN_SEND_MASK))
+ if (!ret)
+ ir_dev->raw->lirc.carrier_low = 0;
+ break;
+
+ case LIRC_SET_REC_CARRIER_RANGE:
+ if (val >= 0)
+ ir_dev->raw->lirc.carrier_low = val;
+ break;
+
+
+ case LIRC_GET_REC_RESOLUTION:
+ val = ir_dev->props->rx_resolution;
+ break;
+
+ case LIRC_SET_WIDEBAND_RECEIVER:
+ if (ir_dev->props->s_learning_mode)
+ return ir_dev->props->s_learning_mode(
+ ir_dev->props->priv, !!val);
+ else
+ return -ENOSYS;
+
+ /* Generic timeout support */
+ case LIRC_GET_MIN_TIMEOUT:
+ if (!ir_dev->props->max_timeout)
+ return -ENOSYS;
+ val = ir_dev->props->min_timeout / 1000;
+ break;
+
+ case LIRC_GET_MAX_TIMEOUT:
+ if (!ir_dev->props->max_timeout)
+ return -ENOSYS;
+ val = ir_dev->props->max_timeout / 1000;
+ break;
+
+ case LIRC_SET_REC_TIMEOUT:
+ if (val < ir_dev->props->min_timeout ||
+ val > ir_dev->props->max_timeout)
return -EINVAL;
+ ir_dev->props->timeout = val * 1000;
break;
default:
return lirc_dev_fop_ioctl(filep, cmd, arg);
}
+ if (_IOC_DIR(cmd) & _IOC_READ)
+ ret = put_user(val, (unsigned long *)arg);
+
return ret;
}
@@ -200,13 +259,28 @@ static int ir_lirc_register(struct input_dev *input_dev)
features = LIRC_CAN_REC_MODE2;
if (ir_dev->props->tx_ir) {
+
features |= LIRC_CAN_SEND_PULSE;
if (ir_dev->props->s_tx_mask)
features |= LIRC_CAN_SET_TRANSMITTER_MASK;
if (ir_dev->props->s_tx_carrier)
features |= LIRC_CAN_SET_SEND_CARRIER;
+
+ if (ir_dev->props->s_tx_duty_cycle)
+ features |= LIRC_CAN_SET_REC_DUTY_CYCLE;
}
+ if (ir_dev->props->s_rx_carrier_range)
+ features |= LIRC_CAN_SET_REC_CARRIER |
+ LIRC_CAN_SET_REC_CARRIER_RANGE;
+
+ if (ir_dev->props->s_learning_mode)
+ features |= LIRC_CAN_USE_WIDEBAND_RECEIVER;
+
+ if (ir_dev->props->max_timeout)
+ features |= LIRC_CAN_SET_REC_TIMEOUT;
+
+
snprintf(drv->name, sizeof(drv->name), "ir-lirc-codec (%s)",
ir_dev->driver_name);
drv->minor = -1;
@@ -44,6 +44,8 @@ enum rc_driver_type {
* @timeout: optional time after which device stops sending data
* @min_timeout: minimum timeout supported by device
* @max_timeout: maximum timeout supported by device
+ * @rx_resolution : resolution (in ns) of input sampler
+ * @tx_resolution: resolution (in ns) of output sampler
* @priv: driver-specific data, to be used on the callbacks
* @change_protocol: allow changing the protocol used on hardware decoders
* @open: callback to allow drivers to enable polling/irq when IR input device
@@ -52,9 +54,12 @@ enum rc_driver_type {
* is opened.
* @s_tx_mask: set transmitter mask (for devices with multiple tx outputs)
* @s_tx_carrier: set transmit carrier frequency
+ * @s_tx_duty_cycle: set transmit duty cycle (0% - 100%)
+ * @s_rx_carrier: inform driver about carrier it is expected to handle
* @tx_ir: transmit IR
* @s_idle: optional: enable/disable hardware idle mode, upon which,
- * device doesn't interrupt host untill it sees IR data
+ device doesn't interrupt host until it sees IR pulses
+ * @s_learning_mode: enable wide band receiver used for learning
*/
struct ir_dev_props {
enum rc_driver_type driver_type;
@@ -65,6 +70,8 @@ struct ir_dev_props {
u32 min_timeout;
u32 max_timeout;
+ u32 rx_resolution;
+ u32 tx_resolution;
void *priv;
int (*change_protocol)(void *priv, u64 ir_type);
@@ -72,8 +79,11 @@ struct ir_dev_props {
void (*close)(void *priv);
int (*s_tx_mask)(void *priv, u32 mask);
int (*s_tx_carrier)(void *priv, u32 carrier);
+ int (*s_tx_duty_cycle)(void *priv, u32 duty_cycle);
+ int (*s_rx_carrier_range)(void *priv, u32 min, u32 max);
int (*tx_ir)(void *priv, int *txbuf, u32 n);
void (*s_idle)(void *priv, int enable);
+ int (*s_learning_mode)(void *priv, int enable);
};
struct ir_input_dev {
@@ -77,6 +77,7 @@
#define LIRC_CAN_SET_REC_FILTER 0x08000000
#define LIRC_CAN_MEASURE_CARRIER 0x02000000
+#define LIRC_CAN_USE_WIDEBAND_RECEIVER 0x04000000
#define LIRC_CAN_SEND(x) ((x)&LIRC_CAN_SEND_MASK)
#define LIRC_CAN_REC(x) ((x)&LIRC_CAN_REC_MASK)
@@ -145,7 +146,7 @@
* if enabled from the next key press on the driver will send
* LIRC_MODE2_FREQUENCY packets
*/
-#define LIRC_SET_MEASURE_CARRIER_MODE _IOW('i', 0x0000001d, __u32)
+#define LIRC_SET_MEASURE_CARRIER_MODE _IOW('i', 0x0000001d, __u32)
/*
* to set a range use
@@ -162,4 +163,6 @@
#define LIRC_SETUP_START _IO('i', 0x00000021)
#define LIRC_SETUP_END _IO('i', 0x00000022)
+#define LIRC_SET_WIDEBAND_RECEIVER _IOW('i', 0x00000023, __u32)
+
#endif