new file mode 100644
@@ -0,0 +1,51 @@
+* Sony 1/3.06-Inch 13.13Mp CMOS Digital Image Sensor
+
+The Sony imx214 is a 1/3.06-inch CMOS active pixel digital image sensor with
+an active array size of 4224H x 3176V. It is programmable through I2C
+interface. The I2C address can be configured to to 0x1a or 0x10, depending on
+how is wired.
+Image data is sent through MIPI CSI-2, which is configured as 4 lanes
+at 1440 Mbps.
+
+
+Required Properties:
+- compatible: value should be "sony,imx214" for imx214 sensor
+- reg: I2C bus address of the device
+- enable-gpios: Sensor enable GPIO
+- vdddo-supply: Chip digital IO regulator (1.8V).
+- vdda-supply: Chip analog regulator (2.7V).
+- vddd-supply: Chip digital core regulator (1.12V).
+- clocks = Reference to the xclk clock.
+- clock-names = Should be "xclk".
+- clock-frequency = Frequency of the xclk clock. Should be <24000000>;
+
+Optional Properties:
+- flash-leds: See ../video-interfaces.txt
+- lens-focus: See ../video-interfaces.txt
+
+The imx274 device node should contain one 'port' child node with
+an 'endpoint' subnode. For further reading on port node refer to
+Documentation/devicetree/bindings/media/video-interfaces.txt.
+
+Example:
+
+ camera_rear@1a {
+ status = "okay";
+ compatible = "sony,imx214";
+ reg = <0x1a>;
+ vdddo-supply = <&pm8994_lvs1>;
+ vddd-supply = <&camera_vddd_1v12>;
+ vdda-supply = <&pm8994_l17>;
+ lens-focus = <&ad5820>;
+ enable-gpios = <&msmgpio 25 GPIO_ACTIVE_HIGH>;
+ clocks = <&mmcc CAMSS_MCLK0_CLK>;
+ clock-names = "xclk";
+ clock-frequency = <24000000>;
+ port {
+ imx214_ep: endpoint {
+ clock-lanes = <1>;
+ data-lanes = <0 2 3 4>;
+ remote-endpoint = <&csiphy0_ep>;
+ };
+ };
+ };
Document bindings for imx214 v4l2 driver. Cc: devicetree@vger.kernel.org Signed-off-by: Ricardo Ribalda Delgado <ricardo.ribalda@gmail.com> --- .../devicetree/bindings/media/i2c/imx214.txt | 51 +++++++++++++++++++ 1 file changed, 51 insertions(+) create mode 100644 Documentation/devicetree/bindings/media/i2c/imx214.txt