different clock speed or to use the SMBUS protocol. Remove the wired-in
code and pass that information from the platform layer. The Cafe driver
now just assumes it's running on an OLPC XO 1; I do not believe it has ever
run anywhere else.
Cc: Daniel Drake <dsd@laptop.org>
Signed-off-by: Jonathan Corbet <corbet@lwn.net>
---
drivers/media/video/marvell-ccic/cafe-driver.c | 6 ++++++
drivers/media/video/marvell-ccic/mcam-core.c | 22 ++--------------------
drivers/media/video/marvell-ccic/mcam-core.h | 2 ++
3 files changed, 10 insertions(+), 20 deletions(-)
@@ -404,6 +404,12 @@ static int cafe_pci_probe(struct pci_dev *pdev,
mcam->plat_power_down = cafe_ctlr_power_down;
mcam->dev = &pdev->dev;
/*
+ * Set the clock speed for the XO 1; I don't believe this
+ * driver has ever run anywhere else.
+ */
+ mcam->clock_speed = 45;
+ mcam->use_smbus = 1;
+ /*
* Get set up on the PCI bus.
*/
ret = pci_enable_device(pdev);
@@ -7,7 +7,6 @@
#include <linux/kernel.h>
#include <linux/module.h>
#include <linux/fs.h>
-#include <linux/dmi.h>
#include <linux/mm.h>
#include <linux/i2c.h>
#include <linux/interrupt.h>
@@ -1536,22 +1535,7 @@ int mccic_irq(struct mcam_camera *cam, unsigned int irqs)
* Registration and such.
*/
-/* FIXME this is really platform stuff */
-static const struct dmi_system_id olpc_xo1_dmi[] = {
- {
- .matches = {
- DMI_MATCH(DMI_SYS_VENDOR, "OLPC"),
- DMI_MATCH(DMI_PRODUCT_NAME, "XO"),
- DMI_MATCH(DMI_PRODUCT_VERSION, "1"),
- },
- },
- { }
-};
-
static struct ov7670_config sensor_cfg = {
- /* This controller only does SMBUS */
- .use_smbus = true,
-
/*
* Exclude QCIF mode, because it only captures a tiny portion
* of the sensor FOV
@@ -1590,13 +1574,11 @@ int mccic_register(struct mcam_camera *cam)
mcam_ctlr_init(cam);
- /* Apply XO-1 clock speed */
- if (dmi_check_system(olpc_xo1_dmi))
- sensor_cfg.clock_speed = 45;
-
/*
* Try to find the sensor.
*/
+ sensor_cfg.clock_speed = cam->clock_speed;
+ sensor_cfg.use_smbus = cam->use_smbus;
cam->sensor_addr = ov7670_info.addr;
cam->sensor = v4l2_i2c_new_subdev_board(&cam->v4l2_dev,
&cam->i2c_adapter, &ov7670_info, NULL);
@@ -42,6 +42,8 @@ struct mcam_camera {
spinlock_t dev_lock;
struct device *dev; /* For messages, dma alloc */
unsigned int chip_id;
+ short int clock_speed; /* Sensor clock speed, default 30 */
+ short int use_smbus; /* SMBUS or straight I2c? */
/*
* Callbacks from the core to the platform code.